Swapped out engine now transmission won't engage

If You were using the Same ECU for engine swap it should not have affected trans Programing....It sounds like a shifter cable problem.....Check for Trans Solenoid Problem after rescan........Make sure all electrical plugs are clean and no bent pins......

Transmission won't engage Drive or Reverse - EricTheCarGuy

www.ericthecarguy.com/.../53999-transmission-won-t-engage-drive-or-r...

This transmission shifted smooth and strong through all gears until today when it stopped all of ... Any idea on where we should start tackling this issue? .... Also, make sure that the pressure tester is not leaking or you will run the tranny dry(use ...

Gear shifter goes from park to drive with no effect. Won't ...

they are different years 1999 is up to 2000/2001 then the 2003 is 2001 to 2004/5. auto box module works different, box's look the same but the sensors are different inside you would need to change the auto module and pair it to your ecu on your engine.

check your fluid level then check your linkage last check your flywheel bolts

This just happened to my 02 eclipse gt automatic on Thanksgiving 2012 . Its ur torque converter , the torque converter engages forward and reverse drive... Sorry to say but u need a transmission rebuild.... I just swapped mine to a 5 speed for around $2000

WHAT CAR IS IT? You need to thell the car that you have put a new transaxle.

Then there is a serious problem with the clutch. turn the engine off and engage a gear and try and roll the truck, do it feel like it is in gear? if not the clutch is either defective or the transmission input shaft is broken

you can just pull out the engine alone and leave the transmission. It depends how difficult pulling out the engine. You can also take the transmision with the engine

if your torque converter on the front of the trans wasnt seated properly before the engine was set in and tightened at the bell housing, you may have cracked the front pump on the tranny

If you put the transmission in neutral, there are two notches on the switch that will line up to adjust the switch correctly.