While driving the car just stops running the enging dies and after 30 minuts starts again. am thiking is the fuel filter how do I change that or check if thats the problem.

Change the fuel filter and see it that helps. It sounds like a fuel supply problem, and the filter is the least expensive most likely place to start.

Could be anything electrical. A weak relay, the coil pack or ignition module, and so on.
You'll need to figure out what is loosing electrical power when it fails to start to know what to test. You might start with the fuel pump relay.

The check engine will be on if the key is on but engine not running . This is normal. If the check engine goes out when the engine starts there are no codes present . Did you check the fuel filter . Sometimes when a filter is dirty there is sedement laying in the filter canister . When the pump starts working the flow picks up the sedement and plugs any remaining open screen and stops the fuel completely . The engine stops . When the flow stops the sedement falls back allowing flow again. and the engine will run for another while . If the filter is old it should be changed anyway . Also when the engine stops check to see if there is spark at the spark plugs while cranking the engine .

It does sound like fuel pressure is low or intermittent. Here are some check procedures p172 on

http://www.turboninjas.com/camry/eg1.pdf

Is the check engine light showing a trouble code on the instrument panel? That may pin the trouble down.

Sounds like the fuel pump is going out. Replace the filter first, as it's only $10. If that doesn't fix it, then it's probably the pump, which is $250.

my 2003 grand caravan 3.3l run for 30 then daying and fuel pump making noise you can restart again it run for 2 to 3 min dies again pep boys change crank sensor fuel pump no help when eng shutdown middle of high way or trafic no fuel to eng does have elect power no eng check light any help

my e-mail is [email protected]

Fuel pump and filter were changed how long ago, and how many miles ago? Did they change the wrong thing(s)? What engine is in your Cirrus?

fuel pump and or filter is my first guess

Check fuel pump for pressure and output. If it's not that, don't start guessing... have a scanner put on it and get some codes. While some codes can be ambiguous, it will serve to start you in the right direction!

Check to see fi your fuel pump is functioning, also change the fuel filter. I had this same problem on a 1984 626. While i waited for the car to restart fuel would seep into the line to allow for the enging to startbe that was it.