2009 Mitsubishi Outlander Logo

Related Topics:

Posted on Feb 27, 2010

What type of engine oil should i use for my diesel mitsubishi outlander 2009 model

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 65 Answers
  • Posted on Feb 28, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Feb 28, 2010
Answers
65
Questions
0
Helped
10383
Points
94

I WOULD PERSONALY RECOMEND MAGNATEC IT REDUCES WEAR AND TEAR AND YOU SEEM TO GET THAT LITTLE BIT MORE ASWEL AS YOUR ENGINE GETTING MORE MILAGE OUT OF IT ,

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Noise from engine, oil indication on , before one year change balance shaft and bearings on mitsubishi outlander year 2004,4x4,suspect the same problem now?

do not run engine with red oil light on, it can cause severe damage. Check oil level first. If ok, then check oil pressure with a gauge. If oil is not low, you may have a clogged filter or a borlen oil pump inside the engine.
0helpful
1answer

Mitsubishi outlander 2009 what"s is the best motor oil do I have to use 10/30 or 10\40

check the owners manual or read the oil fill cap. if you can't find the oil specs i would use 5w30
2helpful
1answer

How do I change the oil and fuel filters on My Mitsubishi Outlander. Year 2007. Where are both filters located in the engine compartment.

Is this a diesel? I just changed my oil and oil filter. You have to remove the plastic engine top cover first and you will see the oil filter in the front right. Black with hex nut on top (my 1 1/4 AF socket fitted). You have to disconnect the bracket holding some wiring. Pull the wiring forward to access the nut on top of the filter. Undo and remove/replace filter.
Under the car you will find a small hatch in the underside plastic cover held in place by three 10 mm bolts. Remove this to access the 19 mm drain plug. Drain old oil and refill with 4 ltrs 5/30 fully synthetic. Top up if necessary after running engine but DO NOT overfill.
The fuel filter is on the bulkhead at the back of the engine on the right side. I wont be changing that for a while!
0helpful
1answer
0helpful
1answer
0helpful
2answers

Where is the water pump located on a mitsubishi 2.4L engine? I have a 2003 mitsubishi outlander

While I understand this answer may be overkill, follow this link to an article about the engine cooling system. Look midway down the article for this sentence "More information about 2003 Mitsubishi Outlander Engine Cooling System service and troubleshooting, find here – 32 pages of PDF filetype" Click on the "find here" link which will prompt you to download a file 14_rar. Open it with any decompressing software (Winzip, WinRar) to find 14.pdf. Go to page 14-23 to see a diagram of where water pump is. It will also give you instructions on removing and replacing it. Good luck!

http://www.fixautopartz.com/2009/03/20/2003-mitsubishi-outlander-engine-cooling-system
Not finding what you are looking for?

326 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...