Need to replace the flasher fuse. Where do I find it and how do I replace it?

The turn signal flasher on a 2014 Kia Sportage is typically located in the vehicle's fuse box. The exact location of the flasher will depend on the specific make and model of your Sportage, but it is generally located near the steering column or under the dashboard.
Here are the steps to locate the turn signal flasher:

1. Locate the fuse box: The fuse box in a Kia Sportage is typically located under the dashboard on the driver's side of the vehicle.
2. Identify the flasher: Once you have located the fuse box, look for the turn signal flasher, which is typically a small, rectangular box with two or three wires connected to it.
3. Test the flasher: Once you have found the flasher, you can test it by turning on the hazard lights and checking to see if the flasher is clicking. If it is not clicking, the flasher may be faulty and will need to be replaced.

The flasher unit on a Toyota Land Cruiser HZJ75 is usually located in the fuse box under the dashboard on the driver's side of the vehicle. To access the flasher unit, you will need to:

1. Open the driver's side door and locate the fuse box cover. It is usually located under the dashboard on the left side of the steering wheel.
2. Remove the fuse box cover: Depending on the model of your Land Cruiser, you may need to use a tool like a flat-head screwdriver to gently pry the cover off.
3. Locate the flasher unit: Once the cover is removed, you should be able to see the various fuses and relays in the fuse box. The flasher unit is usually labeled as "flasher" or "turn signal relay." It may be a small, rectangular component with wires or terminals attached to it.
4. Remove the flasher unit: Depending on the model of your Land Cruiser, you may need to use a tool like a socket wrench or pliers to remove the flasher unit. Some models may have a clip or tab that holds the flasher unit in place, which you will need to release before removing it.
5. Replace the flasher unit: Reverse the steps above to install the new flasher unit. Make sure the new unit is securely fastened and all the wires and connectors are properly connected.

If you are not comfortable or experienced in automotive repairs, it is recommended to have a mechanic perform the flasher unit replacement.

LED's have resistance than incandescent bulbs, that causes a problem, so best thing to do is get ones that come with the correct resistors.

Check fuse.

you need to check the bulbs holders and wiring even a blown bulb will not blow the fuse and an damaged wire or bulb holder will as it will make earth and live go together. there are also fuses for left side and right side turning lights cannot remember rating think they are 10amp.

Okay, the first thing to check is to turn on the signal on one side and see if the outside signal light comes on. if the light comes on then try replacing the flasher. Also see if your 4way flashers work or if they are also out. if they are out then check your fuse first.
If the fuses are good then try the flasher, if the flasher does not solve the problem then you may need to replace the turn signal switch. I have worked on a few of these and most of the time it was a flasher or the turn signal switch. good day.

you need to replace the flasher canister, the car is equipped with two one for the emergency flashers and one for the turn signals the flasher is located on the fuse block.

flasher unit should on the side lower panel next to to hood release hatch open the side panel and its there on the side bolted its stated flasher unit

there should be a flasher under the dash looks like a metal can in fuse box if this is whst you call the relay then the switch is bad if not replace this it is a 552 flasher

check fuse #21 first. 5 amp.

flasher relay in fuse panel on dash