I have a 94 Mazda MX-6 2.5 DOHC I was driving on

For 1993 Mazda MX-6 2.0L MFI DOHC 4cyl the OBD Diagnostic Link Connector is located: Under hood, driver side, upper engine area, passenger side rear of air filter housing, mounted next to airflow meter connector.

Hope this helps (remember to rate this free answer)
.

1995 Mazda MX-6
2.0 liter DOHC L4

1995 Mazda MX-6
2.5 liter DOHC V-6

For the 1994 Mazda MPV 4WD V6 (3.0L DOHC)
Firing Order:
1-2-3-4-5-6
Cylinders
____(back)____
|..5..|........|..6..|
|..3..|........|..4..|
|..1..|........|..2..|
.......(front)
Distributor:
......5
.............6
...................1
4
.......3
...............2
Rotation: Clockwise
Let me know if this helped....Thanks for using FixYa.Com!

For 1996 Mazda MX-6 2.5L MFI DOHC 6cyl the Fuel Filter is located under hood, driver side, engine side of strut tower, below air filter housing, mounted in fuel line.



Fig. 1: Exploded view of a typical 4-cylinder engine fuel system




Fig. 2: Exploded view of a typical 6-cylinder engine fuel system

Hope helps with this; remember rated this.

1993 Mazda MX-6 2.5 liter DOHC V-6




Hope helps with this (remmeber comment and rated this).

Are the fans turning on when in overheat? If not you might have a fan, relay or sender circuit problem.

Sender circuits monitor the cooling liquid temperature and then sends a signal to turn on the fans if it senses that the temp has exceeded the normal operating temp.

Further test showed that the Crank Position Sensor was bad. Replaced it and the vehicle was fine.

You didn't post your engine size so please choose the one that works for you....please don't forget to rate:

1995 Mazda MX-6
2.0 liter DOHC L4



1995 Mazda MX-6
2.5 liter DOHC V-6

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528003952c