Question about 2009 Ford Focus

1 Answer

My car stears right when mt wheel is straight

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 84 Answers

Sounds like an alingment problem not really a bad problem just need to get an alingment done to fix the problem.

Posted on Feb 08, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to install steering wheel 1989 corvette

put stering wheel on straight and tighten the bolt in the center. place center cover on and done. if you want to take one off first you need a stearing wheel puller

Mar 15, 2013 | Chevrolet Corvette Cars & Trucks

1 Answer

I turn the wheel to one side and it honks but when the stearing wheel is straight it doesnot honk

Sounds like you have some worn-out or corroded electrical components in your steering column, specifically the part that connects your horn switch wires. The area where your steering wheel meets the steering column is a common place for electrical problems to occur.

Mar 01, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

2004 Buick Rendezvous: The key is stuck in the ignition and it won't come out of park. Also, the stearing wheel is locked. Any suggestions?

try moving sterring wheel a little to release pressure.this happens if key is turned off when wheel not straight

Dec 16, 2010 | 2004 Buick Rendezvous

1 Answer

I have a 92 cherokee and am having getting the pitman arm and stearing wheel aligned any help would be great

Count the number of times the wheel turns to the left and then to the right. Then find the center, which would be half of the overall turns you made to the steering wheel. Then make sure your fron wheels are as straight as can be, at this point, slide the pitman arem on and snug it up with the tie rod already attached. This will give a starting point or possibly a dead on straight alignment. If you remove the tie rod end that was attched to the pitman arm first, you' have to adjust it a few turns at a time to get a close alignment to drive, but you will have to bring it in to get an alignment to TRUE it up. Hope this helps.

Jan 21, 2010 | 1995 Jeep Cherokee

1 Answer

Where do i put my power stearing fluid in my 1998 ford escort


Position the vehicle on level ground. Run the engine until the fluid is at normal operating temperature. Turn the steering wheel all the way to the left and right several times. Position the wheels in the straight ahead position, then shut off the engine. Check the level in the reservoir; it should be at the FULL mark. If fluid is required, remove the cap and add fluid until it reaches the FULL mark.

Jan 10, 2010 | 1998 Ford Escort

1 Answer

Installing a new steering gear in a 96 dodge intrepid 3.5l no clue where to begin as the stearing wheel was not held still so it could be anywhere how does a professional straighten out this kind of unique...

well you might of destroyed clockspring in steering cloum,(operates horn,airbag and cruise,)if you turn wheel to much with rack shaft unhooked you may have a use a pair of pliers turn rack shaft all the way to left,now count the turns as you trun all the way to right.(should be about 3turns )now trun back half the amount,3truns is1.5 back.set steerwheel straight,connect shaft.wheel straight.

Oct 04, 2009 | 1996 Dodge Intrepid

1 Answer

1997 1500 4x4 pulls to the right

Sounds like a brake caliper hanging up. Check the slides to see that they're smooth working. Jack the right side up & make sure the front wheel turns fairly easy. If it's dragging alot then the caliper slide is fubar or the brake hose is collapsed internaly. Replace the hose if that's the case.

Aug 04, 2009 | 1997 Dodge Ram 3500 Club Cab

1 Answer

2006 yukon xl denali some steering wheel lights out

stearing jerks to the right and or left when in a turn eather righr or left , power stearing pump has been replaced and the stearing box has been replaced , did not solve the problem.

Jul 22, 2009 | 1999 GMC Denali

1 Answer

03 suburban steering wheel unlocked and can't turn key

Jiggle the steering wheel straight then proceed to turn key the steering column gets locked and immobile try that guys/ Please rate my response thank you very much

Aug 22, 2008 | 2003 Chevrolet Suburban

Not finding what you are looking for?
2009 Ford Focus Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5677 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides