Question about 2003 Chevrolet Corvette

1 Answer

2003 RUNNING LIGHT HOW TO CHANGE - 2003 Chevrolet Corvette

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 389 Answers

Hello. There are a few different ways to get access to the bulb. You can remove a small plastic panel underneath the car and reach up. Grab the light socket and give it a quarter turn counter-clockwise and it will come out. When replacing the bulb, don't touch the glass part with your bare fingers. You can also get to it by turning the manual headlight knob and partially raising the headlights enough to remove the plastic surround from the headlight, ( don't use the headlight switch, they will auto-close in 15 minutes and you don't want your arm caught in there), once the surround is out you can reach down and remove the running light socket. Some people remove the "hood bumper" to get more room, I don't recommend this because you don't want to put it back in the wrong position. I hope this gives you some help, good luck.

Posted on Feb 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to fix running lights


did you check the beams and the socket,then fuses,but change the socket if you can ok,the running light should be the inner seal beam that i think also is the hi beam so check your light switch as well

Jun 25, 2014 | 2003 Chevrolet Silverado 2500HD

1 Answer

2004 ford e150 brake lights


do you have voltage at the brake light switch ?

Aug 04, 2012 | 2003 Ford E150

1 Answer

How to change the02 sensors on a 2003 buick rendevzous


The O2 sensor on your Buick is located on the rear (under windshield cowl side of your exhaust manifold...You might be able to spray injector cleaner on it after removal...use PB Blaster to lubricate before removing the nut...also have you tried running some gas tank fuel injector cleaner in your gas tank recently? Sometimes this will help the sensor to work properly. To clear your "check engine light" you need to disconnect the positive side of your battery cable for about 15 minutes, then reconnect...the light should stay off if all is OK...Hope this helps.

Apr 05, 2012 | 2003 Buick Rendezvous

1 Answer

Hi, I have a Pontiac Montana 2003 for a year and is running well, it has 148000 km. Today I went from Toronto to Niagara Falls and park my car for a couple of hours and when I turned on the engine the...


replaced the oil and re set computer to fresh oil change
thes older models will only go aproxamitly 5000k on oil change
it may not have been reset at last oil change
key on run motor off depressed gas pedal to floor 3 times within 5 seconds of key on run
then start motor to re set oil life system

Apr 09, 2011 | 2003 Pontiac Montana

2 Answers

I have a 2003 Olds Alero. Last week the oil change light came on. That same day, it suddenly started running rough when idling. Things I've done to try to fix the problem: * Fuel pump was replaced...


Is the check engine light on? I'm sure changing the oil had nothing to do with how the vehicle is running now unless they didn't replace the oil drain plug or added enough oil.

Jun 02, 2017 | 2003 Oldsmobile Alero

1 Answer

2003 vw jetta oil light came on and went off the car has oil in it. today the oil light came on and the temp gauge went up and came back down and the car started ticking. it did this twice within a few...


Check your coolant level and condition. If you havent' replaced the coolant in a while then change it. You can drain it from the bottom of the radiator plug. You may also want to change your oil and oil fiter.

Aug 17, 2010 | 2003 Volkswagen Jetta TDI

1 Answer

The oil light came on today when i started my 2003 xterra


The oil light comes on when there is no pressure. There is no pressure when the pump either cannot get oil to pump or has oil and will not pump it.

Get it checked before you do anything else. A engine running with no pressure is a cooked engine.

Feb 12, 2010 | 2003 Nissan Xterra

1 Answer

How do I reset the change oil light on a 2003 Chevy Surban


rotate ignition switch from off to on three times. With ignition in on position not running press gas pedal to floor three times. Turn ignition off then start vehicle.

Jun 22, 2009 | 2003 Chevrolet Suburban 1500

1 Answer

I have a 2003 Tahoe. The check engine light is on.


i would start easy and run a bottle of injector cleaner through it. Good Luck

Mar 14, 2009 | 2003 Chevrolet Tahoe

Not finding what you are looking for?
2003 Chevrolet Corvette Logo

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...