Question about 2001 Nissan Xterra

3 Answers

Diagram available for 01 Nissan Xterra Knock Sensor location?

Is there a diagram available for a 2001 Nissan Xterra on where the knock sensor is located?

Posted by on

  • 1 more comment 
  • Anonymous Mar 12, 2014

    Where is the knock sensor located on a 2000 Nissan Quest

  • Anonymous Mar 12, 2014

    Location of a 2000 Nissan quest knock sensor

  • Anonymous Mar 16, 2014

    Where is horn located on 2003 Nissan xterra

×

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 17,970 Answers

V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

Diagram available for 01 Nissan Xterra Knock Senso - 9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Posted on Feb 08, 2010

  • FixItYoSelf Dec 22, 2010

    Unless you have an aggressive BODY LIFT kit, you cannot reach this sensor without removing the entire upper and lower intake manifold, fuel rail, etc... An Experienced mechanic would take about 5 hours, and a DIY'er could take 10 hours (or more, depending on experience level).

×

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

How do i change the knock sensor on a 2001 nissan xterra

Posted on Apr 03, 2010

  • jplumb38
    jplumb38 Aug 30, 2012

    Can you answer this question for me also?

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You're probably better off just selling your Nissan

Posted on Feb 06, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Knock sensor 2000 nissan xterra V6, location of sensor? how to change knock sensor?


Hello the sensor is located under your intake manifold you will need to remove the intake manifold to gain access to it here is photos of what and where your looking for thisregeetone_0.pngregeetone_21.jpg

Jan 23, 2011 | 2000 Nissan Xterra

2 Answers

I have on 01 xterra-service engine light on-codes P1126 & P0325. I think the battery is about to go,could it be realated to codes? Otherwise what do the codes mean? Appreciate any help


Your battery has nothing to do with these codes. Your vehicles computers have detected a malfunction or failure in the system. This triggers these codes and sets your check engine light. Below I have listed the code meanings and some repair solutions.

P1126 - Throttle Position (Narrow Range) Sensor Circuit Malfunction.

Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is not provided to the ECM.

Possible Causes For P1126:
- Harness or connectors (Throttle control motor relay circuit is open)
- Throttle control motor relay


P0325 - Knock Sensor Circuit Malfunction

The knock sensor is attached to the cylinder block. It senses engine knocking using a piezoelectric element. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the Powertrain Control Module (PCM) or Electronic Control Module (ECM).

Possible Causes For P0325:
- Knock sensor circuit short to ground.
- Knock sensor circuit short to power.
- Knock sensor circuit open.
- Damaged knock sensor.
- Damaged PCM or ECM

Possible Solutions:
- Repair or resecure harness or connector
- Replace knock sensor Bank 1 (Bank 1 if applicable)
- Replace PCM or ECM

The P0325 DTC is a very common problem with Nissan vehicles. On most Nissan vehicles the knock sensor is located on top of the engine block.

knock_sensor_infiniti.gif

Jan 20, 2011 | 2001 Nissan Xterra

1 Answer

Where is the knock sensor located


Thank you fo using Fixya

For your 01 Nissan xterra V6 3.3L. The sensor is located underneath the air intake manifold on top of the engine block.

All the best!

Nov 17, 2010 | 2001 Nissan Xterra

1 Answer

Where is the knock sensor for the 04 nissan xterra located?


Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models.

Nov 05, 2009 | 2002 Nissan Xterra

1 Answer

Knock sensor location


HI, click the link below to be directed to a full diagram that will show you the actual location of the sensor. 718 will be the actual sensor to extract and 739 is the mounting screw for the KS.

KNOCK SENSOR DIAGRAM

Jul 22, 2009 | 2001 Chevrolet Silverado

4 Answers

Nissan xterra knock sensor


It's the valley of the engine underneath the intake manifold. It's about an $800 job because the top of the engine has to come off. However, unless you have a supercharged xterra it shouldn't effect performance. Also, the knock sensor will not trip the check engine light, as it does not indicate a primary problem, so if your light is on you should have another code that should be fixed first.

Nov 05, 2008 | 2002 Nissan Xterra

Not finding what you are looking for?
2001 Nissan Xterra Logo

9,745 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...