Question about 2005 Kia Sedona

1 Answer

2005 Kia Sedona, Trouble Code P0320. Everything I read online tells me its a Crankshaft Sensor. I called Kia and then sent me to www.kiatechinfo.com were it says that the code is an Ignition System Failure Sensor. I searched every were and there is no **** thing. Can anyone here help me please.

Posted by on

  • 1 more comment 
  • cessna1466u Feb 08, 2010

    Thanks lylerwh, I didn't think anyone was going to answer. The van drives perfect. The only thing wrong is a check engine light and the Tachometer stuck on 0. I ran the scan tool at Schucks Auto and it came up with the p0320 code which is supposed to be a crankshaft sensor, but the kiatechinfo.com website says its a Ignition System Failure Sensor, which no one has ever heard of.

  • Lyle D. Rowh May 11, 2010

    A crankshaft sensor is a part of the iginition system. If you don't have it, your plugs won't ignite. These terms are sometimes confusing.

  • Billy Sikes Oct 01, 2013

    Cessna1466u, did replacing the crankshaft sensor work? I am having the same problem.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 67 Answers

This is a common problem usually related to the crankshaft position sensor. Before you replace it, disconnect the electrical connector to the CPS sensor and clean it with electrical contact spray and add a dab of dielectrical grease. If the problem continues, replace the CPS sensor. It is easy to replace and is not very expensive. It just bolts to the engine block with one or two bolts. I believe the CPS sensor on the Sedona is behind the timing cover on the front of the engine.

Posted on Feb 12, 2010

  • Speedy14u2 Aug 14, 2011

    It isn't the CPS sensor trust me. We installed a new one at our shop since nobody knew what an IFS sen sor is and the vehicle runs fine with no tach. Either dont worry about it or go to KIA and spend $120 to get it figured out correctly instead of guessing online to save a buck. The CPS sensor cost $200 if you can even find it, and doesnt make a difference, Good Luck

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fault code is P0183


this is the fuel temperature sensor a circuit high input reading

Jun 28, 2012 | 2005 Kia Sedona

1 Answer

Need diagram for 2005 kia sedona


Register to http://www.kiatechinfo.com/.
Much the same web site as the dealers have. As this site is for USA there is not much about diesel but everything else is there

May 29, 2011 | 2004 Kia Sedona

1 Answer

I went to have an emissions test and I failed.


code P0320 stored.
Tests/Procedures:
1. Check if the oil pump drive housing has rotated on the hold down clamp. If it has, replace the oil pump drive gear and housing.

2. Scope the Crankshaft Position (CKP) sensor.

3. Scope the Camshaft Position (CMP) sensor.

Potential Causes: Camshaft Position Sensor (CMP)
Crankshaft Position Sensor (CKP)
Distributor Sync

Only a qulified mechanic will be able to tell you the cost once he eliminates each possibility.

Jan 31, 2010 | 2003 Kia Sedona

3 Answers

Crankshaft position sensor replacement on 2005 Kia Sedona


The CPS is located under the timming cover 4 small bolts remove the cover and the sensor is viewable 2 bolts have to be loosend and the wire leads up to a dual connector on the left side of the engine

Jan 26, 2010 | 2003 Kia Sedona

1 Answer

03 Kia -P0320 Ignition/Dist Engine engine Speed Input Circuit Malf. What does that mean?


You most likely have a bad crank or camshaft sensor. Either way it is a bad sensor that is not being read correctly by the computer.
You can go to autozone.com and register for full free online repair manual. It will also tell you exactly what the code is for and what should be replaced.

Sep 28, 2009 | 2003 Kia Sedona

1 Answer

2005 kia sadona belt replacemnet


This guide will help you. Just provide an email and log on.
http://www.kiatechinfo.com/

Jul 15, 2009 | 2003 Kia Sedona

1 Answer

Gearbox linkage broken


http://www.kiatechinfo.com/index.asp

Good source for Kia its free to register NO STRINGS

May 04, 2009 | 2005 Kia Sedona

1 Answer

Check Engine light on 2005 Kia Sedona


This is the KIA tech site. Free to register and use. It lists the repair tech manuals, Sevice Bulletins,Trouble Code identifications, How-to's, and troubleshooting guides the factory trained repair guys use:
http://www.kiatechinfo.com/index.asp

AutoZone will read trouble codes for free

Mar 17, 2009 | 2005 Kia Sedona

Not finding what you are looking for?
2005 Kia Sedona Logo

4,789 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...