Question about 2001 Hyundai Santa Fe

1 Answer

Heater switch does not go on - 2001 Hyundai Santa Fe

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 677 Answers

Please check your fuses make sure they are ok. If not and the fuse is blown, then we must ask why ?
Is the blower motor or resisitor going bad ?
Please let me know.

Posted on Feb 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2000 Isuzu npr has no 12v to heater relay in order to apply voltage to heater system. where does this 12v come from ?


accessories fuse check this.
check heater switch - see if 12v at heater switch
Check if 12v applied to relay coil to switch it

Nov 27, 2016 | Isuzu Cars & Trucks

1 Answer

My 2005 GMC C7500 heater is not blowing hot air. The fan is working fine, but it seems we can'[t get it to switch to heat. We replaced the in dahs switch assembly thinking the switch just wasn't...


It is probably the blend doors in the heater case not opening correctly. They are probably vacuum operated doors.


Check the heater core by feeling both heater hoses (the inlet and outlet) when the engine is at normal operating temperature. Both hoses should feel hot, meaning the heater core is circulating coolant correctly. If only one hose feels hot, the heater core may be plugged up, or it may have an air block.

If the heater core checks out good, check the heater case doors for proper movement when you switch from cold to heat. Several vacuum lines branch out from back of the control unit to vacuum canisters on the case, which open or close the various doors. These doors used to be only cable operated, but most are now vacuum operated. There should be a single vacuum hose from the engine, into the firewall, and then to the heater control unit in the dash, where hoses distribute the vacuum signal to various doors or vents as demanded by the switch settings.

Oct 24, 2014 | Cars & Trucks

1 Answer

Can you fix a windshield wiper switch and heater core at the same time in a 98 s10?


There not related,so doing the heater core doesn't doesn't make the wiper switch easier.Click here to see.Here's the heater core.

Feb 13, 2013 | 1998 Chevrolet S-10 Pickup

1 Answer

Smoke or steam comes out of heater vents


it could be your heater core leaking - you will be able to see why
the vents won't switch when you take the heater box out to do the
heater core

Jan 19, 2013 | 1986 Ford Bronco

1 Answer

Fuse diagram for a 98' E-150 van specifically for heater fan


owner manual will tell you fuse layout. If you have only high speed, you have a bad resister. 4 wires.

Resistor —Heater Blower Motor Switch Removal
  1. Remove the battery (10655) ; refer to Section 414-01 .
  1. Remove the battery tray.
    1. Remove the screws.
    1. Remove the battery tray.
  1. Disconnect the heater blower motor switch resistor connector.
  1. Remove the heater blower motor switch resistor (18591).
    1. Remove the two screws.
    1. Remove the heater blower motor switch resistor.
---------------------------------

0f120f5.gif

Feb 26, 2010 | 1998 Ford Econoline

2 Answers

Heater problem, not very hot & not switching from defrost to floor


either the AC\Heater panel switch on your center dash or the heater box vent door is stuck or not operating. Most likely panel switch or disconnected \ broken vacumm lines at back of switch

Jan 13, 2010 | 1996 Chevrolet Blazer

1 Answer

Fan quit on 87 celebrity, heat ac, etc.. fuse ok ????


Hi
Check for bad connection at heater resistor or try tapping heater motor lightly
with ignition switch on and heater switch on. Could be heater switch connection.

Apr 01, 2009 | 1987 Chevrolet Celebrity

1 Answer

I have a 2000 ford E350 van with front and rear air. the front blower motor runs at low speed, The front blower still runs on low even when the knob is set on medium or high. I do not know where the...


it's either the blower motor switch or blower motor resister. Resistor ?Heater Blower Motor Switch Removal Remove the battery (10655) ; refer to Section 414-01 . Remove the battery tray. Remove the screws. Remove the battery tray. Disconnect the heater blower motor switch resistor connector. Remove the heater blower motor switch resistor (18591). Remove the two screws. Remove the heater blower motor switch resistor. ----------------------------------- Switches Removal Disconnect the battery ground cable. Remove the center trim panel; refer to Section 501-12 . Remove the control assembly. Remove the screws. Remove the control assembly. Remove the A/C-heater function selector switch knob. Disconnect the vacuum harness connector. Disconnect the A/C-heater function selector switch connector. Remove the A/C-heater function selector switch. Remove the screw. Remove the A/C-heater function selector switch. Remove the temperature control switch knob. Disconnect the temperature control switch connector. Remove the temperature control switch. Remove the screw. Remove the temperature control switch. Remove the heater blower motor switch knob. Disconnect the heater blower motor switch connector. Remove the heater blower motor switch (18578). Remove the screw. Remove the heater blower motor switch. ----------------------------

Mar 31, 2009 | 2007 Ford E-350 Super Duty Length XLT

1 Answer

No heat


The most likely problem is a stuck heater switch. follow the heater hoses from the firewall to the engine block, somewhere along those lines will be a switch that allows the warm coolant to pass through the heater core. place your hand on both sides of the switch with the car warmed up, if the side towards the block is warm and the side towards the heater core cool then replace the switch.

Nov 23, 2008 | 1999 Saturn SL

Not finding what you are looking for?
2001 Hyundai Santa Fe Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...