Question about 2000 Toyota Sienna

1 Answer

2000 Toyota Sienna Headlight Problem

Hello, We just got a 2000 Toyota Sienna as a gift. It was wrecked in the front about 2 years ago and was fixed. Since then..the front left low beam light only will blow a fuse and the interior lights go out as well. If the wires are in good working order...is it possible that the wires installed were incorrect.

Posted by on

  • green200937 Feb 08, 2010

    Hey Steve...just to double check if all else fails we can use the working wires from the right side of the car and run the left side as well...and it will not overload? That was such a great answer thank you!!! :)

  • green200937 Feb 08, 2010

    Hey Steve...just to double check if all else fails we can use the working wires from the right side of the car and run the left side as well...and it will not overload? That was such a great answer thank you!!! :)

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 1,675 Answers

It sounds like there is an earthing fault, they may have got the wires for the lights the wrong way round and is now shorting the fueses, try removing the plug from the rear of the headlight and checking it with the oppersit side and see if the wires are the same, if not just swap the live for the earth and see how you get on, also check to see if any of the wires are burnt together this also could be shorting it out, the other way round it is, just run 2 wires, and earth and a live from the oppersite side and connect directly to the plug wires ( you wil have to cut them frm the plug) make sure you give yourself plenty of length on the plug wires...hope that helps

Posted on Feb 08, 2010

Testimonial: "Thank you will try this out at tonight!"

  • steve morris
    steve morris Feb 08, 2010

    no it wont overload it as the fuse still has to cope with both the lights anyway, your just removing one power sorce and replacing it with another, yes you got it right...good luck

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The rear bumper cover came off how can I reinstall it


2000 Toyota Sienna rear Bumper cover replacement (1998 ...

? 3:40
https://www.youtube.com/watch?v=AY1BBdg3q74
Sep 20, 2013 - Uploaded by SergSpace
2000 Toyota Sienna rear Bumper cover replacement (1998-2003) .... Automotive Bumper Repair Specialist- How to repairyour plastic bumper cover ... Toyota Sienna Rear Shock Installation 2003, 2004, 2005, 2006 - Duration: ... 2015 Toyota Sienna XLE - Duration: 28:13. by MikesCarInfo 35,234 views.

Fixing My Mom's Prius: Loose Rear Bumper Cover - YouTube




Nov 29, 2015 | 2005 Toyota Sienna LE

1 Answer

Headlights do not work high or low beam all other lights work


Re: Condensation in Sienna Right Headlight.... - Toyota Sienna Forum

www.siennachat.com/.../4606-condensation-sienna-right-headlight.html
Mar 10, 2009 - 15 posts - ‎9 authors Over the years, I was not a frequent visitor to SiennaClub...but when I did visit, it was... in the right, passenger-side xenon HID headlight of my 2004 Sienna...the light has... Check with your dealer and see if they can do anything about it. .... :o The HID bulb is also a PITA to remove because you are working ... Re: 2004 Sienna no brake lights, radio, heater/AC ...
15 posts
Jan 4, 2013
Thread: HELP: Both Low Beams don't Work
6 posts
Nov 27, 2011
Thread: 2000 sienna drl and/or headlight issue
5 posts
May 7, 2010
Automatic Headlight Option: Useful or Not?
8 posts
Mar 3, 2010
More results from www.siennachat.com

Toyota 2004 Sienna repair: Replacing HID ballast or ...

toyotarepairsemipro.blogspot.com/.../replacing-hid-ballast-or-computer....
May 1, 2010 - Replacing HID ballast or computer control lighting for the Headlight. Just got a ... Up until now, I did not know I had the option of seeing twice as far with Xenon. Also up to ... In the end after buttoning everything up, the light did work fine. .... Howdo you determine if you have a HID or non-HID light? Reply ...

Oct 15, 2015 | 2004 Toyota Sienna

1 Answer

Is there a 12V output from integration relay going to headlight switch of 98 sienna LE. no headlight both hi and low, but flash headlight is working.


There is a fuse for both the low and high beam headlights.
There is a relay for both as well.

The headlight switch feeds the relay.

Thank you the excellent symptom of the problem.

Yes,12 V. goes to the headlight switch.

Mar 09, 2013 | 2000 Toyota Sienna

1 Answer

My Toyota Sienna 2000 has power door problem. It stopped working. I took it to the dealership, who re-program the computer and the power door started working normally - but only for a few times before it...


Obtained from the following link: http://www.siennachat.com/forum/16-general-discussion/58-2-ways-fix-sienna-power-door-problem.html
2 ways to fix a Sienna power door problem

Just wanted to share my success with 2 ways I fixed my wife's power door:

1. Clean the track, using soap and water...for real tough grease/oil, use lite acetone and wipe as to not destroy the paint. Then, I used low temperature grease (no, it does not "melt" even in the FL sun!) on the tracks, joints, latch areas, guides, etc. Finally, clean the seals (between the rubber and the door jam) then "armor-all" the heck out of it....this worked for me for several years....toyota told me to replace it 5 yrs ago for $600!

2. I found this thread and tried it today, works so far...http://www.fixya.com/cars/t595343-ne...nna_power_door ....if the link does not come up, here's the nutshell:

Turn the power door control button to the off position (where you can't see the red on the button).

Disconnect the - battery cable for a minute or so.
Reconnect, and then turn the system back on with the same button.

Open the door and see if it worked. Thats the pricedure for 'recalibrating' the system.

Nov 21, 2017 | 2003 Toyota Sienna

1 Answer

Need Detailed Diagram for Audio Wiring In 2000 Toyota Sienna


2000 Toyota Sienna Stereo Wiring Constant 12V+ Blue/Yellow Switched 12V+ Gray Ground Brown Illumination Green Dimmer n/a Antenna Trigger Black/Red Antenna Right Front Front Speakers 6 1/2" Doors Left Front (+) Pink Left Front (-) Purple Right Front (+) Green Right Front (-) Blue Rear Speakers 6 1/2" Side Panels Left Rear (+) Black Left Rear (-) Yellow Right Rear (+) Red Right Rear (-) White

Apr 04, 2010 | 2000 Toyota Sienna

2 Answers

Van Leaks Water Above Emergency Brake


It does sound like it may be coming in by the windshield. Especially if it has been replaced. Most windshield replacement companys stand behind their work and will pull the windshield out again and reseal it for free. Check on that first. You may not have to do any work!

Feb 22, 2010 | 2000 Toyota Sienna

1 Answer

1999 toyota sienna replacement the headlight set


Ask the dealer about the lens. That is where 98% come from

Sep 29, 2009 | 1999 Toyota Sienna

1 Answer

Both manual sliding doors on my Toyota Sienna will not open


Check out this youtube video for taking off the interior door panel and resetting. https://www.youtube.com/watch?v=MkC2OiOiE_U

Apr 09, 2017 | 2000 Toyota Sienna

2 Answers

Moisture in headlight assembly, 2004 toyota seinna van. How do I take out to reseal or replace? It is the assembly on the passenger side.


Once the factory seal is leaking moisture, it can be hard to dry and reseal. You can try a hir dryer, and then look for a seam to lay silicone on, but the recommended fix is to replace the whole headlight assembly. The lens is not removable like on older lamps. The pieces are molded, and then epoxied together. Hard to split apart and get back together without damaging. Try a salvage yard.

Mar 20, 2009 | 2004 Toyota Sienna

2 Answers

I had moistured on my 2004 sienna headlight, How can i removed the moistured?


I fixed this problem on my 2004 Sienna. The moisture seems to come in from the top of the headlamp assembly. I generously applied Permatex Super Clear VINYL SEALANT to the seam at the top of the assembly after drying out the moisture by remvoing the bulbs. There are vent at the bottom of the assembly which should be open; there's a liitle foam plug that let's air in so the assembly is not intended to be airtight. There has been no moisture problem for about a year.

Jul 31, 2008 | Toyota Sienna Cars & Trucks

Not finding what you are looking for?
2000 Toyota Sienna Logo

406 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...