Question about 2001 Buick Park Avenue

Open Question

2002 Buick Park Avenue. Driver's side heater not

2002 Buick Park Avenue. Driver's side seat heater not working. Shops says whole leather seat has to be replaced for $600. Any ideas?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2920 Answers

SOURCE: Replace Thermostat in 1998 Buick Park Avenue

if you follow the top radiator hose to the engine you will see where it connects to the engine...you will want to drain some of the coolant from the radiattor but once you loosen the clamp holding the hose on you will need to pull the hose off and push it to the side out of the way. there are two bolts that hold the housing on that you need to remove where the hose was hooked up. once you take those bolts out you should be able to pull the housing out and the thermostat is right there.
i do wish to offer you an opinion on the thermostat i dont think its the problem..i think maybe your heater core is partially clogged and not letting the coolant get into the interior of the car as you are driving.if its blowing warm when you start it up and let it run and it gets warm and then get cooler as you drive thats going to be in the heater core since the thermostat is opening to let the heat in when you first start the car up to warm it up.

Posted on Jan 12, 2009

emissionwiz
  • 75817 Answers

SOURCE: my 1997 buick park avenue

U need to replace the air temperature control blend door actuator motor, this requires removing the dash to access the motor for the blend door.

Posted on Apr 13, 2009

  • 6 Answers

SOURCE: 1991 buick park avenue will not run fuel pump is good and replaced the fuel filter

http://www.fixya.com/cars/t1810766-1991_buick_park_avenue_stop_running

Check out this link. It may help you with your problem.

Posted on Apr 23, 2009

matney68
  • 426 Answers

SOURCE: 1998 Buick Park Avenue Ultra, AC was low on

still low on charge usually problem.

Posted on Jun 19, 2009

  • 115 Answers

SOURCE: 2000 Buick Park Avenue Service engine soon light

need to take car somewhere to have the code read with a scanner,try parts stores first some will do it for free if not the dealers have them

Posted on Sep 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you change the driver name and memory for seat and mirror adjustment on a 1997 buick park avenue ultra


I am not sure about changing the name as my 2000 park ave. only indicates driver one or driver two. To reset the memory for seat/ mirror position is rather simple: with the ignition on and the car in park, adjust your seat and mirrors to the desired position. Then press and hold the desired button (driver one or two) until you hear a beep, This is the procedure that works on my 2000 park ave. I hope this helps you.

Jun 21, 2014 | 1997 Buick Park Avenue

1 Answer

Where is the Fuse panel on a 2002 buick park avenue


there are 3,, one in the engine compartment,, one on the passengers side inside the cab,, this one in my Buick is on the side wall under the carpet,, ( nice place to put it),, the third according to my manual is located under the back seat,, hope this can help You...

Jun 17, 2014 | 2002 Buick Park Avenue

4 Answers

The driver side power seat button moves forward and backward and reclines, but wont move up or down, the seat is stuck all the way down so i cant get to the wrom gear underneath, how do i go about raising...


I am working on a replacement motor that will come with a new gear/shaft on it. I have one of my setups in the car right now and have the parts for another one ordered. I hope to make a video of the repair in a couple weeks when the parts show up. Still uses plastic gears, but these are larger, more durable gears and the swap is fairly straight forward with just a few modifications.

Jul 10, 2012 | 2002 Buick Park Avenue

3 Answers

2002 buick park avenue power drivers seat won't go up or down


The most common problem is the gear breaking under the seat. There is one motor to make the front go up and down and one motor to make the back go up and down. The front up/down motor is the easier one to replace. I have a video of one way to fix the up/down motors. I demo the back motor. Here is the link to my video: http://www.youtube.com/watch?v=wQLVvUf-9rs

Jun 30, 2012 | 2002 Buick Park Avenue

1 Answer

Turn signals on my 1992 Park Avenue blinked slower and now donot work at all. My emergency flashers work fine and all blink but I have no turn signals and nothing lights up when signal is left or righ


About your 1992 Buick Park Avenue 3.8L SFI OHV 6cyl. the Flasher is located:
Hazard flasher: Front seating area, driver side, under dash, mounted above kick panel

Turn signal: Front seating area, driver side, under dash, driver side of steering column, mounted on support bracket

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Nov 11, 2011 | 1992 Buick Park Avenue

2 Answers

Where is Flasher


1994 Buick Park Avenue 3.8L SFI OHV 6cyl
The Flaser is located in front seating area, driver side, under dash, driver side of steering column, mounted in lower corner of fuse block.

Application:
01 for Hazard flasher; and,
01 for Turn Signal Flasher.

Good luck (remember rated this help).

Jan 13, 2010 | 1994 Buick Park Avenue

1 Answer

Buick park avenue 1997 leaking need to replace


Ussualy a pain,but some radiator shops will replace it cheaper than most machanic shops.

Jun 18, 2009 | 1997 Buick Park Avenue

1 Answer

Where is the starter ignition relay on a 1993 buick park avenue located?


Front seating area, driver side, driver side of steering column, behind upper dash panel, mounted above fuse block

Dec 19, 2008 | 1993 Buick Park Avenue

Not finding what you are looking for?
2001 Buick Park Avenue Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...