Question about 2002 Jeep Liberty

1 Answer

How do you remove a door panel in a 2002 jeep liberty? Its the back seat behind the driver. The window is off track

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

There should be a screw by the door handle and 1 or 2 behind some small circle inserts the rest is held by clips. Be careful not to break the plastic

Posted on Feb 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i check the window switch jeep liberty?


Get yourself a test light and remove the switch from the door panel, you should have 12v going to one side of the switch and when you activate the switch power should be available at the other side. If you remove the door panel and access the wires going to the window motor, you should get power to the motor when you activate the switch. If you have power going to the motor and the motor doesn't run.....has top be a bad motor.

Aug 10, 2014 | 2002 Jeep Liberty

1 Answer

How do you remove rear drivers side door panel on 2002 jeep


Several steps in here; review the KJ-2002-Liberty-Service-Manual-PDF-Secc-23-Body (page 128 and next).

I hope help you with this. Remember rated this help, good luck.


Sep 04, 2009 | 2002 Jeep Liberty

1 Answer

I have a 2002 Liberty Sport, the right side back passenger window will not go up. I can hear the motor work in both directions but the glass stays inside the door. How do I get the door cover off so I can...


The window has likely come off the track. DO NOT roll the window up or down as it may scratch the glass inside the door. Their in a few screws and some body panel plugs to pull out. They make a special tool for this. I just give her a good yank, If they break don't worry they sell new ones at the dealer and most parts stores.

Jul 29, 2009 | 2002 Jeep Liberty

2 Answers

Jeep liberty 2002 window problem


the guides that hold the window in the track are probably broken. easiest to take it to an auto glazier and have it checked, unless you feel like pulling the door panel off and replacing the guides yourself.

Jun 18, 2009 | 2002 Jeep Liberty

1 Answer

Front Window stoped working on 2002 Jeep Liberty


Three things. Fuse, window motor, or bad switch. If the fuse is good, remove the door panel, disconnect the harness to the window motor, and check to see if you have power with a test light/volt meter while pushing the window switch (ignition switch in ON position). If you have power, the motor is bad, if you do not, replace the window switch.

Apr 13, 2009 | 2002 Jeep Liberty

1 Answer

2003 Jeep Liberty rear side window "squeals" when operated down.


I usually spray guide tracks with a silicone spray. It works pretty well. Up north where I am, when sprayed on door seals it keeps doors from freezing closed as well!

Mar 11, 2009 | 2002 Jeep Liberty

1 Answer

2003 Jeep Liberty Power Window Off Track


its the window regulator. not to bad to change. just a couple of screws to remove the door panel. peel the liner back & remove the 6 10mm bolts and uunhook the electrical connector and the window from the regulator. installation is reverse

Jan 21, 2009 | 2007 Jeep Liberty Sport

1 Answer

Replace Driver's side mirror - Jeep Liberty 2002


The door panel has plastic clips that hold it in place also. Put a thin blade screwdriver between the panel and door. Pry the panel away from the door. The panel will make a loud snapping noise, that is the clip coming out of the retaining hole. Sometimes the clips break.

Dec 09, 2008 | 2002 Jeep Liberty

3 Answers

Rear window falls down


The same thing just happened to me. I took off the door panel, pulled off the white barrier, and found the problem. There is a white plastic connector at the bottom of the window that connects the cable to the window and the track for the power-window. The connector has broke and the cable cannot grip the connector so the window falls. Its hard to tell because it will still be connected to the track, its just a small part of the connector that broke off. I have found that the only way to fix it is to replace the whole assembly. Don't waste time taking apart the motor housing, it is a pain. I found, and bought, the whole assembly on ebay motors for $120.00 shipping and all. If you have some tech abilities it shouldnt be too bad. If you need more info, just e-mail me, Im waiting for my part and will be assembling soon.

Aug 02, 2008 | 2002 Jeep Liberty

2 Answers

2002 jeep liberty - limited - electrical problem


If yor liberty is a 2002 to 2004 it is very likley that the wiring harness is pinched under either the drivers or passengers seat. you need to remove the seats (its only 4 bolts) and lift up the carpet and look at the harness that runs under the seats. I have seen this many times before.By the way i am a Jeep master technicain and have been for 15 years.

May 18, 2008 | 2002 Jeep Liberty

Not finding what you are looking for?
2002 Jeep Liberty Logo

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...