Question about 2002 Chevrolet Impala

Open Question

Cant get gas in tank

Tank will only accept gas at a very slow pace,it takes forever to get $5.00 in the tank. Replaced the fuel pump to fix the guage but it still wont accept gas. Is there a check valve or something in the filler neck or what? Thanks, Bob

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
csmock132
  • 4669 Answers

SOURCE: 1992 Pace Arrow Motor Home 454 Chevy...not getting fuel to start

After you dump the fuel in the throttle body it will continue to run on its own or die as soon as it burns up all the fuel you dump in? Do you have access to (Noid lights)? Are both plugs attached to the distributor?

Posted on Jun 24, 2009

Ad
  • 87 Answers

SOURCE: 04 chev. 1500 fuel tank will not take gas, gas

Evap vent solenoide is stuck closed. Start by replacing the valve and checking the hose to the valve for clogs...this is located between the cab of the truck and the bed of the truck on the driver side (can be seen if you look down through the crack)....If this doesn't work then check the fuel filler neck hose for kink or restriction this is the hose that goes from the gas cap to the fuel tank.

Posted on Aug 02, 2009

  • 1 Answer

SOURCE: I have a 2000 Chevy 3500 box truck with 2 gas

Fuel levels are equaled in the tanks via a frame mounted transfer pump that transfers fuel from the rear tank to the front tank where the main pump is. Your transfer pump needs replaced, and should run about 60 bucks. Should find the pump mounted to the frame between tanks.

Posted on Jan 10, 2010

caroldon
  • 17130 Answers

SOURCE: How to repair Fuel Tank crack at filler neck

The only way is to remove the tank from the vehicle first , then remove all the fuel from the tank. The neck can be welded using gas welding , get help if your are not familiar with welding. if the crack is wide , use a clipper to hold while you weld and try to fit the filler cap before fitting back the tank. Hope you get this right.Good day.

Posted on Aug 14, 2010

HansPP
  • 2510 Answers

SOURCE: I am trying to syphon gas from my 99 Cavalier with

Yes, virtually all cars have them these days. You will not get any fuel out of the filler cap. There are some places you might get access to the tank contents like the outlet to or from the pump, the rubber connector that connects the filler pipe to the tank or the fuel pump if it is mounted in the tank and is accessible under the back seat.

Posted on Mar 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel problems 1988 pace arrow


remove the tank unit and check it as their is a gauze filter on the bottom of the pick up and it could be dirty

Apr 05, 2015 | Cars & Trucks

2 Answers

2001 Durango acts like the gas tank is full during filling cutting off the pump. The only way to fill tank is to pump gas really slow


Chrysler and Dodge have a fuel vapor filter that allows air out of the gas tank but filters the harmful fumes. Usually the problem happens from topping off your gas after the gas pump stops due to the automatic shut off and then putting more gas in the tank (to make the bill an even $50. or to the next $5 increment, or pumping more in just because it fits). Anyway the filter gets saturated with gas, is not able to breath, and causes a vacuum in the tank. Because of this, the anti-siphon ball is not able to float around and sits at the opening of the fuel fill tube and won't allow any more gas to be put in (acts like the car is full). If you pump super duper slow like put a nickel to hold the gas pump handle, it will trickle in without a problem, but it takes forever! Solution, get the filter replaced and don't over fill the tank.

Sep 11, 2010 | 2001 Dodge Durango

1 Answer

2005 chev silverado takes forever to pump a little fuel in gas tank


Not sure what you mean. Do you mean takes awhile to pump gas into tank? If so it's because that truck has a large gas tank compared to a smaller car or the gas station you regular has slow pumps. :s

Sep 05, 2010 | 2005 Chevrolet Silverado

3 Answers

Gas guage not working on daughter's 1997 Buick Lesabre - just replaced the fuel pump-should we have done something while the tank was off for the gas guage?


if you did nothing wrong replacing it then most likley the the level sensor is jammed. You will need to take the tank back out and inspect.

Jul 23, 2010 | 1997 Buick LeSabre

1 Answer

Repalced fuel pump on 1997 voyager and gas guage


well either the fuel sender got caught on the tank baffle or your other sender was going bad

May 05, 2010 | 1997 Plymouth Voyager

2 Answers

I have a 2000 Chevy 3500 box truck with 2 gas tanks. The gas guage only goes to 1/2 with both tanks full and it won't pump gas from the second tank. How do I fix this.


Fuel levels are equaled in the tanks via a frame mounted transfer pump that transfers fuel from the rear tank to the front tank where the main pump is. Your transfer pump needs replaced, and should run about 60 bucks. Should find the pump mounted to the frame between tanks.

Oct 14, 2009 | 2000 Chevrolet 3500

1 Answer

Gas guage is not working


If there is gas in the tank and it is not registering correctly, then the sending unit or power to sending unit is bad.

Sep 16, 2009 | Volvo 740 Cars & Trucks

2 Answers

Gas gauge reads empty but tank acts like it's full


I also have a 04 with a 1.8L. same problem. I took the fuel regulator off. It is a black box behind the rear tire under car. It only has 2 bolts to take off. After that there is a couple of vent hoses from the tank going to this box. Unplug them and 1 electrical connection. The electrical connection and one vent is connected to a T connection on the box that you can unplug by twisting on the T. Take that T off and look inside where you unplugged the hose on this T. There is a spring and a little plunger inside this tube. The plunger gets stuck. I took a little screw driver and some PB blaster and worked that plunger back and forth a couple dozen times and it unfroze. Put it back together gassed up just fine. I did not look but I was told regulator can be replaced for 200$. But a can of blaster is cheaper.

May 27, 2009 | 2004 Nissan Sentra

2 Answers

Fuel gauge problem


sending unit on the fuel pump in the tank is stuck, and needs to be replaced. its expensive, but that will fix your issue. its the housing around the pump that has the float arm on it. you can try to free the float arm by removing your pump assembly, but cant guarantee its any good after being stuck

Mar 09, 2009 | 1996 Chevrolet K1500

Not finding what you are looking for?
2002 Chevrolet Impala Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...