Question about 1999 Plymouth Grand Voyager

1 Answer

I need to find the starter on a 1999 Plymouth Grand Voyager

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Plymouth Master
  • 752 Answers

Follow red positive cable wire from battery connected to starter..good luck

Posted on Feb 07, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1999 grand voyager clicks once but wont start. has done in past but usually after a few turns the motor starts again

Hi Chris, Try cleaning the battery terminal. You may need to remove them and clean oxidization from inside. If that does not work you may have a problem with the starter relay or starter motor. Regards John

Apr 23, 2012 | 1998 Plymouth Grand Voyager

1 Answer

I have a 1999 plymouth voyager with ignition problems . It will start and then it just clicks alot before starting . is the ignition switch pooched and if so how to replace

It is most likely the starter ,the starter has contacts in it,instead of brushes like the old days,they will do this when it is time to change the starter,not that this is a warning sign,but take it as one before it gets you stranded

May 26, 2010 | 1999 Plymouth Grand Voyager

1 Answer

1999 plymouth grand voyager speed sensors location

1999 Plymouth Truck Grand Voyager 2WD 3.8L MFI 6cyl
The Vehicle Speed Sensor is located Mounted on transmission
* The Sensor - Transmission Speed is located Mounted on transmission

Hope this help (remember comment and rated this).

Apr 20, 2010 | 1999 Plymouth Grand Voyager

1 Answer

We have a remote car starter, not sure what brand. We had a new battery installed and now we can't start the car with the remote anymore. We have a 1999 Plymouth Grand Voyager.

Have a remote car starter, new battery, but still will not work. Don't know the brand, believe it to be 9 yrs old and probably no longer in business. 66 yr old female

Jan 31, 2010 | 1999 Plymouth Grand Voyager

1 Answer

My van doesn't start

u need to read the codes, this is key to finding the root casue here, u can get them at most auto parts stores for less than $50, cheaper on ebay. You need a OBD 2 reader

Nov 20, 2009 | 1999 Plymouth Grand Voyager

2 Answers

Can you show me where the starter is located on a 1999 plymouth grand voyager

Take a look at the photo....

In this photo, it is the 3.0L engine. The starter is right next to the oil filter. There is a bracket there with an "X", to the left of it is the starter. Location is in the front, closest to the grill of the van. Same for the 3.8L and the 2.4L (it'll be close to the A/C compressor.).

Nov 01, 2009 | 1999 Plymouth Grand Voyager

1 Answer

Starter Motor Replacement

Try the website. Go there and register. It doesn't cost anything and will give you access to an online repair manual for your van. The procedures for changing the starter can be found there. Hope this helps and best wishes.

Aug 08, 2009 | 1999 Plymouth Grand Voyager

1 Answer

R&R Starter 1999 Plymouth Voyager w/3.3 V6

The likely problem is the contacts in the solenoid on the side of the starter. Does the solenoid click when trying to start the car? Disconnect one battery cable before doing anything with it. I fixed mine by removing the end of the solenoid case and building up the badly eroded input terminal bolt head with silver solder--worked great. You have to work under the car to get to these parts--use jack stands for safety.

Jul 16, 2009 | 1999 Plymouth Grand Voyager

Not finding what you are looking for?
1999 Plymouth Grand Voyager Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides