Question about 1996 Toyota RAV4

1 Answer

Motor has loss power/runs weak

Loss of power, spudering when changing gears, check engine light is blinking. dont know if it is a fouled spark plug or maybe the fuel pump/filter.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

It sounds like it could do with a good service, it could well be a fuel problem

Posted on Feb 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Weak power,shaking engine ,engine light blinking,even in neutral


The check engine light can come on for many different reasons. There is only ONE reason for it to flash or "blinking" because excess or un-burned fuel is going into the exhaust and WILL damage the catalitic converter. The weak power and engine shaking is because not all cylinders in the engine are working. Most common causes are tune-up related. If you have a spark plug that does not work ( creates a spark to ignite the fuel which makes the engine run) this unburned fuel will go into the exhaust where the catalitic converter is located.This unburned fuel will cause excessively high temperatures in the converter and Will damage it. The most common reasons for no spark at the plugs- worn or defective spark plugs, spark plug wires or ignition coil. Hope this helps

Nov 26, 2013 | 2004 Saab 9-3

1 Answer

1999 mercury cougar engine is bucking and check engine light blinking and foul odor


very possible convertor is plugged have local muffler shop check temp difference between convertor an exhaust ppipe also check fuel pressure

Jun 25, 2012 | 1999 Mercury Cougar

2 Answers

HELP Mustang engine power loss, rough idle, engine shake


I'm wondering if you could have a burnt exhaust valve cause by the exhaust leak in the cylinder where the exhaust leak was.

May 10, 2010 | 2001 Ford Mustang

2 Answers

Check engine light stays and blinks on a 2005 pontiac grand prix gtp and it also has vibrations as u drive


Sounds like it is misfiring.
Try changing the spark plugs and you MUST run premium fuel.

Dec 27, 2009 | 2005 Pontiac Grand Prix

1 Answer

My 1997 hyudai accent has a missfire code on cylinders 1 and 4 car has no power replaced plugs only change is the idle is much smoother. what else should i check


Main causes of misfire would be loss of spark; the air/fuel mixture is too far out of balance to ignite; or loss of compression.

Loss of spark includes anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. Causes include worn, fouled or damaged spark plugs, bad wires or even a cracked distributor cap. A weak coil or excessive rotor gas inside a distributor would affect all cylinders, not just a single cylinder.

"Lean misfire" can occur when the air/fuel mixture is too lean (not enough gasoline in the mixture) to burn. This can be caused by a dirty, clogged or inoperative fuel injector; air leaks; or low fuel pressure because of a weak pump, restricted filter or leaky pressure regulator.

Loss of compression means the cylinder loses most of its air/fuel mixture before it can be ignited. The most likely causes here are a leaky (burned) exhaust valve or a blown head gasket. If two adjacent cylinders are misfiring, it's likely the head gasket between them has failed. Also, if an engine is overheating or losing coolant, it's likely the head gasket is the culprit.

You can isolate the weak cylinder by temporarily disconnecting each of the spark plug wires, one at a time, while the engine is idling. When there's no change in the idle speed, then you have pinpointed the weak cylinder.

Aug 25, 2009 | 1997 Hyundai Accent

1 Answer

Engine light has come on and car is misfiring, loss of power, sounds rough


Main causes of misfire would be loss of spark; the air/fuel mixture is too far out of balance to ignite; or loss of compression.

Loss of spark includes anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. Causes include worn, fouled or damaged spark plugs, bad wires or even a cracked distributor cap. A weak coil or excessive rotor gas inside a distributor would affect all cylinders, not just a single cylinder.

"Lean misfire" can occur when the air/fuel mixture is too lean (not enough gasoline in the mixture) to burn. This can be caused by a dirty, clogged or inoperative fuel injector; air leaks; or low fuel pressure because of a weak pump, restricted filter or leaky pressure regulator.

Loss of compression means the cylinder loses most of its air/fuel mixture before it can be ignited. The most likely causes here are a leaky (burned) exhaust valve or a blown head gasket. If two adjacent cylinders are misfiring, it's likely the head gasket between them has failed. Also, if an engine is overheating or losing coolant, it's likely the head gasket is the culprit.

You can isolate the weak cylinder by temporarily disconnecting each of the spark plug wires, one at a time, while the engine is idling. When there's no change in the idle speed, then you have pinpointed the weak cylinder.

Aug 25, 2009 | 2001 Ford Focus

2 Answers

What causes a misfire on a 99 pontiac grand am if spark plugs or good and the car does not have wires


here are the common causes of a missfire, defective ignition coil or ignition coil wiring for that cylinder, defective fuel injector, defective powertrain control module, intake manifold vacuum leak, low cylinder compression.

Aug 24, 2009 | 1999 Pontiac Grand Am GT

1 Answer

Engine light is blinking and it runs very rough/low power in gear.


Check the coil pack. Same symptoms on mine. It went at 74,000.
You can get the resistance specs from a shop manual. I have been told the plastic engine cover traps heat and makes short life of the coil pack. I removed the top engin cover, cosmetic only after replacing mine. You will probably need spark plugs also they are probably fowled by now. If you have not changed spark plug wires in awhile in would not hurt.

Apr 22, 2009 | 2001 Hyundai Elantra

1 Answer

Car spudered and die know it won't start


1 Inspect Battery Damaged or faulty battery and/or connections. 2 Inspect Coil - Ignition Damaged or faulty ignition coil or ignition coil circuit. 3 Inspect Fuel Filter Clogged or dirty fuel filter 4 Inspect Fuel Injector Pressure Regulator Faulty fuel injector pressure regulator or circuit. 5 Inspect Fuel Pump Improperly functioning fuel pump or circuits. 6 Inspect Wireset Damaged, worn, or deteriorating spark plug or coil wire(s). 7 Inspect Control Module-Ignition Faulty ignition control module or circuit. 8 Inspect Solenoid Switch Damaged or faulty solenoid switch or solenoid switch circuit. 9 Inspect Starter Damaged, worn, defective, or faulty starter or starter related circuit. 10 Inspect Neutral Safety Switch Damaged or faulty neutral safety swittch or circuit. 11 Inspect Fuse Corroded, burned, or shorted fuse may be interupting power source. 12 Inspect Fusible Link Corroded, burned, or shorted fusible link may be interupting power source. 13 Inspect Battery Cable Corroded, broken or poorly connected battery cable. 14 Inspect Spark Plug Wire Loom - Performance Improperly adjusted or worn/malfunctioning carburetor. 15 Inspect Distributor Cap Loose or cracked distributor cap 16 Inspect Distributor Cap And Rotor Kit Loose, cracked, or worn distributor cap and ignition rotor. 17 Inspect Fuel System Pressure Incorrect fuel pressure being delivered to carburetor or fuel injection system. 18 Inspect Fuel Injector Plugged, dirty or poorly connected fuel injector. 19 Inspect Ignition Switch Worn, damaged or faulty ignition switch or circuit. 20 Inspect Spark Plug Fouled, damaged or broken spark plug(s). 21 Inspect Belt Incorrectly routed, adjusted(tensioned), missing or worn drive belt(s). 22 Inspect Timing Belt Slipped or broken timing belt. 23 Inspect Timing Set Slipped timing chain or worn timing gear(s). 24 Inspect Fuel Tank Contaminated fuel from rusted or deteriorated fuel tank. 25 Inspect Ignition Timing Incorrectly adjusted engine timing.

Dec 08, 2008 | 1995 Buick Park Avenue

3 Answers

96 dodge neon, Loss of power, check engine light


check your fuel pressure, should be 40lbs+ at idle. If you dont know how to do this, have a friend or a shop check it for you. I had same problem, no power at all would barely run ect,, turned out to be fuel pump.

Nov 14, 2008 | 1996 Dodge Neon

Not finding what you are looking for?
1996 Toyota RAV4 Logo

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...