Question about 2005 Scion xA

1 Answer

Too tall how can i lower so its not in the way? please.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Learn to speak english

Posted on Mar 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I can't free tire from the cable. How to do?


Get a couple blocks about 6 to 8 inches tall. Lower your spare down with the blocks under the tire part. then you can reach under the tire pull the holding bracket down enough to turn it sideways and push it thru the hole in the wheel.

May 14, 2011 | 2007 Chevrolet Avalanche LTZ

2 Answers

Which way does the thermostat install tall end to engine or to radiator


The spring will always go towards the motor on any vehicle. This allows the lower temperature coolant from the radiator to enter the motor before it enters the heater.

Sep 29, 2010 | Toyota Camry Cars & Trucks

1 Answer

My 1994 civic dx has an ex gage cluster and the speedometer is off by 10-15 mph how would I correct this and keep the gage cluster it says my tire size should be 175 70r13 but I have 185 60r14 which is the...


okay,lets go to basics...1/.175 is the width of the tyre.2/.70 is the profile(that is 70mm from the wheel rim to the road).3/.13 is the width of the wheel rim.
So,you have 185(wider tread)60 (lower profile)14"(bigger wheels).you need to fit 35 profile tyres to get close to the same rolling radius to correct the speedo,the ride will be harder and the tyres are much more expensive,alternatively fit 13" wheels/tyres.
70/13 radius is the same circumferance as 45/14(25mm thinner).
simply put,if you measure the original wheel, road to top of tyre,then measure the ones fitted you are an inch to tall or 3.1/2" more around (approximately)please leave feedback...ta
geoff.

Aug 09, 2010 | Honda Civic Cars & Trucks

1 Answer

I have a 1988 Toyota Hilux V6 3.0L 4X4 that I need a radiator for. Toyota no longer has this part. All the parts houses have a replacement but they all are too tall and hit the hood. Any idea if anyone...


what you have to do is move the lower mounts down to make the aftermarket radiators fit!! it's been done a lot and really not that hard to do

Jan 17, 2010 | 1988 Toyota Pickup

1 Answer

Can 165 70 13 tyres be used to replace 175 75 13 on a 1998 lancer


It's OK is you do it in pair.

10 mm tailer and 5 mm wider is not so bad.


Please do this swap in pair.

Keep tall (1st send of number) tire in rear.

Please rate my answer if it's useful to you.

Cheers,


Mustgo.

Dec 13, 2009 | Mitsubishi Lancer Cars & Trucks

1 Answer

Where is the fuel filter located on a '94 camry?


On both engine models, the fuel filter is mounted on the drivers side frame rail, just below the aircleaner box.
It is a vertical mounted cylinder, black, about 4 inches tall. The lower fitting is a 14mm flare nut, the top fitting is a 17mm banjo bolt.

Oct 17, 2009 | 1991 Toyota Camry

1 Answer

Can't identify indicator light on instrument cluster


You have a manual transmission. The car is telling you to up shift.

May 17, 2009 | 1993 Saturn SL2

2 Answers

LOST BATTERY


It's under the rear seat on the right side of the car. Pull the two phillips screws at the front lower edge of the rear seat bench and lift the seat out from the front edge and then out. The battery is held down with a 13mm bolt and tall bracket. Cables are 10mm nuts.

Apr 19, 2009 | 1996 Audi A6

2 Answers

Car


Dariux-

There should be a VIN plate at the very front edge of the dashboard where the bottom of the windshield intersects on the driver's side. Look staight down through the lower edge of the windshield on the driver's side with a flashlight (in the defroster vent area) for a metal plate about 1/2" tall and 3" across with the VIN stamped or embossed into it. The number should also be found somewhere inside the driver side door, and it is also stamped somewhere on the engine block... look for a machined-flat protruding surface with number/letters stamped into it along the oil pan line.

Hope this helps and best of luck! Don't hesitate to ask for further assitance or post a comment...

Tanks!
-WildBill

Jun 17, 2008 | 1993 Honda Prelude

Not finding what you are looking for?
2005 Scion xA Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Scion Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Brad Brown

Level 3 Expert

16026 Answers

Are you a Scion Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...