Question about 2005 Cadillac CTS

1 Answer

Where is the location on oil pressure sensor on 05 cts 3.6

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,049 Answers

The sensor/sender is easily replaced. It is located on the horizontal surface of the "V" of the block at the rear of the intake manifold on the driver's side. R&R requires a deep-socket about 1 1/16" or so.

Posted on Feb 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil pressure censor located on a cadillac cts 2007 3.6


Engine Oil Pressure (EOP) Sensor (LP1/LY7)
In the engine compartment, on the left side of the engine, in the oil filter housing
Engine Oil Pressure (EOP) Sensor (LS2)
In the engine compartment, on the top, rear, center of the engine

Jan 10, 2016 | Cadillac Cars & Trucks

1 Answer

Where is the back knock sensor located on a 05 impala 3.4L. I already found the one in the front.


there is only one on that motor. there are 2 oil pressure sensor on the motor,but there is only 1 knock sensor

Dec 06, 2012 | 2004 Chevrolet Impala

1 Answer

My oil pressure sensore keeps going off


If you mean the low pressure warning on the cluster, is the oil pressure dropping below normal range ?
You may need to have the oil pressure sensor replaced or have the oil pressure checked with a mechanical gauge.

Aug 08, 2012 | 2005 Cadillac CTS

1 Answer

WHERE IS THE CRANK SHAFT SENSOR LOCATED ON A 2003 cts cadilac


The sensor itself is located under the car right behind the oil filter. It is connected on top of the motor right by the fire wall. You will need an E8 torx socket to get it out but it's a very easy replacement.

May 08, 2010 | 2003 Cadillac CTS

1 Answer

Where is the oil sending unit on a 1996 ford taurus 3.0 liter engine located? glenn


On 3.0L OHV engines, the oil pressure sensor is located on the left side of the engine block above the flywheel. On 3.0L DOHC engines the sensor is located on the left side of the engine block above the oil filter. On 3.4L DOHC engines the sensor is screwed into the oil filter adapter. The oil pressure sensor operates the oil pressure warning lamp.

71f6e37.jpg
Fig. 1: Location of the oil pressure sensor-3.0L OHV engines


046f42b.jpg Fig. 2: Location of the oil pressure sensor-3.0L DOHC engines

69cce3e.jpg

Fig. 3. The oil pressure sensor-3.0L OHV engine

Hope help with this (remember rated this help). Good luck.

Feb 18, 2010 | 1996 Ford Taurus

2 Answers

Crankshaft sensor



Crankshaft sensor is Located on the side of the block by the oil filter,

Hope this tip helps.

r/
David

Jan 24, 2010 | 2006 Cadillac CTS

1 Answer

05 Cadillac will not start after spinning out on interstate.


there is an oil pressure switch that shuts the fuel off if the key is on and the engine has no pressure. the switch is useally located near the oil filter on the block, this is not a common problem so it is unlikely it is your cause of no fuel pressure.

Aug 10, 2009 | 2005 Cadillac CTS

2 Answers

WHERE IS THE IPR LOCATED ON THE ENGINE ?


The "IPR" is and Injector Pressure Regulator. It is a Solenoid used to control the oil pressure created by the High Pressure Oil Pump. The IPR is capable of regulating oil pressure from 0 to 5000 psi. On an 05 6.0l the IPR is located in rear, top, center of the engine in the High pressure oil pump. It can be identified by its gold color. It sticks out of the side of the pump pointing toward the driver side of the truck. It has a 2 wire plug that is held on by a metal clip. usually the ipr and plug are protected in a heat shield so you may not be able to see it right away. Some people mistake and IPR for and ICP. The ICP is a sensor that tells the PCM what the High oil pressure is. ICP stands for Injector Control Pressure. This sensor is located in the passenger side valve cover on and 04, 05 6.0l and in the top of the High pressure oil pump on an 03 6.0l.

Nov 06, 2008 | 2006 Ford F-250 Super Duty

Not finding what you are looking for?
2005 Cadillac CTS Logo

496 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...