Question about 2000 Ford Expedition

1 Answer

The back air shock is not lifting the frame up but the compreeser runs

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Get a windex spray bottle and spray the air bag to see if bubbles appear. if so it leaks

Posted on Feb 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Our air suspension on our 2007 Mercedes r350 have stopped lifting


Your air pump or air shocks may have quit working. Mine would run but the shocks had an air leak. I had to get new air shocks and yes the air pump was shot so I replaced the air shocks and installed an air line below the license plate. I pump them up with my air compressor about every three months. The pump was too expensive for me.

Jun 06, 2017 | Mercedes-Benz Cars & Trucks

2 Answers

Astro van suspension


What the back is to low or left and right side not even if you whant to lift the rear suspension air shocks

Apr 05, 2012 | 1998 Chevrolet Astro Van

1 Answer

The back suspenion is lower and its not level with the front does it have air shocks that raises the back or does it have regular shocks on the back or maybe air shocks. P.S. its a 2000 ford expedition...


Not an expert here, but my buddy had the same problem till i looked underneath and saw the leaf spring end bracket rusted off, and holding onto the frame by a tiny screw. this is common on fords. pls check.

Aug 03, 2011 | 2000 Ford Expedition

2 Answers

I WOULD LIKE TO RAISE MY 2000 MERCURY MARQUIS BY FOUR INCHES, IS THIS EASY TO DO


Hello, Here is what you might try. First, go to DiscountTire.com and look at their tire comparison features on the Website. You will see "tools" that show what size tires will fit on your rims and what extra size rims will fit under your wheelwells. There is also a speed calculator for using the larger size tires over stock and it will show speedometer error if you do not recalibrate the speedo.

Next would be using spacers on the bottom of the springs or having longer springs refitted to your car. Finally air shocks front and back will give you some lift. The Grand Marquis can have rear air suspension, but to use it like you want, you will need to reconfigure the pump and change limit switches.

If you do all of this, you may reach your 4" lift. Your ride quality once you start changing springs and limiting travel in the suspension will probably deteriorate. As your car is a body on frame design, you may be able to put spacers of 1/2" to 1" under the body to frame mounts. You would need to make up the distance for the steering shaft, A/C lines and possibly hoses throughout.

In general, an inch from the tires, two inches from the springs or air shocks, and the balance from body on frame spacing.

I changed from the low 60 Series tires to a 65 Series tire on my own Grand Marquis. You can get a 70 Series to fit. I looked at Police car tires and they used 60 Series. But going back to 1994 Models, the 70 Series tire was available from the factory.

I hope my solution is very helpful to you in deciding what you to do.

Apr 22, 2011 | 2000 Mercury Grand Marquis

1 Answer

How to level cadillac


did you blow your back air shocks there should be a switch in trunk to reset air shocks when you lift your car make sure you turn this switch off if you dont you could blow your air shocks there not cheap to fix unsure the exact price

Feb 22, 2011 | Cadillac DTS Cars & Trucks

1 Answer

How to remove bottom of back seat need to remove seat to remove rear shocks..


PUSH IN CENTER FRONT EDGE CUSHION TO DISENGAGE PART OF SEATS WIRE FRAME FROM CLIPS.WITH CLIPS UNHOOKED LIFT UP AND REMOVE SEAT.IF REAR SEAT NOT HELD IN PLACE WITH CLIPS. LIFT UP THE REAR SEAT CUSHION AND PIVOT IT FORWARD. DETACH THE RETAINING BOLTS AT THE LOWER EDGE OF THE SEAT BACK AND IF NECESSARY REMOVE THE SEAT BELT ANCHOR BOLTS.LIFT UP ON SEAT BACK REMOVE IT..

Feb 06, 2011 | Jaguar X-Type Cars & Trucks

1 Answer

Have a 94 p/u toyota v6 ext. cab long bed. would like to know how to replace front shocks and brand that will add more lift..Chris


A lift kit is something other than new shocks. Google Toyota pickup lift kits. As far as replacing the shocks there is a single stud on the top of the shock and 2 bolts on the bottom that secure it to the truck frame. You'll need to raise the truck some and remove the tires to have room to work. This also is a "generic" process and you can probably find basic info using a search engine or even a video at youtube, etc.

Sep 09, 2010 | 1994 Toyota Pickup

1 Answer

I cannot put any weight in the back of my car because on the passenger back side it is not lifting the car so that the tire wont rub the inside of the panel the air lift system is kick in


You have air shocks on this and the one may have a blown seal or air line causing the shock not to inflate. I would have this looked at at a tire shop. Have them put it on a lift to find the problem. They may not charge you for this.
Shastalaker7

Mar 25, 2010 | 2001 Oldsmobile Aurora

1 Answer

How to remove rear shocks in my 1997 ford eplorer


There should be 2 bolts in a bow-tie shaped braket on the top of the shock, with a nut on the other side, through the frame. There should be one large bolt and nut on the bottom of the shock, through a braket on the rear axle.

Lift the vehicle up by the frame on both sides, so that the axle is dangling underneath the vehicle, and the shocks should be very easy to remove and reinstall.

Nov 20, 2009 | 1997 Ford Explorer AWD

1 Answer

No back air in shocks


you probably need a comp . ck relay under pass side frt frame behind bumper replacing these pieces should ix your problem

Jan 14, 2009 | 2001 Ford Expedition

Not finding what you are looking for?
2000 Ford Expedition Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...