Question about 2000 Lincoln Navigator

1 Answer

Sparkplugs - 2000 Lincoln Navigator

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 617 Answers

Your spark plus are in valve covers under the coil packs, remove each coil pack and then each spark plug, 4 on each side.

Posted on Feb 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes air to seep around the spark plugs on a 2002 Chrysler voyager


Loose sparkplug
cross threaded sparkplug
over compressed washer on sparkplug
worn threads in the head

Just put new ones in. Start them by hand and turn using a sparkplug socket and extension bar until tight. Add the ratchet bar or T-Bar and tighten a further one eighth turn.

Jan 10, 2016 | Chrysler Cars & Trucks

1 Answer

Changing plugs , is there any parts that have to be removed before you take plug sout?


Sometimes a plastic cover needs to be removed. Otherwise it's just unplugging the sparkplug caps and insert the sparkplug tool to loosen the sparkplug. Make sure nothing falls into the open sparkplug hole once it's out.

Jun 30, 2011 | Hyundai Accent Cars & Trucks

1 Answer

Cylinder 3 misfire


Check ignition lead - ignition cap and sparkplug. look signs of wear or cuts on the lead. The cap should be tight on the sparkplug. The sparkplug must be free of cracks and not unusually blacked out. Replace if in doubt.

Quick test is to open the hood in the dark. Let someone start the car and look for blue sparks around the lead and sparkplug cap. Be careful - keep away from moving parts.

Jun 30, 2011 | 2004 Ford Freestar

1 Answer

Diagnostic states 3rd cylinder mis fire


Hello, Depending on the Year of the car, the cars that had a sparkplug with a remote coil, you could have a bad sparkplug wire or a bad coil-pack or a bad sparkplug. For newer cars, the coil is attached to the sparkplug directly on top.

For those newer designs, the coil would need to be tested for that cylinder. Using an Ohmmeter, with 1 lead on top and the other on the tip which touches the sparkplug, it is a 10,000Ohm resistance.

Accessing the sparkplug coil is different for several engines. You may have to remove the Intake manifold to reach the coil and you may need to remove part of the fuel rail to remove the Intake manifold. Switching out a plug or coil is easy once you can get to it.

You can have your scans done free at Autozone, Oreillys, or Advance autoparts and they will clear the problem codes once you replace parts. I hope this Solution is very helpful to you.

Jun 18, 2011 | Mercury Marquis Cars & Trucks

1 Answer

Can someone tell me how can I replace the spark plugs on Dodge Caravan 2005, from above?


Open the hood to access the engine compartment. Locate the sparkplugs sitting to the side of the motor. Six wires run to the motor, three on each side.

Twist the rubber boot and pull away from the sparkplugs. This will expose the sparkplug.

Unbolt the sparkplug with a socket wrench. Use a 5/8-inch deep-well socket attached to the socket wrench.

Pull the sparkplug away from the motor. Discard the sparkplug.

Screw the sparkplug into the motor by hand. Make sure it is hand-tight.

Tighten the sparkplug with the socket wrench, using the deep-well sparkplug socket.

Click the wire to the sparkplug wire to the end of the sparkplug. Gently pull the wire to ensure it clicks into place.

Repeat the procedure for the remaining five sparkplugs. Change each sparkplug one at a time.

Aug 24, 2010 | Dodge Grand Caravan Cars & Trucks

1 Answer

How do I get the spark plugs out of my 1998 ford escort to replace with new ones? Also where does the pcp Valve go?


With you hood open and you are standing in front of the car sparkplug wires need to be removed,i suggest you remove them one at a time, under each wire the sparkplug is threaded into the cylinder head,using a 5/8 sparkplug socket remove the sparkplug and replace it with new properly gapped sparkplug.Note:if you remove all sparkplug wires at once the factory wires are generally numbered 1 2 3 4 the sparkplug closesed to the passenger fender is #1 and the one clossesed to the driver's fender is #4.Standing in front of vehicle the PCV Valve is located between #3 and #4 on the backside(intake side) of the engine fitted down into a rubber hose

Jul 17, 2010 | 1998 Ford Escort

1 Answer

Sparkplugs need replaced


Here are some instructions:

1. open hood
2. disconect battery
3. remove sparkplugs cable
3. use a torque ranch to remove sparkplugs (turn to left)
4. replace with new sparkplugs
5. connect cables
6. connect battery

Start car and check for missfires

Good luck!!!

Dec 29, 2009 | 2000 Mitsubishi Montero Sport

1 Answer

I HAD #3 SPARK PLUG BLOW OUT OF CYLINDER. HAD IT REPAIRED AND ALL NEW PLUGS, FUEL FILTERAND PCV PUT IN NOW TRUCK HAS A VERY FAINT ROUGH IDLE. ANY IDEAS


#3 sparkplug is not firing at peak performance.
The engine block sparkplug hole had to be re-threaded in order to accept an adapter for the replacement spark plug. The sparkplug is sitting "higher" in the cylinder than the others (not as efficient).
It may even be a different sparkplug altogether in order to accommodate the adapter.

Add a silicone insulator gel (AutoZone $2) inside both boot ends of the sparkplug wires and re-seat them all.

Oct 01, 2009 | 2004 Ford Expedition

1 Answer

Its the only sparkplug i have managed to find here in philippines that fits my engine, just wat to know if is suited for my car before i have to look abroad


get on the net to find out more,NGK, Nippondenso,or Bosch will be fine usually higher price better longer lasting plug,i dont think theres any major advantage

Apr 21, 2009 | Subaru Impreza WRX STi Cars & Trucks

Not finding what you are looking for?
2000 Lincoln Navigator Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

fordexpert

Level 3 Expert

5467 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...