Question about 1999 Dodge Ram

1 Answer

Why do you have to pull the distributor to install the pick up coil on a 1999 dodge ram 5.2

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 474 Answers

You probably have to remove the shaft that runs through the distributor that turns the rotor.

Posted on Feb 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Change the ignition coil and still no fire what else could it be


The pick up inside the distributor could be bad, but I'm thinking the crank sensor could be the problem, https://www.youtube.com/watch?v=h0mqbJsYzBc check out this.

May 02, 2014 | 1999 Dodge Ram

1 Answer

1988 dodge ram 50 coil wiring diagram


huh? a toyota/dodge frankenRam.??? what?

Problem with 1999 Toyota RAV4 1988 dodge ram 50 coil wiring diagram ive no idea what you have now. but
you can login to alldata.com and read all that, IT'S THERE.

Jan 21, 2014 | 1999 Toyota RAV4

1 Answer

I have a 1999 ram 2500 with a 360 gas engine 70,000 miles. Driving down road quit. Spark at coil none at plugs, pulled dist cap rotor NOT turning when we rolled engine over with starter. Pulled distributor...


Something has sheared. Is there a pin on the distributor drive gear, are the gears on the cam and dist. shaft perfect / no flat spots at all, is there a keyway or key on the crank or cam gears that has sheared? Must be a weak point that was slipping somewhere.

Sep 26, 2010 | 1999 Dodge Ram

1 Answer

Where is the pickup coil located on 1997 dodge ram


he pick-up coil/stator assembly is located under the distributor cap, and once the distributor cap is removed from the distributor, just remove the ignition rotor, and then simply un-plug the wire connector to the the pick-up coil/stator and then lift it straight up and away from the distributor, and when re-installing the pick-up coil/stator be sure to align the square tab and the rounded tab on the pick-up coil/stator to match with the distributor housing and with the distributor cap and install the ignition rotor and the distributor cap, and then re-connect the wire connector to the pick-up coil/stator.


2ab64f0.jpg

Sep 24, 2010 | 1997 Dodge Ram

2 Answers

How hard is it to install pickup coil in the distributor of a 2001 dodge ram 1500 pickup.


The pick-up coil/stator is easily replaced in a dodge distributor, and once you have removed the distributor cap and the ignition rotor, then just dis-connect the wire connector from the pick-up coil/stator and lift it straight up and out of the distributor, and the distributor does not have to be removed or dis-assembled to replace the pick-up coil/stator. There are two alignment tabs on the pick-up coil/stator that will match up with the distributor cap when the pick-up coil/stator is properly installed. Here are two images to help assist you.


4dd8fcb.jpg

f270266.jpg

Jun 29, 2010 | Dodge Ram Pickup 1500 Cars & Trucks

2 Answers

1991 dakota intermittently stalls or will not start after being run for 30 minutes or more of running.


When it does this you need to check if you have voltage ( spark ) going to the end of the spark plug wire, but it sound to me like your pick up coil is going bad, pick up coil sit under the distributor cap under the distributor rotor same size as distributor assembly ( black ) cheap$$, good luck, hope this was very helpful.

May 14, 2010 | 1991 Dodge Dakota

1 Answer

I have a 1991 Dodge Ram pick-up and I cannot get spark. Can you help?


ck for the pick up coil working.unplug pick up coil remove wire from ignition coil to dist lay coil wire still connected to coil about 1/2 inch from ground turn key on take a jumper wire and jump the wires on the engine harness side of the connector if it has a spark replace the pick up coil in the distributor

Jan 01, 2010 | 1999 Dodge Ram

1 Answer

It just stopped firing out of no were no spark to the coil


pick up coil under distributor cap is bad

Jul 29, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
1999 Dodge Ram Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...