Question about 1995 Nissan Maxima

1 Answer

Key will not turn to start car, after replacing starter.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Contributor
  • 435 Answers

You have miss a connection ,check is the wire coming to the solenoid is connected.

Posted on Feb 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2005 GMC Envoy XL. Will not engage starter. Like something electrical. Turn key and nothing. Worked fine until now.


Could be the neutral safety switch if it won't crank in neutral or park, could also be the starter has failed.

Feb 22, 2015 | 2005 GMC Envoy Xl

1 Answer

Replaced ignition switch, key, battery and now car wont start after running then it will start up hours later..is it the starter?


When key is turned the starter is energized by a solenoid that applies power directly from the battery to the starter. Any loose connection will prevent the starter from turning over. The solenoid can also have burnt spots on the contacts inside case that will prevent current from getting to the starter. A click noise is the solenoid energizing so
if all connections are tight and the battery is good the only
other problem is the starter may be bad. Brushes on the
starter may have seen their life ended. this is usually identified by tapping on starter with a hammer while trying to start engine. If starter spins, replacement is needed.

Feb 06, 2018 | 2000 Saturn SL

1 Answer

Ford Ka starter motor won't start but makes whirring sound. It usually takes 3 turns of the iginition to start


Sounds like the solenoid is bad on the starter..Starter probably needs replacing.

Feb 23, 2013 | Cars & Trucks

1 Answer

Car won't start . Clicking noise wen key is turned


It's your starter. Find location of your starter. By the flywheel. Then. Bang on it . Your car will start. You still need to replace the starter.

Dec 08, 2011 | 2004 Honda Accord

1 Answer

I have a 2006 ford escape. When I turn the key to start the vehicle, it did not start. All my power is on but no clicking sound when I turn the key to start the car. Is it my starter or something else?


Safely secure the parking brake put a 12 Volt test light on the starter wires at the starter have someone help you by turning the key to the start position , if the test light lights replace the starter , if the test light don't light check your fuse if it is good replace the relay .

Oct 12, 2011 | 2006 Ford Escape

1 Answer

My car would not start thought it was the battery, replaced battery for new, car will not turn no sound at all.


Now you must check the starter. The large cable going to the starter supplies 12+ volts. The small wire supplies 12 volts when the key is turned to the start position. Using a volt meter or 12V test light check for voltage at the small wire when the key is turned to start. If 12 volts are now present and your engine grounds are good then the starter is bad. You can try to bamg on the starter with a broom stick while someone turns the key to start. sometimes this will get the starter moving again. but not for long. starter replacement will be required.

If 12 volts is not present at the small wire when turning the key then you may suspect a blown fuse, fusible link, bad starter relay, neutral or clutch safety switch, or faulty ignition switch.

Sep 25, 2011 | 1999 Nissan Altima

3 Answers

Security on. car wont crank. can trun key wont


verify that you have a fully charge battery and that you have the same amount of voltage at the battery as at the starter when the key is turned to the start position. If not repair fault at positive cable either at battery or at starter. If voltage checks good. Use a remote starter and turn key to the on position and try to crank over engine with remote starter. if engine cranks over. You have a defective starter solenoid and starter must be replaced.

Mar 26, 2010 | 1997 Infiniti.5 Q45

2 Answers

1995 BMW 525i. Car will not start or turn over. Have lights battery is strong, replaced starter, starter was tested, and worked. When ignition is turned dash lights up but starter does not engage. Have...


I had the same problem, after having the car towed to four Seasons, it was discovered that the electrical portion of the ignition switch was defective. Works like a charm. Part number 61 32 8 356 026 Hope this will help.

Feb 06, 2010 | 1995 BMW 5 Series

1 Answer

Trouble starting


Your starter contacts are bad. You have 2 options: Replace the starter assembly, or remove the starter & replace the internal solenoid contacts & the solenoid plunger. This is a common problem with Toyota starters; I replace contacts 3-4 times a week.

Aug 30, 2008 | 2002 Toyota MR2 Spyder

Not finding what you are looking for?
1995 Nissan Maxima Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...