Question about 1990 Volvo 740

1 Answer

Driver seat belt broken is it a repair I can make

Driver seat belt is broken. Is it a repair I can make the buckle wont click into place.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 474 Answers

Try and see if anything feel into the buckle and posibly it needs to be lubricated with WD40 or somthing like it.

Posted on Feb 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heated and cooled seat on 2004 expedition stopped working how to reset them


Heating and the cooling both don't work ? Just one seat or all seats ?
Your best bet have it checked for DTC'S - diagnostic trouble codes to start .
Climate Controlled Seat Module (CCSM) Diagnostic Trouble Code (DTC) Index DTC Description Source Action B1342 ECU Is Faulted CCSM INSTALL a new CCSM and CARRY OUT programmable module installation (PMI). REFER to Climate Controlled Seat Module . B1358 Ignition Switch or Blower Electronics Circuit Short to Ground CCSM Go To Pinpoint Test Q . B2477 Module Configuration Error CCSM This DTC indicates programmable module installation (PMI) has not been done to a newly installed module. CARRY OUT PMI. REFER to Section 418-01 . CLEAR the DTC. CARRY OUT the self-test. B2486 Climate Controlled Seat Module Voltage Out of Range CCSM DEPOWER the supplemental restraint system (SRS). REFER to Section 501-20B . DISCONNECT driver safety belt buckle pretensioner electrical connector or passenger safety belt buckle pretensioner electrical connector of the affected seat and CONNECT restraint system diagnostic tool 418-F395 to the safety belt buckle pretensioner harness connector. CONNECT the battery ground cable. CHECK circuit 294 (WH/LB) for a fault. REPAIR as needed. If okay, REFER to Section 414-01 . Once the repair is complete, DISCONNECT the restraint system diagnostic tool from the safety belt buckle pretensioner harness connector and CONNECT the safety belt buckle pretensioner connector of the affected seat. REPOWER the SRS. REFER to Section 501-20B . B2488 Thumbwheel Switch Voltage Out of Range High CCSM Go To Pinpoint Test R . B2521 Tach Circuit Failure CCSM Go To Pinpoint Test Q . B2729 Cushion Over-Temp Detected CCSM Go To Pinpoint Test S . B2730 Back Over-Temp Detected CCSM Go To Pinpoint Test S . B2731 Differential Temperature Fault CCSM Go To Pinpoint Test S . B2792 Heat Switch Short to Ground CCSM NOTE: If HEAT is pressed for greater than 20 seconds on the climate controlled seat switch, DTC B2792 will set in the CCSM.
CLEAR the DTC. If the DTC does not clear, DEPOWER the supplemental restraint system (SRS). REFER to Section 501-20B . DISCONNECT driver safety belt buckle pretensioner electrical connector or passenger safety belt buckle pretensioner electrical connector of the affected seat and CONNECT restraint system diagnostic tool 418-F395 to the safety belt buckle pretensioner harness connector. CONNECT the battery ground cable. CHECK circuit 1551 (VT/WH) for a short to ground. REPAIR as needed. If okay, INSTALL a new climate controlled seat switch. Once the repair is complete, DISCONNECT the restraint system diagnostic tool from the safety belt buckle pretensioner harness connector and CONNECT the safety belt buckle pretensioner connector of the affected seat. REPOWER the SRS. REFER to Section 501-20B . B2793 Cool Switch Short to Ground CCSM NOTE: If COOL is pressed for greater than 20 seconds on the climate controlled seat switch, DTC B2793 will set in the CCSM.
CLEAR the DTC. If the DTC does not clear, DEPOWER the supplemental restraint system (SRS). REFER to Section 501-20B . DISCONNECT driver safety belt buckle pretensioner electrical connector or passenger safety belt buckle pretensioner electrical connector of the affected seat and CONNECT restraint system diagnostic tool 418-F395 to the safety belt buckle pretensioner harness connector. CONNECT the battery ground cable. CHECK circuit 1550 (WH/OG) for a short to ground. REPAIR as needed. If okay, INSTALL a new climate controlled seat switch. Once the repair is complete, DISCONNECT the restraint system diagnostic tool from the safety belt buckle pretensioner harness connector and CONNECT the safety belt buckle pretensioner connector of the affected seat. REPOWER the SRS. REFER to Section 501-20B . U2362 UBP Invalid Data Node ID CCSM NOTE: DTC U2362 indicates a network concern, the CCSM is not the source of the fault.
CLEAR the DTC. If the DTC does not clear, REFER Section 418-01 .

Nov 26, 2016 | 2004 Ford Expedition

1 Answer

Seat belt sensor goes on and off as your driving with all seat belts on


Look for garbage in the drivers seat buckle.

Make sure there is no heavy weight in the passenger seat.

You likely need a seat buckle, but could be wiring.

Dec 29, 2014 | 2008 Chevrolet Uplander

1 Answer

Air bag light flashes 5 times then 1 time


That flashing indicates fault code 51. Fault code 51 indicates a problem with the driver's seat belt circuit. The seat belt buckle has a switch in it to determine if the belt is buckled up when the seat is occupied [determined by a pressure sensor in the seat bottom]. The switch in the buckle is either bad or the wiring to the switch is either short or open circuited.
Use of a computer scan tool can help narrow down the problem. There are four different scan tool fault codes relating to code 51. They are B2432, B2433, B2434 & B2435. These codes will give you more defined information on the actual fault. Most common faults are either a bad switch in the seat belt buckle or damaged wiring to that switch. Damaged wiring is usually caused by the driver placing objects under the driver's seat, which damage the wiring coming out of the seat belt. It is also possible to have a bad seat belt computer [Restraints Control Module or RCM]. A bad RCM is not common. Check for damage to the seat belt wiring under the driver's seat. Best to remove the seat and lift up the carpeting to do this. If no physical damage or water corrosion damage is present, replace the seat belt. After repairs, disconnect the battery for 1 minute to clear the fault code from the RCM's memory.

Aug 27, 2014 | 2003 Ford Crown Victoria

1 Answer

Seat belt


if it wont undo from the buckle you will have to unbolt the belt at its anchor points and take to a garage to see if the buckle can be repaired or just put a new one in

Jul 08, 2014 | 1990 Honda Prelude

1 Answer

Broken seat belt buckle


If I had the problem I would look at a junkyard or on line at e-bay for a replacement. You will need to get the buckle and the belt that it is attached to that goes down to the floor down through the crack in the seat.
Remember the buckle receiver is made for the certain belt in the front and rear seats. I have often tried to put the wrong belt in a buckle and it would not fit. ( Example: the right belt goes in the right buckle.)
Be blessed.

Nov 08, 2013 | 2002 Nissan Xterra

1 Answer

Changing a seat belt buckle


The buckles are placed on the belts and then they are sewn so that you cannot remove the buckles.. You will have to replace belt and buckle as a unit. murf427

Aug 03, 2012 | 1998 Oldsmobile Intrigue

1 Answer

Srs light is on but everything is working..


Known problem for SRS light might be cause by bad seat belt buckle. Honda seat belt buckle and belts are lifetime warranty(not cover if broken because of abuse). Have your honda dealer scan it for code. They might charge you $55 to scan for the code(ex:09-3 driver seat buckle failure), but if it is a for buckle or belt code then everything is free including the scan(labor and part).
good luck

Dec 15, 2010 | 2002 Honda Accord

1 Answer

Driver side seat belt buckle is shorted 2004 VW beetle.looking for info on repair/replace


my seat belt/airbag light on...daeler told me I need a new drivers side buckle...approx 370 to repair!!!! light was on before they repaired, recall i guess, then 2 weeks later this happend

Feb 03, 2010 | 2004 Volkswagen Beetle

1 Answer

My seat belt light stays on in my BMW Z4. Is there a solution to this.


The contact in your seat belt buckle needs cleaned, (when you click the belt into the buckle the connection is not being completed keeping the dash light on.) Try inserting a thin flat blade screw driver with a lint free cloth dipped in rubbing alcohol into the buckle and slide to and fro gently. do this a few times moving cloth o a clean spot each time till no dirt shows.

Jul 11, 2009 | 2003 BMW Z4

1 Answer

Airbag light is on - 2003 Tiburon


section_closed.gif 2003 HYUNDAI TIBURON Recall ID from NHTSA: 02V290000 Auto Recall Date: NOV 05, 2002 Vehicle Component: SEAT BELTS:FRONT:BUCKLE ASSEMBLY Model Affected TIBURON Estimated Vehicles Affected: 7382 Recall Details Auto Recall Date: NOV 05, 2002

Vehicle Component: SEAT BELTS:FRONT:BUCKLE ASSEMBLY Estimated Vehicles Affected: 7382 Model Affected2003 HYUNDAI TIBURON

2003 Hyundai Tiburon Defect Summary:ON CERTAIN PASSENGER VEHICLES, THE DRIVER SEAT BELT BUCKLE WIRING COULD BE DAMAGED BY INTERFERENCE WITH THE DRIVER SEAT CUSHION HEIGHT ADJUSTER MECHANISM.

Defect Consequence:DAMAGED DRIVER SEAT BELT BUCKLE WIRING COULD CAUSE THE SEAT BELT WARNING LAMP OR THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG WIRING LAMP TO ILLUMINATE. IT COULD ALSO CAUSE THE AIR BAG FUSE (CAVITY NUMBER 5) TO OPEN, PREVENTING AIR BAG DEPLOYMENT. NONDEPLOYMENT OF AN SRS AIR BAG IN A CRASH WHERE AIR BAG DEPLOYMENT IS WARRANTED COULD INCREASE THE RISK OR SEVERITY OF INJURY IN A CRASH.

Remedy:DEALERS WILL INSTALL A NEW DRIVER SEAT BELT BUCKLE, IF NECESSARY, AND WILL PLACE A PROTECTIVE COVER OVER THE DRIVER SEAT BELT BUCKLE WIRING TO PREVENT DAMAGE FROM OCCURRING. OWNER NOTIFICATION BEGAN ON MARCH 24, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HYUNDAI AT 1-800-633-5151.

Estimated Vehicles Affected: 7382

Notes: HYUNDAI MOTOR COMPANY 056

Dec 07, 2008 | 2003 Hyundai Tiburon

Not finding what you are looking for?
1990 Volvo 740 Logo

Related Topics:

322 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...