Question about 1995 Toyota T100 Xtracab

Open Question

How do you remove the rear side panels on a T100 to install new speakers? ... how to remove the side panels to get to the speakers in the xtra cab

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 255 Answers

SOURCE: how to remove rear door interior door panel

You should obtain a tool made specifically for removing door panels. They are attached by "snap" connectors, and by pulling on the door panel itself will invariably ruin it. Get the tool from a parts place and carefully peer into the slot between the door metal and the door panel. Use the tool slowly with resolution. You should really acquire a manual that guides you for your particular Jag.
Remember, to take the panel completely off, you need to remove the door handle. Look for a plug that has a screw under it. You'll need to pop the door window/lock control panel too, to access screws under there. This can be tricky, so be careful.

Posted on Nov 24, 2009

  • 45 Answers

SOURCE: rear struts replacement

It's kinda hard to explain on line but I think you need to remove the rear seat back which you might have to remove the sitting portion to get that out. Once the seat back is out of the way most of the parcel shelves slide foreward. I've done this on some newer BMWs and the plastic on the sides needed to be removed also. If you could post a picture of the whole rear shelf area I could probably help you more.

Posted on Aug 12, 2008

SOURCE: How to remove rear door panel on 2003 Chevrolet Malibu?

not sure

Posted on Aug 13, 2008

  • 328 Answers

SOURCE: How do you remove the door panel on a 1997 GMC 1/2 ton trucks?

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008f768
Hope this helps!

Posted on Feb 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to install quarter window that flips out on 2003 dodge Dakota. 2 door.right side


REMOVAL

(1) Remove quarter trim panel.

(2) Remove the bolts attaching the latch to the cab


side panel.



(3) Remove the nuts attaching the frame/hinge to

the B-pillar.

(4) Remove the glass from the cab.
(5) If necessary, remove the latch from the glass.

INSTALLATION

(1) If removed, install the latch to the glass.

(2) Center the window glass at the opening, insert

the hinge studs in the B-pillar holes, and install the

nuts.

(3) Attach the latch to the rear side panel with the

bolts. Tighten the bolts with the latch in the lock

position and pushing rearward on the latch.

(4) Test the vent window for water leaks.
(5) Install quarter trim panel.

INSTALLATION

(1) If removed, install the latch to the glass.

(2) Center the window glass at the opening, insert

the hinge studs in the B-pillar holes, and install the

nuts.

(3) Attach the latch to the rear side panel with the

bolts. Tighten the bolts with the latch in the lock

position and pushing rearward on the latch.

(4) Test the vent window for water leaks.
(5) Install quarter trim panel.

Oct 02, 2016 | 2003 Dodge Dakota

1 Answer

1995 toyota t100 fuse location


Under kick panel drivers side of cab also engine compartment driver's side

Apr 05, 2013 | 1995 Toyota T100 Xtracab

1 Answer

Replace passenger mirror


glass and motor availbable separately

Removal
NOTE: Do not remove the mirror assembly when repairing the individual mirror part. Individual mirror parts can be installed without removing the mirror assembly.
  1. Remove the front door trim panel; refer to Section 501-05.
  1. Remove the outside rear view mirror access water shield.
    gn1881a.gif
  1. Remove the speaker.
    1. Remove the screws.
    1. Disconnect and remove the speaker.
    gn1882a.gif
  1. Disconnect the outside rear view mirror electrical connector.
    gn1883a.gif
  1. Remove the outside rear view mirror.
    1. Remove the nuts.
    1. Remove the outside rear view mirror.
      • Feed the outside rear view mirror wiring through the opening in the front door.
    gn1884a.gif

Oct 26, 2010 | 2003 Ford Ranger Regular Cab

1 Answer

How is the rear speaker cover removed from a supercab fx4 f150 2004


The rear door panels are not like the front doors ( additional panel on the door panel ), the silver/gray rear speaker panel is part of the rear door panel.

Remove the panels next to the window ( should be spring clips ).
This should expose 3 bolts holding the top of the door panel on.

Next remove the rear window console panel ( spring clips on the side towards the cab, tabs on the side towards the door ).
Behind this should be a bolt.
Next remove the rectangle cover in teh door handle area, there is a bolt behind this.
should be 1 other screw at the bottom of the door panel, by the door sill area ( under the map pocket ).
The door is held on like the front doors, with large plastic hooks, so pick up on the door panel once all the screws are out.

Nov 24, 2009 | 2004 Ford F150

2 Answers

I need help with replacing the driver side window in a 2003 ford f-150,four door super crew cab truck.


Removal & Installation
Motor - Front Door
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove the window control switch
  3. Remove the front door trim panel and watershield.
  4. Tape the window in the full UP position.
  5. Disconnect the window motor electrical connector.
    NOTE Support the window motor while removing the window motor retaining screws.
  6. Remove the window motor bolts and remove the motor.
  7. To install, reverse the removal procedure.
Rear Door
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove the window control switch.
  3. Remove the rear door trim panel and the rear door trim watershield.
  4. Remove the door speakers.
  5. Tape the window glass in the full UP position.
  6. Disconnect the window regulator electric drive.
  7. Position the connector for the window regulator electric drive inside of the door.
  8. Remove the bolts.
  9. Separate the window regulator electric drive from the rear door window regulator.
  10. Remove the window regulator electric drive from the door.
  11. To install, reverse the removal procedure.

Motor & Regulator

3d4a07e.jpg

Fig. Front Door Trim Panel

7932e42.jpg


Fig. Rear Door Trim Panel-Crew Cab


Regulator - Power Windows

506866e.jpg

Fig. Window regulator arm nuts


db15984.jpg

Fig. Window regulator bolts

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove the window control switch.
  3. Remove the door trim panel.
  4. Remove the door speaker.
  5. Remove the door watershield.
    NOTE Do not remove the window glass from the door.
  6. Remove the window glass from the window regulator.
  7. Tape the window glass in the full UP position.
  8. Disconnect the window motor electrical connector (power windows only).
  9. Loosen the window regulator arm nuts and pull the arm from the mounting position.
  10. Loosen the bolts and remove the window regulator.
  11. To install, reverse the removal procedure.

Hope helped with this. Good luck.

Nov 16, 2009 | 2003 Ford F150 Regular Cab

1 Answer

Timing belt change


its involved, unless you are a mechanic, then you need to find a good shop to replace it, and any related items. tensioner pulleys, seals, water pump, ect.

Sep 23, 2009 | 1995 Toyota T100 Xtracab

1 Answer

When i try to open the door it wont move the bottom latch releases but the top wont and i cna get to it to try to remove it


Section 501-14A: Handles, Locks, Latches and Mechanisms 1997 F-150, F-250 Workshop Manual REMOVAL AND INSTALLATION Latch, Rear Door — Upper Removal
  1. Remove the rear door trim panel; refer to Section 501-05 .
  1. Remove the rear door radio speaker.
    1. Remove the four radio speaker screws.
    1. Disconnect the electrical connector.
    1. Remove the rear door radio speaker.
  1. Carefully peel off the rear door watershield.
  1. Disconnect the upper rear door latch cable.
    1. Lift the clip.
    1. Pull to release the cable from its seated position.
d07f7d7.gif
  1. Remove the upper rear door latch.
    1. Remove the three screws.
    1. Pull the upper rear door latch and the cable up through the door latch opening.
b223e87.gif

Apr 14, 2009 | 1997 Ford F150 Regular Cab

1 Answer

2001 GMC Sierra C3 How to get front door panels off


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Mar 20, 2009 | 2002 GMC Sonoma Extended Cab

1 Answer

Install Rear Speakers Ford F150 1997 Regular Cab


you should not have to remove the panel by taking the four phillips screws out of the speaker grill you will pull out through front

Jan 13, 2009 | 1997 Ford F150 Regular Cab

1 Answer

Replace passenger mirror


  1. Remove the door inside handle as follows:
    1. Remove the screw and slide the handle forward.
    2. Disconnect the handle from the control link and remove the handle.
  2. Remove the door trim as follows:
    1. Remove the 2 caps and 2 screws.
    2. Using a screwdriver, remove the door trim upward then disconnect the connectors.
    3. Using a screwdriver, pry the forward of armrest panel and remove the panel.
    4. Remove the 2 screws and tweeter speaker.
    5. Disconnect the connector, remove the 5 screws and speaker.
    6. Disconnect the wire harness and remove the 2 grommets and service hole cover.
  3. Remove the cover and disconnect the power mirror connector.
  4. Remove the 3 nuts and outer rear view mirror.
To install:
  1. Installation is the reverse of the removal procedure.
  2. Tighten the mirror nuts to 8 Nm (71 inch lbs.).

Good luck...

Nov 11, 2008 | 2002 Toyota Tacoma

Not finding what you are looking for?
1995 Toyota T100 Xtracab Logo

Related Topics:

316 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...