Question about 1994 Chevrolet K1500

1 Answer

Were is the plug to disconnect the computer from changing the timing on a 94 chevy pickup with 350?

Posted by on

  • frank thomas wilson
    frank thomas wilson May 11, 2010

    computers keep the timing in sync no way to change it unless an older style distributor is used and completely rewired for it

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 617 Answers

Disconnect SET TIMING connector: The location of the set timing connector is inside the cab where the heater box and the carpet meet on the passenger side floor. Pull carpet back to expose the single wire and connectors on the outside of the control module harness. The wire colors are tan with a black stripe. DO NOT disconnect 4 wire connector at distributor.

Posted on Feb 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can a 94 chevy cheyenne transmission interchange with a 97 chevy silverado tranmission


Will it physically fit? yes. Will it be a direct replacement any everything hook right up and plug right in? If we are talking about an automatic then no. 1994's wiring was completely different than the 1997. Can it be made to work? possible, but I believe it would be more trouble trying to make it work than if the correct transmission were located and installed. If it is a cost issue where he has a good trans out of a 1994 he might see if a salvage yard will do some partial trading for the correct trans.

Apr 24, 2013 | 1998 Chevrolet C1500

1 Answer

What causes a 1994 chevy pickup with 350 motor to surge at idle then die. Has little power, runs rough, bad fuel economy. disconnected egr valve, no change, replaced throttle position sensor, no change.


is the check engine on? are there any trouble codes? one posible cause would be a restricted fuel filter, a worn fuel pump, or a restricted exhaust system.

May 03, 2011 | Chevrolet C2500 Cars & Trucks

2 Answers

Pictures of 350 engine in a 1989 chevy pickup truck


here you are my friend. Now i went way out of my way for this so i hope this is what you are asking for :) 09bfaec.jpg

Apr 10, 2010 | 1989 Chevrolet Silverado 2500

1 Answer

Do i use a exhaust manifold gasket or rtv on my 5.7 checy pickup 94 chevy / 350


You can use a little rtv on the gasket but is not necessary.

Feb 28, 2010 | 1994 Chevrolet K1500

3 Answers

94 chevy 5.7 350 need to reset timing what do i need to do?


start engine and bring to normal operating temp. unplug the base timing connector located in the distributor wiring harness tan wire with a black stripe use a timing light and set timing to 0 degrees at idle the timing marks are on the crankshaft pulley and a tab on the timing cover with numerical indications

Jan 01, 2010 | 1994 Chevrolet Silverado 2500

1 Answer

94 chevy 1500, 350 engine. putters after start


check your vacuum lines they are weather cracked and leak vacuum air

Oct 07, 2009 | 1994 Chevrolet K1500

1 Answer

Idle drops really low then returns to normal afew times b4 cutout


my buddies 94 350 has been doing the same thing for years i think its in the computer i would say youll probably have to live with it

Mar 24, 2009 | 1994 Chevrolet C1500

2 Answers

93 chevy c1500 pickup 350 moter


Its mounted on the passenger side of the intake next to the TBI

Oct 22, 2008 | 1993 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...