Question about 2006 Chevrolet Trailblazer

1 Answer

2006 chevy trailblazer replace 4wheel drive selector

How to remove dash cover on 2006 chevy trailblazer,so i can replace 4wheel drive selector part

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 246 Answers

I've got a 2003, and i believe the parts and procedures are the same for the years. there are screws in the dash trim by the ciggarette lighter, and more on the underneath of the dash pad where the gauge cluster is. then carefully pop the dash trim out. there are retaining clips that hold it in besides the screws. they should pop out without too much effort. i'd start near the radio and be careful. there also may be two more screws near the bottom of the steering wheel that you'll have to remove the trim below it to get at.

Posted on Feb 17, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the fuze for theated seats in a 2003 chevy trailblazer


Most Chevys have two fuse blocks. Heated seats power windows and other interior options are in a panel on end of dash. Open drivers door and look at dash end should be a removable cover with fuse guide posted on its inner surface.

Feb 15, 2015 | 2003 Chevrolet TrailBlazer

1 Answer

How do you replace a low beam headlight bulb in a 2006 Chevy Trailblazer?


Drivers side- reach hand behind headlight and remove the rubber cover, then turn and remove bulb.

Passenger side- remove air cleaner top and move the air cleaner out of the way. Now you have access to the rubber cover to replace the bulb

Dec 13, 2010 | 2006 Chevrolet Trailblazer Ext

1 Answer

Need to replace low beam headlamps on 2006 Chevy Trailblazer.


For the passenger side- need to remove the air cleaner top and move the air cleaner out of the way. You can now access the rubber covers that protect the bulbs.

For the Drivers side, just stick, your hand down behind the headlight and remove the rubber cover.

Remember, do not touch the new bulbs, the oil from our hands will burn a hold in the bulb.

Dec 11, 2010 | 2006 Chevrolet Trailblazer Ext

1 Answer

2003 Chevy trailblazer, the 4 front dash air


{: ) Check first the fuse labeled HVAC1 10A at the rear fuseblock. If okay, the mode actuator could be faulty. You can try this: turn ignition switch and a/c off for a minute. Then turn ignition on, wait forty seconds. Afterwards, start the engine, and check your a/c again.

Aug 01, 2010 | 2006 Chevrolet Trailblazer

1 Answer

How to loctae a crank shaft sensor for a 4wheel


Sits on the side of the engine block, held on with a 8 or 10mm bolt, remove bolt and sensor slides right out.

Jun 04, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

How to change headlight bulb 2006 chevy trailblazer


See note below for passenger side. Remove the dust cover on the back of the head light assembly (black round rubber cover about 3" in diameter, just pull it off), disconnect the plug on the bulb, turn the bulb a 1/8 turn and pull it out. Then reverse the process for assembly.

***NOTE***If you are trying to replace one of the bulbs on the passenger side, remove the air filter housing cover and displace the filter for access to the dust covers on the back of the head light. 2 screws hold the air filter housing cover on, one directly behind it and one on the side (drivers side of air filter housing).

Jan 03, 2010 | 2006 Chevrolet Trailblazer

1 Answer

How do you get to the low beam to replace it on a 2003 chevy trailblazer. it is burnt out and i can't find how to remove it to replace it.


there is an access cover at the rear of the headlamp that you need to remove. once you do that you will gain access to the headlight bulb. remove the electrical connector and then twist the bulb counterclockwise to remove it.

Sep 23, 2009 | 2006 Chevrolet Trailblazer Ext

Not finding what you are looking for?
2006 Chevrolet Trailblazer Logo

417 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...