Question about 1990 Ford F150

1 Answer

Cant get the transmision all the way in strait drive 1990 4x4 i got the transfercase off and got the tranny all but three quarters of an inc in

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 279 Answers

U may have to remove the bell-housing and loosen the pressure plate and and install your alignment tool.Hold pressure against the alignment tool while you tighten the pressure plate to ensure that the clutch plate does not move.Apply a small amount of grease to the end of the input shaft,put the gear box in neutral to allow the shaft to move.Be patient it may take some time to get it in.

Posted on Feb 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2003 dodge 2500 two wheel drive have a bad raidle on the front driver side when im on a rough road


ok that rattle if that what you meant could be you shocks are gone on that side or it could be you lower control arm bushens may be bad or you tirerod end is bad check this right away it could be dangerous ,now just to give you an idea how to check those parts,jack that side up off the ground then support the vehicle,then hold the wheel at quarter to three that would be strait across the shake it left to right if you have any movement its your tirerod end then put your hand at six oclock thats strait up and down now try a push and pull movement if you have any movement you wheel bearing is bad now some time you may not have a movement but the wheel bearing still could be bad,now,check your lower control arm,look for a broken bushen ,inspect your shock as well

Jul 14, 2014 | Dodge Ram 2500 Cars & Trucks

1 Answer

My 94' gmc yukon will not shift into over drive


Problem is most likely internal of the transmision. To diagnos this problem correctly, you need a scan tool. Most likely scenario is that the solenoids in the transmision are defective. Take to tranny shop for proper diagnosis.

Aug 20, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

I have a 1996 gmc serria 1500 4x4 v6 vortec manual I can't seem to find the oil plug for the trannie it seems to me it's part of the transfercase help


Most vehicles do not have an oil drain plug for the tranny...you have to drop the pan to change the oil. Make sure you install a new gasket when you put it back on.

Jul 17, 2013 | Cars & Trucks

1 Answer

What type of oil for transmision(manual) transfercase,front and rear differentals


Gearbox (manual) 75W90
Transfer box 75W90
Front and rear axles SAE90
Hope that helps

Jan 15, 2010 | 2000 Kia Sportage

1 Answer

Is my transmision going out


If it only does this in third gear and no others then your tranny is faulty in that gear. Expensive fix.. I would make sure that your fluid is full and clean before I change the tranny.

Sep 24, 2009 | 1999 Volvo S80

2 Answers

Transmision wont back up


you need a different tranny because the reverse is a direct gear and is doent engage,the reverse doest work with the drive gear system,so you have a internal mechanical problem in you tranny

Sep 24, 2009 | 2001 Ford Windstar

1 Answer

I Have transmision problem with my Dodge Stratus 2002 2.4 Lt


You need to flush and change your tanny fluid and this should help with the late shifting.
Note, these cars kindda have bad rep for tranny failure unless you drive soft and not vigorously, like my brother who went through 3 rebuilt tanny before he learned his lesson.

Aug 19, 2009 | 2002 Dodge Stratus

1 Answer

Transmision wont shift out of 2nd gear


Maybe, but won't know till you take it too tranny shop. Even iif it is done a rebuilt is still cheaper than brand new. And, less you drive it now less damage done.

Dec 29, 2008 | 2000 GMC Sierra

1 Answer

My truck when put into drive it won't go unless it is revved up to 3000 RPM? whats wrong?


It sounds like the Torque converter might be failing or the tranny needs work. Look at the tranny dipstick to see if an metallic specs exist. A good tranny filter change/ system flush with a pressurized collection system will always do a world of good. how long has it been for you? if its a 4wd do the front diff and the transfercase as well.

Jul 30, 2008 | 1999 Ford Ranger SuperCab

Not finding what you are looking for?
1990 Ford F150 Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...