Question about 2005 Chevrolet Uplander

1 Answer

Just bought used and engine light came on all is running well

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,111 Answers

Well 1st i would open the Hood and with the engine _OFF) look for the obvious 1st such as fluid levels and ensure they are all correctly up to level .

you can go to most parts stores and ask to use the diagnostic tool that plugs into your vehicles diagnostic lead usually under the dash drivers side once connected turn the key to the ON position and allow it to communicate with your vehicle if any codes are found write them down if there is more than 1 code press the down arrow and continue writing them down
once this is done you will have an option to delete any and all codes to remove the chk engine light ...however you may wish to keep them unless you as i said write them down and if you need any parts you are at the parts store anyhow so you can also ask them advise on difficulty of installing certain parts or components as well ...hope this helps and is an easy fix .....and usually is especially if all is running well so far .

Posted on Feb 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need PCM WIRING DIAGRAM for 1999 ford ranger 3.0L v6 4x4 flex fuel engine vin letter V


In the reference I have, power from 7.5A FUSE 11 is connected by a RED/YEL wire to one terminal of the malfunction indicator lamp (MIL) in the I/P. A PNK/LT GRN wire connects the other terminal to pin 2 of the PCM.

Dec 10, 2016 | Ford Ranger Cars & Trucks

1 Answer

I have a Hyundai Accent 2005 and i bought it with an engine light on.. The engine light is on all the time and it doesn't go off. Is there a way i can fix it alone? Is it something major? Please help or...


run the fault codes to find the sensor that has the light on. it can be either engine or transmission
fix the fault and reset the ECM using a scan tool

May 22, 2015 | 2005 Hyundai Accent

1 Answer

Kia spectra check engine light


Hey Connie, There are numerous reasons the check engine light will come on... from a loose or not sealing gas cap, to numerous sensors...if it runs great, gets good mileage..>>>???

Jul 05, 2017 | Cars & Trucks

1 Answer

I just bought a 2006 Chrysler 300 limited and I'm


You don't have daytime running lights but you do have automatic light control. The design engineers reasoned that you would not need fog lights unless you were running with headlights on under foggy conditions so these functions are controlled by logic and can't be separated without rewiring

Nov 15, 2012 | Cars & Trucks

1 Answer

Engine runs fine when cold ,as soon as warms up to temp runs like **** revs up then bogs down the quits. what the problem


is your check engine light on? sounds like your intake air temp sensor. sometimes you can unplug it {while its running} and listen for change in engine. it will slow down or shut off. i would suggest getting one from local salvage yard before i bought it new. if it sloves the problem then you havee= the option to use it or buy new.

Jan 17, 2011 | 2000 Buick LeSabre

1 Answer

Check engine light came on. Just bought the car. Fluids are all good. Any ideas?


do a self test for your check engine light.

use key. turn to; off-run, off-run, off-run. ( run is when the dash lights are on-not starting, and off is one click back) The codes will flash out on the check engine light in pairs, or display on the digital odometer. end of the test is 5-5.

Or did you leave the gas cap loose or off? If so just tighten the cap and the light will go out all by itself in a few days.

Oct 01, 2010 | 1999 Plymouth Breeze

1 Answer

Just bought my 2004 Dodge Ram 1500 Quadcab 4x4


use a 1/16 drill bit to drill thru indicator to break bulb. light will not come on when started again

Jan 21, 2010 | 2004 Dodge Ram 1500

1 Answer

Dash lights on, running rough


i have the same car and year. Both my lights flashed i bought it to my mechanic he checked my oil and said that when i got my car serviced at a cheap place they put in cheap oil. he hooked up his computer to mine and got an o2 sensor code. he shut the light off and changed my oil. all set. i also use premium gasoline and my car runs very good.

Apr 13, 2009 | 1999 Lexus ES 300

Not finding what you are looking for?
2005 Chevrolet Uplander Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...