Question about 2003 Honda Odyssey

1 Answer

Put in new ignition and will ot start now - 2003 Honda Odyssey

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,206 Answers

Check your fuses one could have blown during your installation,if not check all your connections and work.

Posted on Feb 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My smart key will not turn in my ignition on my clk320 year 2000 battrey was flat but it as been charge up and tested

sounds like a bad key and needs to be replaced. you cannot take it out of park unitl the key is rotated.

Feb 28, 2015 | 2000 Mercedes-Benz CLK


Engine is cranking but no start

remove plastic cover over the ignition.its fix with screws under weather strip and  2 more .after remove cover carefully because its easy to lose remove ignition cylinder by pushing on pin ( when key is on the pin move into a small hole under cylinder)disconnect cylinder connector on left remove immo antenna(the black ring ) by removing small screw.put foam tape between antenna and the cylinder assy.the goal is to seal antenna from the rest ot cylinder

on May 26, 2012 | 2007 Hyundai Elantra Limited Sedan

1 Answer

2007 Chrysler town and country. originally had a p0202 code which the dealer said was an ignition coil pack. Replaced ot and two weeks later the engine light comes back and it's a p0303 and the

it could be the system utility of the car computer its protecting,the car ,if you have a friend or somebody lets you borrow a compu and check to verify its not the computer,start to send you codes,you just said after fix one another comes out,sometimes are the wires too

Sep 20, 2012 | 2007 Chrysler Town & Country LX New Cars

1 Answer

Hi someone removed a fuse from my 98 grand prix and now it wont start do you know which fuse this could be please

Lots to look at, fuel or ignition. The panel i wold guess they messed with would be the one under the hood (see picture below) In the other picture I gave you a diagram of the layout with numbers ot to guide you. This is for a 1999 but am 95 percent sure it is the same. fuses to look at: number 4- battery Main, 5 - ignition main , 7 - battery main, 8 - ignition main. Now the real ones to look at: number 25 - ignition module, 32 - fuel pump & 33 - electronic control module/powertrain control module. Now to a couple of relays in that same box that could be the problem. number 11 - ignition main & number 14 fuel pump relay. I would put money it's one that has to do with fuel. I really hope your weekend goes better. Good luck.


Apr 23, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

I bought 91 eagle talon tsi with no key how do i get the cylinder ot so i can have it keyed or put a new cylinder in?

remove the wheel housing and remove the old ignition switch and replace with a new one i believe the wire harness comes with it so a bit of work is involved

Sep 15, 2009 | 1991 Eagle Talon

1 Answer

I have a 1996 GMC K2500 power staying on to my heater fan

Hardly seems worth changing the lock cylinder, since it is not that easy.
Just be more careful turning the ignition off.
Put in an ignition indicator light on the dash if you have to.

Jul 26, 2009 | 1997 GMC Sierra K2500

1 Answer

BMW 530 ignition problem

when starting the car the starter motor uses a huge amount of current

normal things like lights radio ac dont use that much

most of the time the radio will work but the car will not start

i recomend recharging the battery before you start replacing anything

i amagine that changing the barrel would not be that hard
the hardest bit would be finding a barrel and keys

Jul 04, 2009 | 1990 BMW 5 Series

1 Answer

Security system

If your car has a chip in the key, then this is the definitive solution: . It was the only thing that saved my Park Avenue.

Feb 10, 2009 | 1997 Oldsmobile LSS

Not finding what you are looking for?
2003 Honda Odyssey Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides