Question about 1997 Volkswagen Jetta

1 Answer

Cranks but wont start. has fuel, has fire from coil to dist.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 37 Answers

Check pules on injector conections with niod light . if no pules .then two things crank sensor or blown pcm.

Posted on Feb 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My engine cranks but will not start replaced fuel pump but still wont start


Cud b ignition..like a crank sensor or new coil, dist cap, plug wires. Stil need to test fuel pressure. Turn key off/on 3 times on 4 startit..if no gas builds up then fuel system has furthr problems

Jun 07, 2015 | Cars & Trucks

2 Answers

Engine turns over but wont start. You can hear thr fuel pump come on. Is it electrical? Could it be battery, fuse, or loose wire?


This sounds like the crank shaft sensor is bad. The sensor sends a signal to the computer about when to fire the coils for spark.

May 02, 2015 | 1999 Dodge Durango

1 Answer

Engine cranks over but wont start, I can faintly smell fuel


seems with the Info you provided ,, that you are getting NO Spark ,,,ck. coil wire ,,for corrosion ,,and then coil ,,,Dist. cap ,,,and Dist. Rotor ,,,,,LMK ,,,

Apr 10, 2015 | 1998 Dodge Dakota

1 Answer

2001 blazer wont start ran fine before turning off has fuel pressure has fire check timming ok relaced coil ,ing moduel crank sensor dist cap could it be the anti theft ?


You say it has fuel pressure, if it has sequential fuel injection it needs about 70psi to start the engine.
If it cranks and has spark to the plugs, the anti-theft system is not involved.
You did not mention the rotor, I assume you have spark to the plugs not just out of the coil.
If you have not yet checked cranking fuel pressure, I would start there. The pump could be weak or the filter stopped up.

Jul 22, 2012 | 2001 Chevrolet Blazer

5 Answers

Truck wont crank. we have put new distributor cap, rotor button, coil pack, plugs, wires, and fuel pump. we also checked our firing order.


you said you repl dist cap that means you don't have a crank sensor you have electronic ing module. remove your elec ing module have it tested most auto parts stores could test your module, or check your coil at the neg terminal. should have power. if not you lost your primary volt from your batt.your secondary power is coming from your electronic ing module from the module to the pos terminal on the coil, when the eng cranks,from the coil to the dist cap , from the dist cap center to the rotor then out to the plugs,this all happen pervided the timing belt or timing chain is ok. the cumbustion chainber needs 3 things , thats fuel, air, and spark.

Apr 17, 2011 | 1996 Chevrolet K1500

1 Answer

Engine turns over fast, wont fire, has fuel,


Since it don't fire, you need to check your spark plugs/coils, wires, distributor/coil pack, dist.cap, rotor, cam sensor, crank sensor. It may be the computer but that is last possibility. Each one of these effect the fire to the engine. You need to test what you can. It could be anyone of them.

Mar 08, 2011 | 1999 Pontiac Grand Am GT

1 Answer

I have a 1993 gmc 1500 5.7 liter I just had the tranny rebuilt and now I have been having problems with it running! so I gave it a new tune up, plugs, wires, coil, dist cap, rotor, I have even went as far...


Two things kill engines faster than anything 1) fuel 2 ) ignition So 1) Fuel coming through line at good volumes and pressure? fuel pump and its electrical supply in good shape? In-line fuel filter not clogged? Does she fire if you squirt Easy Start (raw alcohol) in the throttle throat? Is the fuel fresh and not rancid stuff that has been sitting in a can for years? No disconnected hoses (crank case breather/relief pipe) to the inlet manifold to cause loss of vacuum? and 2) Timing? leads in right order from dist cap? fuses all OK? can you see spark jumping from top of coil to HT lead when disconnected but brought up close? check that low tension wires are on the correct terminals.

Apr 24, 2010 | 1993 GMC Sierra K1500

1 Answer

Cranks but no start, no injector signal or spark


SEE IF YOU CAN PULL CODES AND DATA READINGS, IF YES MORE THEN LIKELY ECU OK. CHECK DIST. FOR PLUG FIRE AND INJECTOR PLUSATION, IF NO FIRE OR PLUSATION POSS. BAD IGNITION COIL OR MODULE.OHM COIL.

Nov 05, 2009 | 1994 Toyota Corolla

1 Answer

1995 GMC Suburban 4 Wheel Drive wont start


check your timming .dist may have moved on you this happend to me i have a 2500 gmc pu.ran fine .started,my truck it ran moved about 20 feet and dyed .cranked over but no start just by fluke moved dist back and a way we go try that .good luck ED.

Aug 10, 2008 | 1995 GMC Suburban

Not finding what you are looking for?
1997 Volkswagen Jetta Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...