Question about 1984 Honda Accord

1 Answer

How to change my e-brakein a 1984 honda accord lx

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 2,984 Answers

Removal & Installation

  1. If equipped with an air bag, disconnect the negative battery cable and properly disable the Supplemental Restraint System (SRS), as detailed in Section 6 of this manual.
  2. Remove the access cover at the rear of the console. In some cases, removing the console may be necessary for access. Loosen the adjusting nut until the cable ends can be disconnected from the equalizer. With the cables detached, the parking brake lever may be removed, if desired, by removing the mounting bolts holding it to the floor.
  3. Loosen the lug nuts, then Raise and safely support the vehicle on jackstands.
  4. Remove the rear wheels.
  5. On disc brake equipped vehicles, pull out the lock pin, remove the clevis pin and remove the clip.
  6. On drum brake equipped vehicles, remove the brake drum and brake shoes. Disconnect the cable from the backing plate.
    1. Detach the cables from the cable guides and remove the cables from the vehicle.
    2. To install:
    1. Fit the cable loosely into place. Begin reattachment at the rear brake shoes or calipers. Make certain the cable is routed correctly and firmly seated in it mounts.
    2. Connect the cable(s) at the lever inside the car.
    3. Install the cable bracket retaining bolts. Do not allow the cable to become kinked or bent. Make certain the rubber boots are in place where the cables pass into the cabin.
    4. Adjust the cables.
    5. Lower the vehicle to the ground and check for proper brake operation.
    6. If equipped, enable the SRS system and connect the negative battery cable.

how to change my e-brake - 38ac190.gif
Use a box-end wrench to depress the retaining tangs, then slide the cable out of the backing plate

Posted on Feb 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Honda Accord brake light in dash stays on


Check to make sure your parking brake isn't slightly lifted up otherwise your brake fluid is low

Jul 12, 2014 | 2003 Honda Accord 2.4 LX

1 Answer

Where is the transmission filter in a 1984 honda accord lx?


Most transmission filter are located inside the transmission right above the transmission pan. Good Luck

Jun 25, 2011 | Honda Accord Cars & Trucks

1 Answer

Changing front brake rotors on 1992 Honda Accord LX . How do get them off?


on the 1992 Accord you have to remove the hub and bearing assembly in order to remove the brake rotor, you will have to remove the steering knuckle in order to get access to the brake rotor.

Dec 30, 2010 | 1992 Honda Accord

1 Answer

I want to change rear drum brakes to disc brakes on a 1992 honda accord lx 4dr


you would need to take the WHOLE system from another honda ...ALL OF IT ...it would be better to buy another car......
you CANNOT just replace the rear break/axle system.

Aug 21, 2010 | 1992 Honda Accord

1 Answer

My honda accord lx 2005 made a sound like a whale while it stopped & brake pedal is pushed. Please advise! Thanks Ty


check if theres a deep scouring on your brake discs if it does its ur bakes pads metal is getting in contact with your brake discs u need to change the pads and reface the discs to remove deep cuts on it.

Apr 07, 2010 | 2005 Honda Accord

2 Answers

Low brake pedal on honda accord lx 96


You need to check the brake fluid if it is low it will take air in the system,you need to take that air lock in order to get a better brake.

Feb 02, 2010 | 1996 Honda Accord

2 Answers

91 honda accord brake lights stay on replaced


are you sure you the adjustment to it is correct the button in the end of the switch has to be fully depressed to deactivate the circuit

Jan 19, 2010 | 1991 Honda Accord

1 Answer

1992 Honda Accord LX intermittantly shifts correctly


-very important check for brake light when pressed (outside rear)
-did u recently change any bulb at the rear if yes recheck if it the right brake light bulb 1157
u need to do a dignostic for the d4 light and it will lead u to the problem

Oct 05, 2009 | 1992 Honda Accord

1 Answer

92 Honda Accord LX


is the front (in the hood)

Mar 02, 2009 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...