Question about 2006 Toyota Sequoia

1 Answer

Was just told the translate ecu unit is shot in my sequoia. what does that mean?

Posted by on

  • yadayada
    yadayada May 11, 2010

    is this the PCM? ECU is old term for electronics control module for the engine and emission system.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 259 Answers

Emissions control unit. It controls emissions by adjusting engine settings.

See explanation of what it does here:

Posted on Feb 05, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hello Where is the body control module on my 2014 Toyota Sequoia please Thanks

The body ecu( control module) is located on the back of the junction block that has all the fuses on in on the inside at the lower left of the dash, in most cases the entire junction block with the ecu has to be replaced as one unit.

Nov 28, 2017 | Toyota Cars & Trucks

1 Answer

Ecu wiring diagram

You need to go to eBay and try to find the wiring diagram or contact dealer on your area. I was able to find a wiring diagram in eBay for my classic car a Ford 1979. New no less.

Jan 04, 2016 | 2001 Toyota Sequoia

1 Answer

Replacement ECU

Simple. Go to YouTube and find the answer step by step.

Jan 04, 2016 | 2001 Toyota Sequoia

1 Answer

I have codes C1241 and C1223 on a 2001 Toyota Sequoia. What is the possible problem?

found this on another post. Hope it helps.

c1223 absicon1.png control system abnormal

c1203 data cannot be transmited/recived to/from ECM

trouble area:
brakeicon1.png fluid
brake fluid level switch
SS1 or SS2 circuits
Translate ECU

Nov 01, 2013 | Toyota Sequoia Cars & Trucks

1 Answer

Toyota sequoia skid control

how to retrieve code for 1992 mecedes 300E

Jun 13, 2013 | Cars & Trucks

1 Answer

What is code po441 on a 2003 toyota sequoia

Get its repair manual to translate it.


Mar 29, 2013 | 2003 Toyota Sequoia

1 Answer

Car won't start, just click click click

Generally this means yr battery is shot. get it chkd. otherwise it is the connection to the starter motor or earth wiring. Basically it indicates that the main stream power from the battery is not there and therefore not enough to start the motor. cheers

Aug 24, 2012 | 2003 Toyota Sequoia

3 Answers

2003 toyota abs light Codes C1203, C1223

C1223 - Left Rear Wheel Speed Sensor Input Signal is 0 C1203 - The procedure for this fault is to check for an open or short in the harness and connector between the Skid control ECU and ECM.If no faults are found with the wiring, then - the MIL stays off when ignition on but engine not running (Requires ECM replacing)
- the MIL comes on when ignition on but engine not running (requires ABS & traction actuator assembly)
These parts wont be cheap so i hope its a wiring fault smile.gif
If you take it to a Toyota dealership they should be able to do this for you pretty easily.

Mar 02, 2011 | 2003 Toyota Sequoia

1 Answer

2003 Toyota Sequoia - Brake light comes on during hot weather

your ecu got nothing to do with your brake,maybe your abs controller but i dont thing so,warping is basically couse of poor material or uses of exessesive brake,imagine your truck is big and heavy try not to setle with cheap rotors and good brake pad,after installing all new and break in and bedding it really good that should last u a 4 to 5 years before it warp again.check your sensor about the light check your safety brake sensor too..good luck

Dec 17, 2009 | 2003 Toyota Sequoia

Not finding what you are looking for?
2006 Toyota Sequoia Logo

Related Topics:

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

80263 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides