Question about 1989 Oldsmobile Ninety Eight

1 Answer

Need to change alternator in 89 Olds Ninety Eight. Simple/not simple? serpinetine belt 'concerns' me..should I worry or forge ahead.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

Should not be too difficult if you apply pressure to the tensioner pulley for the serpentine belt (making it easier to remove). After disconnecting the negative battery cable you can then remove the Alternator.

Posted on Feb 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can I bypass the ac compressor with a smaller serpentine belt?


I have a 1990 Olds 3.8 V6. Installed a 715k6 belt bypassing the frozen AC compressor using the stock belt routing. Working great.
Thanks for the above advice

Aug 07, 2012 | 1994 Oldsmobile Ninety Eight Regency

1 Answer

Where is the fuel filter located in my '89 Olds Ninety-eight


Gasoline Fuel Filter There are three types of fuel filters; internal (in the carburetor fitting), in-line (in the fuel line), and in-tank (the sock on the fuel pickup tube). CAUTION
Before removing any fuel system component, always relieve pressure from the system.
---
Check near the gas tank behind it in the fuel line.

Oct 08, 2010 | 1989 Oldsmobile Ninety Eight

1 Answer

How do i remove the power steering belt from an 84 olds omega?


There is a serpinetine belt that goes around the p/s pump and the pulley and alternator. Ther are 2 bolts on the alternator one long that holds the alternator onto the vehicle and one short that adjusts the belts to tighten and loosen. Loosen both bolts, this allows the alternator to tilt letting you remove belt. Hope this helps. Good Luck

Jun 12, 2010 | 1984 Oldsmobile Omega

3 Answers

Alternator-1995 Oldsmobile


Bolts and Nuts from the alternator? not 100% sure of the question.

Mounting Bolts to the engine, there are 2...

electical connections, there is 1 for the charging circuit (bigger wires) that have a nut to hold them on, and 1 connector for the voltage regulator.

Hope that answers your question.....

Peace,

Mar 09, 2010 | 1995 Oldsmobile Ninety Eight

1 Answer

How to change the water pump on 93 olds 98


remove serp. belt put jack under engine use a piece of wood and lift engine a little and remove motor mount remove water pump clean surface and install water pump and reassemble

Nov 08, 2009 | 1993 Oldsmobile Ninety Eight

1 Answer

Where do you change the flasher on a 1996 oldsmobile ninety eight?


On the 1996 Olds LS. It was located on the back side of the fuse box. In other words the fuse box is located just under the left side of the steering column. It is exposed so you can access the fuses through a small plastic cover. But you can't access the flasher this way. You have to remove the whole plastic panel that runs in front of the steering column just under the dashboard. I removed three screws and lowered the panel to access the flasher. It's going to be "resting" in a small area on the backside of the fuse box. It was very simple to remove the existing flasher and plug in the new one. The operation from start to finish took about 10 minutes. Good luck and hope this helps.

Oct 22, 2009 | 1996 Oldsmobile Ninety Eight

2 Answers

Fuse box diagram for 1990 olds 98 i want to cut


Review this Wiring Schematic about Olds 98 ('89, '90 & '91):
1989 1
1989 2

1990 1
1990 2

1991 1
1991 2

I really hope help you with this (remember rated this help). Good luck.

Oct 21, 2009 | 1991 Oldsmobile Ninety Eight Regency

1 Answer

How do i know if my '94 olds ninety-eight is turbocharged or not?


I assume you mean Supercharged. Look at your engine. If it is supercharged, you will see a large component with a shaft and pulley at the drive belt side of the engine right on top of the engine. It is usually grey or white in colour.

Jul 24, 2009 | 1994 Oldsmobile Ninety Eight Regency

1 Answer

Supentine belt


The motor mount needs to be removed to change the belt. The labor guide is 1.5 hours for a trained technician with experience. There is no other way, sorry for the news.

Mar 14, 2009 | 1995 Oldsmobile Ninety Eight

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...