Question about Chrysler Voyager

1 Answer

How do I reset the AC on my 1998 Chrysler Grand Voyager?

How do I reset the AC on my 1998 Chrysler Grand Voyager - my Voyager was in for some body work and they let the battery run down. When I turned the vehicle on, the AC system would not work and several of the lights on the control buttons are blinking.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

You can try disconnecting the battery, some times that work's, also have the a/c system check for freon pressure could be low being they did body work and maybe had to remove an a/c hose.

Posted on Feb 05, 2010

  • Mick Bazely Jul 09, 2011

    Fix for the flashing lights.

    Ok. I have been wondering how to get the same lights to stop flashing for over a year now. I seen this post and read the answer. I immediatly went out and tried it and it re-calibrated the AC so quick I was shocked.
    All you need to do is start your van. (if you are unsure what knob or lever is which I am looking in the manual for proper terms) Then slide your temp lever all the way to the right (full cold). Then turn the Mode Control to 'panel' (the one that sends air to your face only). Then turn the 'blower switch' to all the way to full. Now go to the leftmost three buttons. Press the top one (rear wiper on constant) and the bottom one (rear wiper washer fluid). Hold these two for a few seconds. Once the lights come on solid then begin to flash you can let go. The AC will now calibrate. You will feel the air blow out of all the different zones at different intervals and see lights come on and go off. Then after a minute or two the top bottn you pressed will be slowly flashing. This means it has been completed (I actually let it run for 5 more minutes just in case something else started blinking). Press the last flashing button and you are done. I then turned off the van and started it back up and now I don't have those infernal blinking lights for the first fifteen minutes of my drives. Thank you to whoever it was who posted the initial answer to this problem.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Operators manual chrysler grand voyager 1998


Junk yard or maybe a Chrysler dealer can still order one.

Sep 27, 2014 | 1998 Plymouth Grand Voyager

1 Answer

Whining noise on acceleration in Chrysler Voyager


Front differential that is inside the transaxle

Normally when you rebuild that transaxle you
do not remove the diff or change it's bearings

Jan 28, 2013 | 2000 Chrysler Grand Voyager

1 Answer

2000 chrysler grand voyager over heating when ac is on changed belt and tensioner pulley


YOUR FAN FOR THE AC IS NOT WORKING THE FAN HAVE TWO SPEED 1 FOR NORMAL COOLING AND THE OTHER FOR YOUR AC CHECK AC FAN RELAY IS THAT IS GOOD CHECK FAN MOTOR AND ALSO CHECK CONNECTION ON FAN MOTOR

Sep 24, 2012 | 2000 Chrysler Grand Voyager

1 Answer

Where is shift solenoid on chrysler grand voyager 2001


All the transmission shift solenoids are located inside the transmission, you must remove the pan and they are attached to the valve body.

May 16, 2011 | 2000 Chrysler Grand Voyager

1 Answer

Ac gives out then van overheats


Both of these need the serpentine belt to run. Maybe its too loose. may need replacement or tensioner

Aug 08, 2009 | 2000 Chrysler Grand Voyager

1 Answer

Washer bottle motor 1998 chrysler grand voyager 3.3 LX


should be located at the bottom attch to bottle follow the plug wire for washer motor and u will see and u will see

Jul 01, 2009 | 1998 Chrysler Town & Country

1 Answer

Washer bottle 1998 chrysler grand voyager 3.3 LX


If you are talking about the window washer bottle and the cooling system bottle the answer is no. The washer bottle goes to the winshield washer ports and the coolent bottle goes to the radiator

Jun 29, 2009 | 1998 Plymouth Grand Voyager

3 Answers

Chrysler voyager 2000 blocked by ''alarm set''


Hey I got a 1998 Chrysler voyager and can not get rid of alarm set point as you said I am on the forum and still do not go if you can help me on str33t_styl3@yahoo.com mail message pretty please

Feb 10, 2009 | 2000 Chrysler Grand Voyager

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

603 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...