Question about 2004 Jeep Liberty

1 Answer

Looking for the location of the spark plugs on the 2004 jeep liberty. I want to replace them but can't even see where they are located.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 770 Answers

Locate the distributor. The wires coming from the distributor, with the exception of the coil wire, all go to a spark plug. Simply follow the wires to the plugs. Good Luck! I hope you find this to be very helpful!

Posted on Feb 05, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the position of radiator fan relay on jeep liberty 2006

no idea to be honest earlier jeeps had then at the front of the wing down below as i remember ?? newer one would i imagine be in the electrical box under the bonnet near the battery

Dec 02, 2016 | Jeep Cars & Trucks

1 Answer

Where are the spark plugs located?

Each spark plug should be under the coil for that cylinder. They are in the middle of each valve cover.

Feb 16, 2015 | 2010 Jeep Liberty Limited Edition 4WD

1 Answer

Hi there, We think the fuel pump on our 2004 Jeep Liberty needs fixing. Can we do this ourselves? Where exactly is the fuel pump located in the Jeep? Thanks, Gen

Thanks for choosing FixYa and welcome to the site. Jeep Liberty electric fuel pumps are almost always located inside the fuel tank, but there are some vehicles where the pump may be located along the frame rail or mounted to the body near the fuel tank. It can be done by yourself but when it is in the tank, it is not an easy job. You will have to take the tank off to get to the fuel pump.

Apr 11, 2011 | 2004 Jeep Liberty

1 Answer

Where are the spark plugs located at in my 2004 Jeep Liberty?? Would like video or pics....

The plugs are loated under each coil pack for every cylinderca82c8a.gif 1. Using compressed air, blow out any dirt or contaminants from around top of spark plug.
2. Check condition of coil O-ring (2) and replace as necessary. To aid in coil installation, apply silicone to coil O-ring (2).
3. Position ignition coil (1) into cylinder head opening and push onto spark plug. Do this while guiding coil base over mounting stud.
4. Install coil mounting stud nut (2). Tighten to 8 N·m (70 in.lbs).
5. Connect electrical connector to coil by snapping into position.
6. If necessary, install throttle body air tube.


Apr 19, 2010 | 2005 Jeep Liberty

1 Answer

2004 Liberty -- Tire Sensor

Turn Ign. key on but only to on position do not turn to start position, now look at dash instrument cluster for a 4 tire diagram of vehicle as if you were above the vehicle looking down. It will show middle of cluster and even show all 4 tires in proper position on vehicle . Now when one tire is low below 30 psi it will light the tire in the position on vehicle located for you the tire with issue...

Sep 11, 2009 | 2004 Jeep Liberty

1 Answer

Where are the spark plugs on a 2004 jeep liberty?

Many new cars have internal"spark plugs", kinda like the glow plugs on a diesel motor. Look in you manuel and they might have written some kind of explanation. My friends 2001 Ford F-150 truck has no spark plugs and it baffled us until we knew the answer, They just didn't have any

Jul 11, 2009 | 2004 Jeep Liberty

1 Answer

Why is my 2004 Jeep liberty sport Brake lights not working. I have replaced the bulbs and fuses, what else can i do?

The brake light switch is probably bad. It's usually located up under the dash and is connected to the brake pedal shaft. It could even be unplugged.

Jun 18, 2009 | 2004 Jeep Liberty

1 Answer

Iat sensor

It is located at the rear end of the intake manifold. It is connected to a plug and wiring harness. you need to remove it from the wire clipon plug and replace it .If it is a 2.4L engine. If it isa 3.7l basically near the same location.

Aug 30, 2008 | 2004 Jeep Liberty

Not finding what you are looking for?
2004 Jeep Liberty Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides