Question about 1986 Toyota Camry

1 Answer

99 camry rear window wont roll up. there is no sound

I can force the window up but only about 3/4 the way. there was some grinding noise before it stopped working. The other windows do work.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 200 Answers

The regulator gear is stripped, a auto glass shop is where to go. Doing it yourself can be hazardous. The window weight is counter-balanced by spring tension.

Posted on Feb 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I correct wind noise on drivers side door / window 1999 Camry?


There may be a torn, missing, or loose door gasket. If you inspect the seal and find torn or missing segments, repair or replace. If the seal is intact, the the most likely cause is a gap in the door seal near the top rear of the door. This happens over time because the door frame can actually get bent slightly outward. It is so little as to not be visible, but you can hear the wind noise. The way to get the noise to stop is to open the door and roll the window all the way down. Then, holding the door firmly, grasp the upper rear corner and pull it inward (toward to the car). A couple of sharp tugs will usually do the trick. I know it sounds silly, but it works. BE SURE TO HAVE THE WINDOW DOWN OR YOU COULD SHATTER THE GLASS!
The door frame is quite thin compared to other car body parts and will bow/bend if you pull on it. Start out carefully and if you don't get the results you want, try again with more force.

Nov 21, 2014 | 1999 Toyota Camry

1 Answer

Recently replaced the original equipment front brake pads on a 1997 Toyota Camry V-6 with ceramic brake pads. Also replaced the front brake rotors. Used disc brake quiet/lube at time of installation. I am...


You did not mention working on the rear brakes, so I must assume that the rear brakes are still original equipment. Perhaps the grinding noise is coming from the rear.

Dec 16, 2010 | 1997 Toyota Camry

1 Answer

99 Silverado - window will not roll back up


this is a braided cable window lift type regulator. the grinding sound comes from the cable being chewed up by the lift motor after the plastic guides have failed. the regulator is easy to replace, 10 mm nuts (2 hold the glass & 4 or so hold the regulator to the inner door panel). loosen the 2 that hold the doorglass (spreading the saddle type attachment at the bottom of glass). push the glass all the way up and tape into place. remove the remaining nuts that hold the regulator, unplug the motor's electrical connection and install new regulator. remove tape from glass allowing it slide down to a visible place to tighten the glass attachments and install the door panel.

Sep 14, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

92 Toyota Camry Downshift into 3rd gear problem


is your transmission manual or automatic

Jun 18, 2009 | 1992 Toyota Camry V6

1 Answer

The friver side windowmad a grinding noise when I


the window regulator sounds like it needs replaced

May 16, 2009 | 2003 Mercury Mountaineer

2 Answers

Divers window won't roll up my Camry


No won't be fuse. My guess is there is something faulty with the main controller. You could probably verify this by trying the switch on right rear passenger door. If it works there then the problem is at the main controller in the driver door. Could be a loose wire or the switch itself is broken.

May 13, 2009 | 1986 Toyota Camry

1 Answer

99 Toyota Camry one of the rear seat belts won't retract


You have to actually unbolt the belt holder behind the seat. Then from there you can check to see if the spring still works. You'll probably have to take the cap off it, wind the spring-load, then put the cap back on. If you can get to it, it's not too difficult. I recommend another pair of hands to help hold if they're available. You'll also want to make sure you've rolled the belt up as much as possible before before you coil the spring-load.

Apr 25, 2009 | 1999 Toyota Camry

1 Answer

Not working = power rear window, power antenna, starter


it looks like the starter is bad, install a new one. the antenna gear is broken, needs to be replaced and you need to check the rear hatch for any obstructions

Apr 21, 2009 | 1999 Toyota 4Runner

1 Answer

Rear power window wont move makes grinding type noise


it is the window regulator your motor is ok this is a very common thing onBMW

Mar 31, 2009 | 2006 BMW 5 Series

Not finding what you are looking for?
1986 Toyota Camry Logo

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...