Question about 1997 Chevrolet Monte Carlo

1 Answer

How to replace front passenger side barings? - 1997 Chevrolet Monte Carlo

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 645 Answers

Take off wheel. remove tie rodend, remove control arm at ball joint. remove axle nut pull axle out of hub, take brake caliper and rotor off should be bolts holding hub in place.

Posted on Feb 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I locate the camshaft sensor on a 2005 ram 1500 slt 4.7


passenger side head front of exhaust manifold can't see it from top barely see it from bottom kinda got to put in blind

Apr 19, 2015 | 2005 Dodge Ram 1500

1 Answer

Fuse blows out 5-10 min after replacement


Check all your wires ,make none have rubbed and exposed the bare wire .vibrations might cause the wire to short out on metal

Apr 01, 2014 | 2005 Chevrolet Suburban

1 Answer

2011 Legacy with front light issues


Interesting question. Bulbs do burn out, but premature failure is often caused by overvoltage from the alternator. Have your dealer check the alternator for correct voltage AND waveforms. You can check it yourself with a multimeter. If the battery voltage is more than about 14.5Vdc, eg 15+, the alternator has to be replaced.

Jan 22, 2014 | 2011 Subaru Legacy

2 Answers

Where is the PCV Valve located on a 1993 Cutlass Ciera S with 3.3 V6?


The PCV filter is located in the air cleaner housing and must be replaced every 50,000 miles (80,000 km).

  1. Remove the air cleaner housing lid.
  2. Slide back the filter retaining clip and remove the old filter.
  3. Install the new filter, replace the retaining clip and replace the housing lid.

Jun 13, 2011 | 1993 Oldsmobile Cutlass Ciera

1 Answer

99 yukon denali drivers side turn signal in rear tail light not working, i replaced bulb and still nothing, I looked at the connections and wires and found nothing, front turn signal blinks fast, passenger...


The circuit board needs to be replaced. Which is the board that the bulbs sit in. If you remove the turn signal bulb. You will notice the bulb socket will be slightly burnt inside. I had the same problem with my 99 Denali and replaced the circuit board for $35.00. Now everything is fine.

Feb 01, 2011 | 1999 GMC Yukon Denali

1 Answer

How to replace front (by driver and passenger) interior lights in dodge grand caravan


If you are trying to fix the overhead lights the ones that you push?
All you need to so is take a small screwdriver and put some pressure on the outter side (drivers side- put scrwdriver in the drivers side and repeat for the passengers side) NOT TO MUCH PRESSURE and pull down, it is on a hinge and will swing open and you will see the bulbs, pull them out and put the new ones in but do not touch the new bulbs with you bare skin. now all you need to do is just push the lense up till it clicks and give it a few trys. hope it helped!

Dec 06, 2009 | Dodge Grand Caravan Cars & Trucks

1 Answer

Rear passenger side wheel/brake locking at first touch of pedal


You possibly have air in your lines. When you bleed them you need to start at the rear passenger, then rear driver, then front passenger and then front driver. If you are certain you have no air in the line then you have a bad brake hose/brake line. Replace this and your problem should go away. If not then the culprit should be the distribution or master cylinder. I hope this helps.

Jun 21, 2009 | 1988 Chevrolet S-10

1 Answer

Both wipers will barely move 2000 impala there was a lough pop when they were working and now the passenger side does not move and the drivers side moves about half way


sounds like the motor is dying and needs to be replaced... that pop you heard was either the linkage coming apart on the passenger side... or the motor again.

Feb 17, 2009 | 2000 Chevrolet Impala

2 Answers

1994 toyota 4runner front diff.seal replacement on passenger side


it should be the exact same process just with a little longer axel shaft

Jan 11, 2009 | 1984 Toyota 4Runner

Not finding what you are looking for?
1997 Chevrolet Monte Carlo Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...