Question about Chevrolet Camaro

1 Answer

How do i take out a ignition switch out from a 77 camero and put a new on in

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 564 Answers

The ignition switch is at the bottom of ur steering column,,in side ur car,,under dash board,,there is a rod that comes down from ur key calender,to the ignition switch,,theirs two little screws that hold it on ,,take off wire connector,,replace,,(((make sure rod goes back in same hole on the new ignition switch)))

Posted on Feb 08, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 77 chevy ignition wont let me start it

add a push start button its cheap and easy 2 wires one connected to positive post of battery 2 nd wire connected to starter place them on push start switch and thats that

Jun 25, 2013 | 1983 Chevrolet Silverado

1 Answer

If I put a new ignition switch in a 97 camero does the security system need to be reprogrammed?

Yes and no. The vats system is not reprogramable like the newer passlock and passkey systems. It must be replaced with a original GM part. No after market. If not, the antitheft system can't pass on the correct signal from the key to the theft deterrent module, and the antitheft system will shut off the starter and/or the fuel injectors. It IS possible to bypass this system. This link explains.

Jan 30, 2012 | Cars & Trucks

1 Answer

I have a 1995 camero and it wont stop turning over ...had to disconnect battery

Ignition switch is defective. Replace it. Not the key lock but the ignition switch, normally mounted under the dash on the steering column.

Apr 23, 2011 | 1995 Chevrolet Camaro

1 Answer

How do i change the starter in my 1993 camero

disconnect the red terminal from battery. jack up car enough to get under. secure with jack stands. near rear of engine under car, is the starter. unplug electrical harness from starter. remove bolts. as you remove the bolts, starter will come down. remove, put new one in. put bolts in, tighten bolts. plug electricfal harness in to new starter. lower car from jack stands. connect red terminal to battery. if you have an alarm, put key in ignition to on position before connecting battery.

Sep 18, 2010 | 1993 Chevrolet Camaro

1 Answer

My ignition switch on a 95 chevy camero has locked up and wont turnsometimes if you giggle the steering wheel it will turn over but it has really jammed now

If you can remove the ignition lock assembly and take it to a locksmith they can rekey it for about $20.00.With age the pins in the lock will start ti jam.

Jan 21, 2010 | 1995 Chevrolet Camaro

1 Answer

Need help please can u help 1996 camero v-6,

check the compression is that checks out check your spark plugs and alternator and ensure that the spark plug wires are in the correct fring order in the block and on the distributor

Nov 04, 2009 | 1996 Chevrolet Camaro

1 Answer

The ignition lock is jammed

this happened on my 74 corvette. I had to replace the ignition key cylinder chevy had a pretty common problem with this if I remember correctly there is a small hole where you put the key in you take something like a paper clip and insert it in the hole this releases the cylinder and it pulls out replace with a new cylinder which just pops in

Oct 23, 2009 | 1978 Chevrolet Chevette

1 Answer

Engine will not turn over or make much of a sound.

It sounds like it is probably your ignition switch. Either that or your starter selenoid.

Jun 19, 2009 | Volkswagen Beetle Cars & Trucks

1 Answer

Security light on in a 2002 camero I cannot start the car

the electrical part of the ignition switch needs to be relearned

Apr 23, 2009 | Chevrolet Camaro Cars & Trucks

1 Answer

77 tbird ignition install

Where is the starter located on a 77 thunderbird?

Oct 26, 2008 | 1983 Ford Thunderbird

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides