Question about 2001 Hyundai Accent

2 Answers

Replaced fuel pump and spark plugs but veichle will not start getting spark

Posted by on

  • james_w_35 Feb 05, 2010

    it has the 1.6 4 cylnder

  • tim mcgrath May 11, 2010

    which motor

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

It will be your coil packs. these are cheap enough to replace and will almost definately solve your problem. they come as a single unit ready to go

Posted on Feb 13, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 617 Answers

How much fuel pressure you have? when replaced pump, get the return nozzle properly positioned

Posted on Feb 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06 Stratus shut down on highway replaced starter plugs wires n coil pack won't start


First thing you need t poo do is determine if it is a spark problem or a fuel or compression problem.pull a plug out hook it back up to a plug wire and touch the bottom of the spark plug to the block or a bolt.Then have someone try to start the car.if it sparks then it's most likely the fuel pump.to see if it is a fuel problem get some starting fluid and spray it into the intake manifold then try to start it make sure you have put the plug back in first.if it runs then stalls replace the fuel pump relay if it still doesn't start replace the fuel pump

Apr 16, 2014 | Cars & Trucks

1 Answer

Why does my 86 2.9 l. ranger kill spark plugs


your truck is running too rich with fuel if you have a carburator have it check

Sep 18, 2012 | Cars & Trucks

2 Answers

Car turns over but wont start what is wrong?


The car is either not getting gas or not getting spark. It could be a weak battery, bad spark plugs or wires, bad coil pack/distributor, clogged fuel filter or spark plugs, or a defective fuel pump. These are the most common causes of this problem and and except the fuel pump and sometime fuel filter are relatively easy to replace yourself. Good luck and happy hunting!

Mar 04, 2011 | 1997 GMC Yukon

1 Answer

I have a 2001 Rio 145,000. It started losing power (speed) taking off , then it just died, tried starting but would not turn motor, got it home and the starter was working but the car would not...


test for fuel from fuel pump check for spark from plugs check all fuses if not getting spark replace coil pack if not getting fuel replace fuel pump

Dec 21, 2010 | 2001 Kia Rio

1 Answer

My car wont start,you turn the key , and sounds like it's going to start but it just wont' i already take to the mechanic he had the car for about 2 months i get the car back ; he said it was fix and now...


FIRST GET A SPARK TESTER TO SEE IF YOU ARE GETTING SPARK AT SPARK PLUGS.IF NOT CHECK IGNITION MODULE FUSE.IF FUSE GOOD HAVE CAR HOOK UP TO SCANNER LOOK FOR IGNITION MODULE FAULT CRANKSHAFT SENSOR FAULT AND PCM FAULT.IF ALL LOOK GOOD SO FAR.CHECK TO SEE IF FUEL PUMP WORKING.CHECK PUMP FUEL PRESSURE IT SHOULD BE 41 - 47 PSI. IF NOT REPLACE FUEL FILTER STILL LOW REPLACE FUEL PUMP.IF FUEL PUMP NOT WORKING AT ALL CHECK FUEL PUMP FUSE AND RELAY.IF BOTH IS GOOD FUEL PUMP AT FAULT.BUT SCAN TO CHECK FOR PCM FAULT CODES IT CONTROL SPARK AND FUEL SYSTEM.MAKE SURE SPARK PLUGS AND WIRES IS GOOD. ALSO CHECK FUEL INJECTORS FUSE ALSO.

Jun 08, 2010 | 1999 Oldsmobile Alero

1 Answer

The 1991 mr2 intermittently will not start. you


Sounds like you have a bad one-way check valve in the fuel pump. It is not serviced seperatly. A replacement fuel pump might be your answer.

Oct 18, 2009 | 1991 Toyota MR2

1 Answer

Ok i have a 1999 hyundai accent wont start changed fuel pump and it started ran very bad very! turned it off wouldnt start back up again checked spark plugs no spark and no power going to fuel pump we are...


Changing the pump doesn't affect the spark so lets start a that the beginning?? Why was the pump replaced and was it running fine before changing the pump? Also plugs could be fouled as well but if it was working fine before the fuel pump it will be fine afterwards if getting gas and the fuel pump was the problem., Also how did you verify no spark??

Oct 10, 2009 | 1999 Hyundai Accent

3 Answers

"Cranks, but won't start". Replaced fuel pump, CKP, ICM & nothing


If the engine cranks over normally when you attempt to start you car, but the engine does not start, the problem may be NO FUEL, NO SPARK or NO COMPRESSION. The engine needs adequate fuel pressure, a properly timed spark and normal compression to start.


1) To find why the engine won't start, remove the air inlet tube from the throttle body, push the throttle open and spray a small amount of aerosol starting fluid into the engine. Crank the engine. If it has spark and compression but NO FUEL, it will start and run a few seconds before dying. If it does NOT start, it probably has NO SPARK.

2)Another method to check for spark is to pull a spark plug wire off of a spark plug (if it has plug wires, coil-on-plug ignitions do not) and place the open end of the plug wire near a metal surface on the engine. Have a helper crank the engine while you watch for a spark. DO NOT hold the wire while doing this as it can shock you. If you see a spark, the problem is not spark, but most likely NO FUEL or NO COMPRESSION. If you do not see a spark, the problem is in the IGNITION CIRCUIT.

3)Proper fuel pressure is critical for fuel injected engines to start and run. You should hear the fuel pump inside the fuel tank buzz for a couple of seconds when the ignition is turned on (no buzz means the pump is not running and the engine is not getting fuel). You can smell the tailpipe for gasoline vapors after cranking the engine. If you smell gas, the problem is likely not fuel but NO SPARK. You can also remove the plastic cap and press the schraeder valve test fitting on the fuel rail to see if there is any fuel pressure to the engine (not a very accurate test because fuel pressure must be at a certain level for the engine to start, for that you need a gauge). Even so, no fuel at the fuel rail would tell you fuel is not getting to the engine..

Aug 27, 2009 | Chevrolet Camaro Cars & Trucks

4 Answers

93 chevy s10 wont start


Does it crank the engine ? If not take a look at the starter connections and the starter.Replace the starter if nessesary.
Ok, now that you got the most common problems out of the way, you should check for spark at the spark plugs. Remove a spark plug and attached to the wire. Get a good pair of rubber gloves and put the thread of the plug to ground and crank the engine. The spark plug should spark a bluish spark. If it has an orange spark the spark plug or wire may be bad. if it does spark fairly good.

Check the fuel pump. if it has an electric fuel pump you should hear it when you turn the switch to on. It is a whirring sound. if you can't hear it. the Pump is bad or the shutoff valve turned off the fuel system. Check it to see if the button is up. If it is then the valve clicked off. Press it down. If it is down and there is no fuel the fuel pump is bad.

If it is a mechanical pump, take off the hose to the carb if it does have one. crank the engine . It should pump gas right away.

If it does have spark or fuel to the sytem, then it is a sensor or other problem.You will have to get a trouble code for it. to narrow everything down.

Check the timing belt or chain to see if it is still good and tight. If it is not your timing belt or chain skipped or cut off. you will have to replace it.

I hope you can get some help from this info . good luck

Feb 06, 2009 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
2001 Hyundai Accent Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...