Question about 2000 Chevrolet Silverado

1 Answer

Wiper module location for a 2000 silverado - 2000 Chevrolet Silverado

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

I assume you are looking for the circuit board.If you look at the fire wall on the drivers side you will see the wiper motor with a black cover held on by 3 torx screws.There is also a large wire connecter that comes in from the side.Not sure on the newer connecters but the older ones had a red keeper that had to be pulled out to remove the wirering connecter.Remove the 3 screws and the board is directly behind it.wiper module location for a 2000 silverado - 5375052.jpg

Posted on Feb 05, 2010

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 12650 Answers

SOURCE: location of wiper motor 1999 chevy silverado

under hood drivers side on fire wall between engine and brake master cylinder take off wiper arms slide tab at bottom lift off -- un- screw cowl the cowl is in 3 parts -unscrew center with hood closed first the screws are recessed about an 1-1/2 below the top of cowl open hood and unscrew the both sides of cowl and remove than remove center watch the washer hoses now will have access to the wiper transmission mark where transmission is before unbolting motor and transmission remove motor install is in reverse

Posted on Feb 10, 2010

  • 7353 Answers

SOURCE: 1999 Silverado windshield wipers only work on high

Module. call your dealer, it may be covered under a RECALL.

Posted on Sep 29, 2009

duane_wong
  • 6826 Answers

SOURCE: ware is the wiper module

Follow the Dark Blue/White wire or Brown/White wire from the Multifunction Switch to the wiper module according to the schematic.
Also, one can trace the wires from the windshield wiper motor to the wiper module by peeling away the wiring loom and looking for a Yellow/Red wire that leads to the module.
---
Windshield Wiper Motor Removal & Installation To Remove:

  1. Remove the mounting arm and pivot shaft assembly.
  2. Remove the windshield wiper motor cover.
  3. Remove the clip.
  4. Disconnect wiper transmission linkage.
  5. Remove the bolts.
  6. Remove the motor.
To Install:
  1. Position the wiper motor.
  2. Install bolts. Tighten to 10 Nm (89 in. lbs.).
  3. Connect wiper transmission linkage.
  4. Install clip.
  5. Install wiper motor cover.
  6. Install mounting and pivot shaft assembly.
prev.gif next.gif

Posted on Oct 28, 2010

  • 844 Answers

SOURCE: Wipers on 2006 Silverado will

try unplugging the wiper motor and plug in a couple quick times, the actuator might be stuck.

Posted on Apr 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to located and replace pulse module on winshield wiper


its part of the wiper motor under the plastic cowl bottom of windshield outside the car

Mar 05, 2015 | 2000 Chevrolet Silverado

1 Answer

Wiper control module location


the wipers are controlled by the lighting control module

Apr 10, 2013 | 2000 Lincoln Town Car

1 Answer

02 silverado. wipers only work on high. No delay speed and no low speed. Will not park


Replace the wiper module. Cardone at around $35-$50. This is the black cover under the hood, driver's side with 3 screws and about 4" x 4". Takes about 3 minutes to change.
A1 Cardone 81158PB Remanufactured Wiper Motor Pulse Board Module

May 19, 2011 | 2002 Chevrolet Silverado 1500

1 Answer

Delay wipers only work on high speed on 2000 chevy silverdo 1500 truck no delay


Hello, my name is Ben and I can help you with this problem. This is a very common problem with Chevy. You need what is known in most vehicles as a "pulse board". The pulse board is located inside the wiper motor control module. On many vehicles the pulse board is replaceable, unfortunately on your Silverado you must replace the entire Wiper Motor Control Module which is bolted onto the top of the wiper motor. To get to the wiper motor, first remove those little nut covers on the big end of the windshield wiper arms, if you slip a small screwdriver or your fingernail they just pop off. Now unbolt the windsheild wiper arms, before removing the wiper arms, mark their location on the windsheild with a grease pencil or magic marker. The arms are hard to remove, you need to kinda wiggle and pull at the same time, now that long plastic cowl needs to come off, those clips at the front edge just slide forward, then at each end lift up that rubber flap and remove those TORX screws. Remove the cowl and set it somewhere SAFE, it's easy to break. You will now see the control module mounted on the wiper motor, unplug the electrical connections and remove the TORX screws holding it to the motor. Assembly is the reverse of dis-assembly. If you have any trouble or questions, feel free to ask, Ben.

Nov 13, 2010 | 2000 Chevrolet Silverado

1 Answer

Windshield wipers will not shut off


Hello, my name is Ben. This is a very common problem for GM. You have a wiper motor control module and it is most likely defective. The module is bolted directly onto the wiper motor which is mounted to the firewall under that long plastic cowl just in front of the bottom edge of your windshield.

Jun 08, 2010 | 2003 Chevrolet Silverado 2500HD

1 Answer

2000 silverado wipers only work on high


Hello, this is a very common problem on this model vehicle. Your wiper motor control module is bad and will need to be replaced. The motor is underneath the "cowl vent" at the rear of your hood. You need to pop the cover cap off the windshield wiper arms, then unbolt the wiper arms and remove them, they are tough so spray some WD-40 on them and pull and wiggle. Now at the rear of that plastic cowl at the two rear corners lift up that flap and unscrew those 2 screws, one at each end. Next remove the clips at the front of the cowl, just pull them forward. Now lift up the cowl and unplug the washer hose. Just a word of advise, lay the cowl in the bed so nobody steps on it. Unplug the electrical connector going into the module which is mounted directly to the wiper motor and unbolt the module. Bolt on the new module. Test the wipers now and if all is well, put the cowl and wipers back on and you will be done.

Mar 01, 2010 | 2000 Chevrolet Silverado 1500

1 Answer

Where physically is the blower motor resistor located for 2000 Chrysler Grand Voyager? Checked underneath glove box but underneath is encased in plastic. Need to remove plastics?


open hood, at right side of vehicle underneath wiper module, at firewall, no need to remove wiper module.let me know if this help

Nov 19, 2009 | 2000 Chrysler Grand Voyager

1 Answer

1997 Silverado 2500HD. The connection to the wiper motor becomes loose causing the wipers to intermittently. The motor is fine, the connection is the problem. Is there anything I can do without replacing...


This is your wiper control module that is causling the issue. This is located on the motor and only two screws are holding it in place. Remove the screws, pull the module off and replace the module. It should take ten minutes once you have the new module. Hope this helps.

Oct 22, 2009 | 1997 Chevrolet C/K 2500

1 Answer

1999 Silverado windshield wipers only work on high


Module. call your dealer, it may be covered under a RECALL.

Sep 29, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Where is the blower motor resistor on a 2000 caravan


The resistor is located under the wiper module on the passenger side firewall. You probably will need to remove the wiper module assembly to get to it.

Nov 29, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
2000 Chevrolet Silverado Logo

Related Topics:

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...