Question about 2005 Chevrolet Equinox

1 Answer

How do I change my driver side wiper blade on 2005 equinox

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 677 Answers

Www.ehow.com
There are 2 different styles GM uses. Watch the video and you will see both kinds, easy to do takes only a few min.

Posted on Feb 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 equinox rear wiper replacement


I just replaced mine. Lift the rear wiper up as far as it will go. which is not very far. Place your fingers on each end of the wiper and pull down. The blade is held in place by a clip. Gentle pressure will downward toward the window will cause it to disconnect. An extra pair of hands to hold the plastic cover up helps. Note the orientation of the blade when you disconnect it. The replacement blade may have a clip on it which may need to be removed. Place the replacement blade in the same orientation as the one that was removed and clip back in place.

Sep 16, 2012 | 2011 Chevrolet Equinox

1 Answer

How do you change the rear wiper blade of a Freelander?


You have to unclip it. Usually by pushing wiper blade to right (pass side) while holding wiper arm. Look to bottom side (facing window) some have small plastic button molded into them you have to push to release.

Feb 25, 2011 | 2005 Land Rover Freelander

1 Answer

I need to have 'step-by-step' instructions for replacing the driver side windshield wiper arm on my 2000 Ford Explorer. Can you help me with this?


  • Turn your wipers off, using the stalk on the left side of your steering column. Turn your ignition off and remove the key.

  • 2

    Pull the wiper blade up to lift it to the service position. Pull the front part of the blade down to position it at an angle.

  • 3

    Pull back the lock pin on the center part of the wiper blade (where it connects to the wiper arm). This unlocks the blade from the wiper arm.

  • 4

    Grasp the blade on each side and pull it down (away from the extended wiper arm) to release it from the "U" clip.

  • 5

    Repeat the process for the other wiper blade, if desired. Removing the driver's side and passenger's side wiper blade is the same.

  • 6

    Install the new wiper blade. Open the lock pin on the new blade, and then insert it into the wiper arm "U" clip. Close the lock pin and lower the wiper blade to its normal position.

  • Jan 29, 2011 | Ford Explorer Cars & Trucks

    1 Answer

    How do you change the windsheild wiper so I can replace it


    changing the wipe blades is a tough one. Pick the blade up in one hand. In the center of the blade assembly, underneath, there is a button. You'll need a very small screw driver or something small to press the release. push on the release and pull the wiper blade off.

    Jul 06, 2010 | 2005 Chevrolet Silverado

    2 Answers

    The passenger side wiper blade arm moves manually but not when wiper control is engaged only the drivers side wiper works can anyone help with this


    is the stud stripped or u might need to pull the cover off at the bottom of the wiper and tighten the nut.

    Mar 28, 2010 | 2006 Chevrolet Equinox

    1 Answer

    Windshield wipers on 2007 VW jetta not swiping


    wiper gears may be broken, got to junk yard and buy motor and gear assembly for windshield wipers, should only take an hour to change out.

    Feb 15, 2010 | 2007 Volkswagen Jetta 2.5 Sedan

    1 Answer

    How do I replace wiper on passenger side on a 2005 Chevy equinox?


    wipers snap in place onto the arm. you must hold the tab in to release it off the arm when removing it. if iit is the arm you like to remove the arm has a metal tab at the base which needs to be pulled out to release the lock. that way the arm can be removed

    Feb 06, 2010 | 2005 Chevrolet Equinox

    1 Answer

    2005 tahoe wiper replacement


    My tahoe has a plastic piece just to the left of the metal attaching arm. It is easiest to see on the driver side wiper. There is just enough room to slip a flat blade screw driver into and then pop upwards. After this clip is popped, slowly move the wiper blade to the right as you pull that clip further upward. The blade can now be removed. Of course if you have a different type blade this will not work.

    Dec 14, 2009 | 2006 Chevrolet Tahoe

    2 Answers

    2005 Chevy Equinox Wiper blade hits edge of window


    The 23 should work on the drivers side but you will need a 19" on the passenger side.
    Hope this helps and let me know.
    Regards,

    Feb 18, 2009 | 2005 Chevrolet Equinox

    Not finding what you are looking for?
    2005 Chevrolet Equinox Logo

    Related Topics:

    167 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    79865 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6927 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...