Question about 2003 Jeep Wrangler

1 Answer

What should the fuel pressure be for a 2003 jeep wrangler

Posted by on

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 617 Answers

1. Connect fuel pressue gauge, start engine
2. Observe test gauge. Normal operating pressure should be 339kPa+/- 34 kPa (49.2 psi +/- 5 psi
3. Turn vehicle off.
4. Pressure should not fall below 30 psi for 5 minutes

i have these directions plus more about if want in pdf format, need email address to send if want

Posted on Feb 06, 2010

Testimonial: "Thanks a lot. I knew how to do the test but didn't know the specs. Appreciate the help."

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you correct fuel pressure on a 2003 Jeep Wrangler?


I don't think it's your fuel pump have you tried changing your plugs or doing a full tune up had someone that had similar problem changed plugs wires and cap and rotor and it runs great now even these newer cars need maintenance. Oh and the cleaners you are putting in your gas are just alcohol same thing that's 10% of your gas don't waste your money many studies have been done and have found them useless.

Jul 21, 2014 | 2003 Jeep Wrangler

1 Answer

2002 jeep wrangler fuel pressure issues


What is the fuel pressure suppose to be on a 2002 jeep wrangler

Aug 21, 2012 | 2002 Jeep Wrangler

1 Answer

How to check fuel pressure on a 2004 jeep wrangler 4.0. where is the the fuel pressure check valve? they are normaly on the fuel rail, but this jeep does not.


Nope it does not. You need to pull the fuel line from the fuel rail and use a special hose adapter that is installed in between. A gauge is then attached to the adapter and fuel pressure can be read.

Aug 07, 2012 | 2004 Jeep Wrangler

1 Answer

1994 jeep wrangler engine missing at mid range


check fuel pressure regulator and fuel pressure. should be between 45-50 psi and hold steady.. shut off car and let sit 5 min if pressure drops more than 10 lbs one of the two is bad...

Jul 07, 2012 | 1998 Jeep Wrangler

1 Answer

Replaced fuel pump and it keeps popping out why?2003 jeep wrangler


Does it lose power under acceleration? When you changed the pump did you change the strainer also? You should change the fuel filter if you have not done so. The other thing to check would be the fuel pressure regulator.

Mar 06, 2012 | 2003 Jeep Wrangler

3 Answers

1998 jeep wrangler starting problems


There are several things you can do if you haven't done so already, Check voltage at ignition coil, as soon as the engine starts to turn over there should be voltage. If not, the crank sensor is not triggering the ECM quickly.... on 98-99 wranglers, this was a problem area. Check terminal connectors at the ECM, clean and secure, another area of concern.The module on the side of the throttle body is the air idle control 'motor' as jeep calls it. Over time they tend to carbon up and it results in bad air/fuel mixture and yet fails to send a fault code, you can remove & clean also the O2 sensor in front of the cat. convertor.remove & clean. Check fuel pressure, you should have some residual PSI. Treat fuel system with a good treatment...I like the Lucas products, their fuel system treatment and injector cleaner burns hot & clean.
I hope these suggestions help...and the wrangler returns to top form...good luck.

May 14, 2009 | 1998 Jeep Wrangler

1 Answer

89 Jeep wrangler runs rich


check fuel pressure regulator and vaccuum going to it. likely it's allowing too much fuel in.

Mar 16, 2009 | 1989 Jeep Wrangler

1 Answer

1999 Jeep wrangler runs rough


Check the gas, could be water in it or drive the car with a fuel pressure tester connected to it and watch to see if you lose pressure.
Normal pressure while driving is about 30 to 40 psi

Oct 07, 2008 | 1999 Jeep Wrangler

Not finding what you are looking for?
2003 Jeep Wrangler Logo

Related Topics:

295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...