Question about 2003 Mitsubishi Eclipse Spyder

Open Question

WHERE IS THE egr vALVE LOCATED ON MY 2003 ECLIPSE SPYDER GTS (MANUAL SHIFT) ?

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ZJLimited
  • 17970 Answers

SOURCE: were is the egr valve located for mazda rotege5

2002 Mazda Protege5 with the FS2.0 Motor. The EGR Valve is located below the throttle-body. You must take off the Intake tube to get a good view of it. To replace it I think you might have to take off the throttle-body.

0335fe8.jpg

Fig. Exploded view of the intake manifold assembly with 2.0L (FS) engine

Good luck (remember rated this).

Posted on Jun 25, 2010

Ad
  • 98 Answers

SOURCE: 2003 GTS Eclipse EGR Valve

Both need to be done

Posted on Apr 04, 2010

  • 273 Answers

SOURCE: i have a 2003 spyder eclipse gts 3.0l how do i install a after market tachometer?

It's true that aftermarket electronics can goof up engine management electronics if improperly connected. Never use the ECM (PCM) harness as a supply for 12 volts or ground. Conversely, never supply 12 volts or ground to the ECM except from the original wiring in the harness. Some wires have voltage or ground only intermittently to the ECM as data, not power.

If your tachometer has instructions for installation in a car with DIS (no distributor), you will have to obtain an electrical diagram for your car. Some ignition systems have a tachometer output, others don't. Cars that don't have a tach output may have a wire that goes from the ECM (PCM) to the ignition module that can work for a tach signal. This set-up requires adjusting the tach (per instructions) to operate with this type of signal.

dttech suggested referring to the instructions of the tachometer that you wish to use. You can find instructions online for the better brands of tachometers, such as Sun.

Good luck from Detroit, MI.

Posted on Nov 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is egr solenoid on 2003 eclipse spyder GT V6? I have PO403 code on and most say that is issue.


there should be a diagram on the inside of the hood , if not follow this link , read through the thread and you'll get to the picture
diamante install problems Club3G Forum Mitsubishi Eclipse 3G Forums

Jun 29, 2014 | 2003 Mitsubishi Eclipse Spyder

1 Answer

Code P0405


CEL on, P0405
that dont effect engine running, nor can many more DTC>
DTC = errors.
405 is EGR.
if the egr is stuck open the engine stall.s
if it is not working dead, only the TEST FAILS.
true back to 1987 cars. (about)
its federal mandated test in the USA from then.

EGR is kinda simple on newer cars.
its a valve. and some have read back. telling the brain
hey, i didnt move.
id clean it first.
.
- EGR volume control solenoid valve
- EGR volume control solenoid valve harness is open or shorted
- EGR volume control solenoid valve circuit poor electrical connection
- EGR temperature sensor and circuit


Jun 25, 2014 | 2003 Mitsubishi Eclipse Spyder

1 Answer

03 spyder gts codes


This car has a 16 pin connector under dash in on drivers side with a OBD 2 code reader it will display them

Apr 18, 2014 | 2003 Mitsubishi Eclipse Spyder

1 Answer

Mitsubitsi 2003 spyder gts how do you replace rear 3 spark plugs.


You must remove the intake manifold to gain access to the rear plugs. Here is a picture of an 03 spyder that I did a tune-up on!! 956ab96.jpg

Oct 06, 2010 | 2003 Mitsubishi Eclipse Spyder

1 Answer

I cant find where the egr solenoid plugs in 95 mitsubishi eclipse gst trubo


egr transducer solenoid,,located at underhood, beside a/c idle up solenoid control, take alook at the vaccum hose at egr valve, its goes through the egr solenoid treansducer valve, picture later

Jun 25, 2010 | 1995 Mitsubishi Eclipse

1 Answer

EGR VALVE REPLACEMENT- I have the new part but there is not a gasket included. I assume a gasket would be necessary but I don't really know.


Best way to tell is to pull out and see. If they dont give you one with it tho it most likely will not have one.

Jul 02, 2009 | 2003 Mitsubishi Eclipse Spyder

Not finding what you are looking for?
2003 Mitsubishi Eclipse Spyder Logo

Related Topics:

1,222 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...