Question about 1993 Chevrolet S-10 Blazer

2 Answers

How do i take a starter off of a 1993 chevy blazer s10 i have the two bolts out and no matter how i try to pull it out it keeps getting stuck

Posted by on

  • smherman_101 Feb 04, 2010

    there was just the 2 there doesnt seem to be enough room to take it out

  • smherman_101 Feb 04, 2010

    there was just the 2 there doesnt seem to be enough room to take it out

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 1 Answer

You have to take the flywheel cover off. There are 6 bolts to that, one of which is very difficult unless you have the right tool.

Posted on Feb 06, 2010

Testimonial: "That's it I managed to get by with undoing all but the hard bolt however the small wire going to the starter I had to cut it and extend it. Thanks!!!!"

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Are there more bolts there might be 1 more.

Posted on Feb 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93 CHEVY S10 2.8 PILOT BEARING


Slide hammer with a inside gripping puller. I rented one from my local auto parts store.

Aug 31, 2017 | 1993 Chevrolet S-10 Blazer

1 Answer

How do you get to the torque converter bolts on a chevy s10 blazer 2003?


If you remove the starter, you can access the bolts through the starter drive hole... it isn't easy, but definitely possible.

Feb 02, 2013 | 2003 Chevrolet Blazer

1 Answer

New battery drains in two days on 93 chevy s10 blazer


Is the battery goind dead while the vehicle is sitting and just won't start? Or is it dying while you are driving it?

Nov 25, 2011 | 1993 Chevrolet S-10 Blazer

1 Answer

1993 chevrolet s10 blazer 4.3l clicks but wont start


Sounds like you have a bad spot on the starter armateur...and will need to replace the starter.

If its the original, and you have over 50K miles then its probably a safe bet that your starter is bad, and will fail totally soon...if thats not the case now.

Feb 02, 2010 | 1993 Chevrolet S-10 Blazer

1 Answer

How do I replace my starter?


Open hood.
Disconnect negative (-) batter cable
Locate the starter (under vehicle).
Remove electrical connections. (be sure to remember/take a picture/ make a drawing/ or mark which wires go to what posts)
Remove mounting bolts.
Remove starter, replace with new starter
Install mounting bolts
Install electrical connections

Jan 06, 2010 | 1990 Chevrolet S-10 Blazer

1 Answer

Fender replacement


there will be bolts under the hood down by the wheel well and in the door jam. take off all bolts and the fender will come right off. instalation is the same just reverse order

Jun 20, 2009 | 1993 Chevrolet S-10

5 Answers

93 chevy s10 blazer fuel pump replacement


try yhe pickup coil or ignition module wich are both located on the distributor or the igniton coil.im going through the same thing.all i have left to try is the ignition module.if i get it ill be sure to let you know

Jan 01, 2009 | 1993 Chevrolet S-10 Blazer

2 Answers

Removing starter from S10 blazer


Have you removed the 2 nuts making electrical connection to the starter? I just did this and was able to get the starter out. Could not get it out until I removed the 2 nuts.

Jun 21, 2008 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...