Question about 1998 Dodge Neon

1 Answer

Where is the IAT sensor located on dodge neon

Werer is the IAT sensor on a 1998 dodge neon

Posted by on

  • tim mcgrath May 11, 2010

    sohc vin c dohc vin y

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 677 Answers

Right next to the intake plenum.

Posted on Feb 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2003 dodge neon se odometer code says po 127 I need no what need to do want start or roll over but all lights work


code p0127 refers to intake air temperature (IAT) sensor---too high==causes--wiring short to ground--IAT sensor 2--mechanical fault---ECM

Mar 13, 2015 | Dodge Cars & Trucks

1 Answer

1998 dodge neon turns over but dont start


Pull ur plug wires and check if there is any oil in there if there is clean with carb cleaner and replace also check crank sensor and plug

May 28, 2012 | 1998 Dodge Neon

1 Answer

What is the iat sensor


IAT stands for intake air temperature sensor. This measures the temp of the air going into the intake. Usually attached to the intake manifold.

Jun 30, 2011 | 2002 Dodge Neon

2 Answers

Does my 2004 dodge neon have an IAT sensor? Or a MAP sensor?


Thanks for choosing FixYa and welcome. It should be a MAP sensor.

May 13, 2011 | Dodge Neon Cars & Trucks

1 Answer

I have a MAF/IAT combo in my 98 plymoth neon 2.0 DOC i need a wire diagram for the wires goin to the sensor


SENSOR GND A BLK/LT BLU
IAT SENSOR SIG B BLK/RED
5 VOLT SUPPLY C VIO/WHT
MAP SENSOR SIG D DK GRN/RED

Aug 03, 2010 | 1998 Plymouth Neon

1 Answer

Wher is the IAT?


the iat sensor is located in the fresh air duct connected to the air filter in front of the fuse/relay control panel. to remove the iat sensor, renive the air filter cover and using a pair of wire cutters remove the small steel band holding the sensor in place. then by pulling on sensor it will come out. when replaceing sensor be sure to install new metal ring on new sensor to secure it in place.

Apr 28, 2010 | 2005 Dodge SRT-4

1 Answer

Could you tell me where I can locate the IAT sensor in an 02 dodge ram 1500 with a 4.7 V8


Here is the location ...

80d410a0.gif 1 - LEFT SIDE OF THROTTLE BODY 2 - ELEC. CONNECT. 3 - IAT SENSOR 4 - RELEASE TAB

Jun 11, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

1998 dodge Neon no fire to coil


it sound like you have a bad crank sensor when the sensor gets hot it open circuits inside the sensor and you loose spark if you have access to a noid light see if you are loosing injector pulse also if so then you know its a good chance its the crank sensor

May 29, 2009 | 1998 Dodge Neon

1 Answer

1998 dodge neon


haines manual. more than likely a crank sensor or cam sensor.

Aug 22, 2008 | 1998 Dodge Neon

Not finding what you are looking for?

Open Questions:

0 Answers

I am having trouble with my speedometer not working occasionally and now my seat belt light is coming on sometimes too. Is this the instrument panel cluster? Or something else? 1998 Dodge Neon. Backstory is as follows: -We take very good care of it and have one dedicated mechanic. -It has only had two owners; my parents and I. -We replaced the battery 2 months ago. -Mechanic checked to make sure the speedometer sensor was working. -We have had issues with the radio for years where it will randomly turn on and off, typically brought on by a stuffed trunk OR wet weather. -The speedometer works until we hit a bump and then the needle flies up and down or sometimes just stops working all together. -Mechanic has made mention of there being some Chrysler specific battery cable that is a smaller side cable and it is not in good condition. -Currently, my problem is that I can't find an old 1998 Dodge Neon in the salvage yard because yards are doing a lot of 2002 and newer vehicles and automatically crushing the others. The meat and potatoes of my question is what direction do I go in? And what of these symptoms ties to each other? And will adding new solder to the points on the panel fix it or is it something else? I'm trying to find least expensive to most expensive options and I'm rather handy but can't drop an engine or transmission or anything so keep this in mind. My handiness ends at resoldering the pins BUT I do have a mechanic I trust, but I fear that maybe I'm not combining symptoms properly. I have the money to repair an item I KNOW is wrong but not to chicken hunt around for problems.

Mar 22, 2017 | 1998 Dodge Neon

See all 1998 Dodge Neon Questions

1998 Dodge Neon Logo

Related Topics:

556 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...