Question about 2002 Chevrolet TrailBlazer

1 Answer

Where is my my valt overide button for my remote car starter so I can reset it

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 344 Answers

It is usually installed under the drivers side dash, maybe near the kick panel or it may even be behind the fuse box cover, good luck

Posted on Feb 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What do I do to get the remote starter to work


look for a red reset button on the remove control computer in the car

Dec 14, 2014 | 2007 Buick Terraza

2 Answers

My anti theft went off after eating a meal at mcdonald. cannot stop it cant start car. took battery off for 3 days same thing happening went to start it it doesnt do anything no click no turn over theft...


Normally, putting the key in the drivers side door lock,
turning to the left, then to the right all the way
will unlock and disarm/reset the "OEM factory"
alarm system.

However, if your system is after market:

The Parking Lights Would Flash, A siren Is Going Off,
An LED Is Flashing As Well, and You May Have A Shock/Impact
sensor set Too High Too. Try The Following Procedure
To Disarm/Disable It.

To start with, you can identify which after market
system you have by using the FCC. ID.# found
on the back of each remote. Try a site
like WWW.REMOTES4SALE.COM
to track down the one you have in your hand.

Now let's put the system into overide mode.

As far as the valet/overide button, it's a hidden
device-switch, a little spring loaded micro button,
red or black possibly and is probably down under
the dash area, near your knee/leg. In some
remote start/alarm combos, the antenna on the window
glass will also have an override/valet button.
Older sytems will have a flip type toggle switch.

When you locate the button or switch,
turn on the ignition key, press and hold
in the button until the alarm chirps 1 time
(for toggle types, key on, flip switch in the
opposite direction, then key off)

This should over ride the system, and only the
keyless entry part, if installed, would still be
operating.

You would get a single chirp to confirm from the siren.
The LED (light emiting diode) light in the dash
should also go on solid. This is valet/overide/reset.
This should correct any issues like starter disable,
or anti-hijack. Your keyless entry, if installed,
will still be operable. The have it inspected for the
falsing issues you are experience at a local shop.

You would repeat the same steps to toggle
back into user mode.

Jul 08, 2011 | Ford Explorer Cars & Trucks

1 Answer

The alarm (that I didn't know I had) on my 1997 Toyota Corolla went off when I tried to jump start it, and now I can't start my car at all. There is a brand new battery in there now, and the alarm keeps...


Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

Jan 06, 2011 | Toyota Corolla Cars & Trucks

1 Answer

My battery went dead and i replaced it and when i re-installed it the alarm went off and it wont start now


Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.
the valet switch is by driver side kick panel look for small button may be stuck in wire harness to hide

Jan 06, 2011 | Toyota Camry Cars & Trucks

1 Answer

Engine wont run due to immobiliser coming on and key wont overide


NO REMOTE,NO RESET.unlock door/hold over key,windows go down,then lock car hold over key.windows go up,then press remote unlock for 30 secs,reset done.

Oct 26, 2010 | 1997 Audi A4

1 Answer

Starter vallet reset


I think I know what you are talking about. I am unsure what alarm you are using but on mine I have a two button remote and if I push button one briefly than button two briefly then one again it will either enter or exit the silent mode.

Good luck !!!!


Aug 04, 2009 | 1995 Nissan 300ZX

1 Answer

I have a 1999 Dodge durango and the alarm is stuck in activate mode, the hand held remote won't shut it off, I can't start my car. Help! I have unhooked the battery....I have looked for a reset...


TRY LOCKING ALL DOORS,THEN UNLOCK PASSENGER SIDE FRONT DOOR WITH KEY..THIS SHOULD DISARM SYSTEM..IF NOT,REMOVE TRIM PLATES AT LF DOOR AND LOOK FOR ANY BROKEN WIRES UNDER TRIM AND CARPET..I HOPE THIS HELPS

Aug 01, 2009 | 1999 Dodge Durango

1 Answer

I want to turn off factory installed alarm in 1999 Ford Taurus SHO but where is the switch located?


Hi there. As far as the valet/overide button, it's a hidden
device-switch, a little spring loaded micro button,
red or black possibly and is probably down under
the dash area, near your knee/leg. In some
remote start/alarm combos, the antenna on the window
glass will also have an override/valet button.
Older sytems will have a flip type toggle switch.

When you locate the button or switch,
turn on the ignition key, press and hold
in the button until the alarm chirps 1 time
(for toggle types, key on, flip switch in the
opposite direction, then key off). This should over ride the system. You would get a single chirp to confirm from the siren.
The LED (light emiting diode) light in the dash
should also go on solid. This is valet/overide/reset.
This should correct any issues like starter disable,
or anti-hijack. Your keyless entry, if installed,
will still be operable. The have it inspected for the
falsing issues you are experience at a local shop.
You would repeat the same steps to toggle back into user mode.

Sep 01, 2008 | Ford Taurus Cars & Trucks

Not finding what you are looking for?
2002 Chevrolet TrailBlazer Logo

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...