Question about 2005 GMC Canyon

Open Question

Lcoate vacuum lines on 2005 gmc canyon - 2005 GMC Canyon

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 375 Answers

SOURCE: ignition coil - 2005 gmc canyon

Just above each spark plug.

Posted on May 18, 2008

Ad
klemm
  • 12 Answers

SOURCE: 2006 gmc canyon 3.5 inline 5 cyl.

Not much of a vacuum diagram on this vehicle. Uses vacuum mainly for the EVAP system ( not a good source). Best bet would be to use a source that stems directly from the intake manifold. Good luck

Posted on Jul 07, 2008

  • 3 Answers

SOURCE: i need to know where my spark plugs are on my 2005 GMC canyon tru

under black breather cap om top of motor there is one bolt per plug take bolt out slid long black sleve out plug is in head you will need a 6 inch extension to get them out

Posted on Jun 21, 2009

twiztid_is_c
  • 3 Answers

SOURCE: I have a 2005 gmc canyon. Occassionally it will

it's probably the transmission and u might have to change ur fuel pump also

Posted on Jul 29, 2009

  • 1596 Answers

SOURCE: how do i change the o2 sensor on a 2005 gmc canyon

It is a 7/8 ths Sized Wrench needed for it and you Simplt Unplug it and remove it and replace it. If you see a Problem with this Method , there IS a SPECIAL SOCKET for 02 Sensors and Same Procedure just with A Socket / Extention / Ratchet.

Posted on Nov 09, 2009

Testimonial: "Thanks "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My reverse stop working in my gmc canyon


Put a code reader on it should tell you a code for powertrain

Nov 29, 2016 | 2005 GMC Canyon

1 Answer

Front brakes on 2005 GMC canyon are locked up what could it be


hello,
If the frt brakes are locked up then it could be any of the following, master cylinder is bad, frt brake lines are at fault the flexible rubber part that goes to the calipers, or the calipers themselves could be frozen and are not able to release when you let off the brake pedal.

Mar 14, 2015 | 2005 GMC Canyon

1 Answer

How to change a fuel rail on a 2005 canyon in line 5


In a nutshell... Take the intake manifold off and then you can access the fuel rail for removal.

Aug 30, 2012 | 2005 GMC Canyon

1 Answer

Where is the inside fuse box for my 2005 canyon 4door


All fuses and circuit breakers for a 2005 GMC Canyon are located in the engine compartment fuse block.

This subject is covered in the 2005 GMC Canyon Owner's Manual on pages 5-98 through 5-102.

If you do not have an Owner's Manual, you can download a free PDF version clicking on the following direct link:

2005 GMC Canyon Owner's Manual

Jan 04, 2012 | Cars & Trucks

1 Answer

2005 GMC Canyon windows won't roll back up on driver and passenger side.


2005 gmc canyon.driver side window and lock does not work.have relpaced switch. the new switch now giving the same problem.

Jan 18, 2011 | 2005 GMC Canyon

1 Answer

2008 Colorado cruise control quit working? What can I check?


Check for fuse and relay..
Also check all vacuum lines related to throttle body and/or intake..

Rate well ;o)

Jul 25, 2009 | 2005 GMC Canyon

1 Answer

2005 GMC Canyon 4x4 clicking noise in rear end when in drive. Starts at about 20mph. At first, noticed a squeeking noise when in reverse. that went away.


Stones in tire treads? Pull the rear wheels for a look-see. Inspect brakes and all hardware. Have then lubed. Make sure linings or pads are not glazed to eliminate squeaking noise.Make sure parking brake works properly and smoothly. It may beone or more of those things. Good luck there, pardner.

Jun 10, 2009 | 2005 GMC Canyon

1 Answer

2006 gmc canyon 3.5 inline 5 cyl.


Not much of a vacuum diagram on this vehicle. Uses vacuum mainly for the EVAP system ( not a good source). Best bet would be to use a source that stems directly from the intake manifold. Good luck

Jul 07, 2008 | 2006 GMC Canyon

1 Answer

Ignition coil - 2005 gmc canyon


Just above each spark plug.

May 18, 2008 | 2004 GMC Canyon

Not finding what you are looking for?
2005 GMC Canyon Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...