Question about 2004 Chevrolet Silverado 2500HD

1 Answer

How do I replace a washer pump on a 2004 silverado 2500HD

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has written 2 tips or uploaded 1 video tip.

  • Expert
  • 75 Answers

Remove the air cleaner, then remove the washer container. Then unhook the washer tubes. Next remove the pump by carefully pulling the pump from the retainer on the container. Then remove the pump from the sealing grommet. Put the sealing grommet on the new pump then push it back into the retainer on the container. Hook back up your hoses then proceed to put the washer container back in and the same with the air cleaner.

Posted on Feb 04, 2010


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 3600 Answers

SOURCE: 2004 Chevy Silverado 2500HD 6.0L- loosing coolant

intake manifold boltsare loose goto to confirm soulution.

Posted on Jun 24, 2009

  • 18 Answers

SOURCE: I have 2004 Chevrolet 2500hd diesel - where is the fuel pump

Check on the frame rail.

Posted on Jul 27, 2009

  • 636 Answers

SOURCE: 2004 Silverado 2500HD. Airbag/Steering wheel control issue

Try unhooking the positive post on the battery this should reset the system. As far as the radio controls and airbag, this shouldn't be related the changing parts. Try checking the fuse panel for burnt out fuses.

Posted on Aug 11, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Fuse blows when attempting to use washer fluid

I would be looking for where the power wire to the pump could touch the earth wire or any earth point near the washer pump check the actual connection on the pump for the terminals touching .

May 25, 2013 | 2002 Chevrolet Silverado 2500HD

1 Answer

Water punp is linking

if the pump is leaking from around the gasket then gasket needs replaced but if the leak is coming from the bottomout of a weep hole then the barring is bad and water pump needs replaced this is a very comm in chev water pumps

Feb 07, 2011 | 2004 Chevrolet Silverado 2500HD

2 Answers

Chevrolet 2004 Silverado 2500HD 6.6 wont start

try priming the fuel filter, ther is a pump and bleed scew above the filter, pump a few times hold the pump down open screw and se what comes out air or diesel? keep doing this until its diesel

Mar 04, 2010 | 2004 Chevrolet Silverado 2500HD

1 Answer

I have a 04 silverado HD and while driving i loose throttle

replace your fuel filter best way to diagnose this one to start, find a way to monitor your fuel pressure if the filter had no effect, do you have any codes *** up ? and if so what are they, let me know, if not you might have a defective fuel pump, the pressure reading will tell, over 40 psi is good.

Jan 28, 2010 | 2004 Chevrolet Silverado 2500HD

2 Answers

2004 Chevy Silverado 2500HD 6.0L- loosing coolant

intake manifold boltsare loose goto to confirm soulution.

Jun 24, 2009 | 1997 Chevrolet C2500

1 Answer

Alternator needs to be replaced

There is a spring tensioner on it.Pull back to loosen belt.The same to refit belt

May 30, 2009 | 2004 Chevrolet Silverado 2500HD

1 Answer

Just wanted to see if anyone could give me a complete list of supplies needed to tune up a 2004 chevy silverado 2500HD 8c 6L

that depends on the miles on the truck. spark plugs every 100,000 miles, other ignition parts inspect and replace as ness, fuel and air filter every 30,000 miles. all belts and hoses should be inspected as part of any service.

Apr 30, 2009 | 2004 Chevrolet Silverado 2500HD

1 Answer

Have a 2007 chevy silverado and the windshield wipers lite won't change. I feel the reserved tank up. still displays washer is low. How do i fix?

Disconnect the wiring harness at the pump reservoir and check for faulty wiring, if not, then suspect faulty sensor/pump switch.

Jan 02, 2009 | 2007 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides