Question about 2002 Dodge Intrepid

1 Answer

Starter replacement 2002dodgeintrepid needs new starter wher is it located and is it difficult to replace?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 204 Answers

Its on the trans, i dont remember which side, not hard to get off/on, but requires time and a lot of patience.
- try not to throw your tools :) -

Posted on Feb 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New starter, good battery and the car stiil wont turn over


get alternator tested-probly need new-chec wiring 1st wher it goes to batt--cud be worn

Mar 26, 2013 | Cars & Trucks

1 Answer

Code indicate mafm sensor is faulty and the EGR value need replaced. wher are these parts located on the engine and how much are they to purchase and replace?


No code says a particular part is bad, the code indicates a problem in the circuit, not the just the sensor, this means the problem can be the sensor, the wiring to the sensor or actuator or the computer control module.

Sep 06, 2012 | Cars & Trucks

1 Answer

Wher is the locatio of the crankshaft position sensor and how difficult is it to replace?


It is located under the front timing belt cover. It is failry difficult to replace.

Apr 26, 2011 | 2003 Hyundai Santa Fe

1 Answer

Wher is the blower moter located at to a 2002 cadillac deville how do i replace the heater blower motor


The blower motor is located under the glove box. It is a very difficult procedure to replace. The blower motor has six 7/32 size screws, two of which are hidden and one, the closest to the firewall, will require a 1/4" drive, and swivel. I removed the glove box in order to put the replacement blower motor in. It takes a little extra time but allows more room and saves your back. Get a diagram off the internet of how to remove these things. Plug in the new blower motor and test it before you just install it! My biggest fear installing the new blower motor was that it took a lot of force to get it back in on an angle. Almost thought that I was going to crack or damage the fins on the cage. It takes force but just be careful.

Jan 06, 2011 | 2002 Cadillac Deville

1 Answer

Where is the starter solenoid located in a 94 ford taurus?


the starter soleniod is on the starter, if you look under the front of the car at the motor wher it meets the trany you will see the starter, its best to replace the complete unit, this is not like older fords where there was a soleniod up on the wall and starter on the motor, this is all on one unit, heres a diagram pictur to help you , hope the info helps , good luck.johnjohn2_16.jpg

Nov 08, 2010 | 1994 Ford Taurus

1 Answer

Replacing a starter


Replacing the starter on a 96 Avalon is incredibly simple. I did it in the parking lot of a store. Just bring your ratchet set and you will be good to go. I took out the old starter, had a friend bring me to autozone and I bought a new one. Its easy to locate, easy to remove and easy to install.

Jul 12, 2010 | 1996 Toyota Avalon

1 Answer

Need to replace the starter..where is it located


It is on the passenger side, under the truck, mounted to the transmission. It's not too bad to replace, except for the top bolt for the starter, it's a bit difficult to get to.

Jun 05, 2010 | 1997 Ford Expedition

1 Answer

How difficult is it to replace a 2004 Dodge Durango Starter?


this should not be difficult. Look under the vehicle near the transmission. on the bettom of the engine block will be sticking out the starter. 2 bolts and it will slide out. Replace with the new starter. You may need to jac up the vehicle or use car ramps to have enough room under the vehicle

Jan 29, 2010 | 2004 Dodge Durango

3 Answers

Where is the starter located in a 1995 lebaron


starter is located on the drivers side near the radiator. the connections are a little difficult but the starter bolts are easy to get to and the starter is easy to replace. I replaced one in a parking garage. Took about 30 minutes

Dec 30, 2009 | 1995 Chrysler LeBaron

4 Answers

I need to pull and reinstall starter on '93 audi cs90


starters seem difficult, but can be accomplish relatively quickly. there friendly because you don't have to worry about belts and gaskets. My assumption here is that you know you need to replace the starter and you know where the starter is located.
first disconnect negative battery cable.
On the starter you will need to disconnect power and ground. then you can pull the bolts and remove the bad starter. Installation is reverse of course. Once installed and secure, always double check the gound connection. reconnect battery and off ya go. Time should 45ish minutes.

May 05, 2009 | 1993 Audi 90

Not finding what you are looking for?
2002 Dodge Intrepid Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...