Question about 2002 Chrysler Town & Country

1 Answer

Trans goes in drive for a minute then slips out reverse out if you shut off and restart drive works again then slips out low gear runs fine just cant go over 30

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 279 Answers

You may wanna try replacing the soleniod pack mounted on the front of the transmission.U may have to purchase it at a local dealer or napa.If that does not repair your issue you may have to install a used transmission.

Posted on Feb 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 toyota camry wont go into gear or slips out


Could be a long list of things.
Its too late for a filter change. Doing that now would probably make matters worse.
The trans uses electric solenoids and a pump to apply pressure to the clutches. So either could be faulty given the age and mileage.
I'm not sure if the shifting problem is connected to the shift indicator lights problem.
You may need to take it to a trans shop to find out for sure. And they will not want to touch it with that many miles on it.
A regular mechanic might be able to do a pressure test on it to at least find out if it is the pump or not.

Dec 04, 2012 | 1990 Toyota Camry

1 Answer

Eclipse goes into reverse but wont go in drive.


Friend, start the engine and let it run a few minutes to warm the trans fluid, set the park brake or block the front of the wheels, put the car in drive position and check the transmission fluid. Sounds like it's just too low for the pump to pick up enough for a forward engagement. Reverse doesn't take much to activate the servo. Most automatics are this way. I'm sure you'll find the fluid is way low and needs the proper fluid added. This may mean you have a slight trans fluid leak.

Apr 04, 2017 | Mitsubishi Eclipse Cars & Trucks

2 Answers

I have a playmouth grand voyager 1999 3L,my transmission will not shift up in gear.On drive or reverse it goes well but will not shift.I think it could be an electrique problem,cause the transmission looks...


Your trans is stuck in safe mode, you are only using 2nd gear, this means it is not shifting but staying at a gear so you will not damage the trans. This is an electrical setting , however usually comes from the computer receiving bad information , rough shift, however it can be reset. Remove the positive battery cable for 30 minutes then see if it shifts, also check your fluid level, it can go into safe mode from low fluid if you made a turn and the trans slipped from low fluid . If your trans goes back into safe mode again have it checked, most important, do not drive over 45 mph or allow your rpms to raise over 3 , I have seen many motor problems that spawned from this type of trans problem, if not corrected.

Good Luck

Aug 16, 2009 | 1999 Plymouth Grand Voyager

1 Answer

After driving for 15 minutes truck stalls,restarts no problem ,but trans races and stalls again. if it sits idle for 2-3 days runs again no problem ,until the 15 minute drive again .the 15 minute drive...


put a OBD II code reader on it see if it has stored any codes if not replace the TPS sensor and the MAF sensor do the replacements at different times so you don't buy one or the other for nothing

Jul 03, 2009 | 1993 Ford Ranger SuperCab

2 Answers

Gmc 4x4 wont go into drive


When it does this, Reverse works fine? How about low 2?

Apr 24, 2009 | 1999 GMC Jimmy

1 Answer

Goes in reverse but dont move. in drive only goes 10mrh.


I think you need to bring that thing to a transmission shop. it is a bit surprising that a 5 y'old car would have a bad trans but maybe a transmission shop can save it. GL

Feb 01, 2009 | 2003 Dodge Stratus

1 Answer

Losing all gears intermitently


sounds like a case for the transmission shop. The slipping may be due to low hydrolic pressure- did it take long for the gear to engage when u put it in gear after letting it cool? Im interested in more info on when the problem occurs, but from what it sounds like u need a rebuild done on that trans unless u misread the dipstick when u checked the fliud. make sure the truck is running and has been driven to warm up the trans for an accurate reading b4 checking the fluid level. You can also warm up the trans by letting it sit in drive with the parking brake set for a few minutes.

Jan 19, 2009 | 2001 Chevrolet S-10

1 Answer

Lost all gears while driving this morning


Definately has too be the Problem. There are Marks on there, They may be really Faint though. Get some fluid in there if it is low and hope that it will not need to be Rebuild.

Jan 18, 2009 | 2001 Chevrolet S-10

Not finding what you are looking for?
2002 Chrysler Town & Country Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...